Wireless Mesh Network Security, Architecture, and Protocols

Author(s):  
Sachin Kumar Gupta ◽  
Aabid Rashid Wani ◽  
Santosh Kumar ◽  
Ashutosh Srivastava ◽  
Diwankshi Sharma

Due to suppression of central administration in WMN, network functioning like network controls, management, routing, switching, packet forwarding etc. are distributed among nodes, either collectively or individually. So, cooperation among nodes is highly solicited. However, there may exist node's malicious activities because of its open characteristics and limited available battery power. The nodes may misbehave by refusing to provide service or dropping down the packets because of its selfishness and malicious activity. The identification of misbehaving nodes and prevention from them can be one of the biggest challenges. Hence, the prime target of the chapter is to provide an overview of existing intrusion detection and prevention approaches, and secure routing or framework that can recognize and prevent from the malicious activities. The digital signature-based IDS to offer secure acknowledgment and an authentication mechanism has also been discussed. The expectation is the digital signature-based IDS will overcome the weakness of existing IDS.

2016 ◽  
Vol 2016 ◽  
pp. 1-11 ◽  
Author(s):  
Rakesh Matam ◽  
Somanath Tripathy

Multicast is an indispensable communication technique in wireless mesh network (WMN). Many applications in WMN including multicast TV, audio and video conferencing, and multiplayer social gaming use multicast transmission. On the other hand, security in multicast transmissions is crucial, without which the network services are significantly disrupted. Existing secure routing protocols that address different active attacks are still vulnerable due to subtle nature of flaws in protocol design. Moreover, existing secure routing protocols assume that adversarial nodes cannot share an out-of-band communication channel which rules out the possibility of wormhole attack. In this paper, we propose SEMRAW (SEcure Multicast Routing Algorithm for Wireless mesh network) that is resistant against all known active threats including wormhole attack. SEMRAW employs digital signatures to prevent a malicious node from gaining illegitimate access to the message contents. Security of SEMRAW is evaluated using the simulation paradigm approach.


Author(s):  
A. Rethina Palin ◽  
I. Jeena Jacob

Wireless Mesh Network (MWN) could be divided into proactive routing, reactive routing and hybrid routing, which must satisfy the requirements related to scalability, reliability, flexibility, throughput, load balancing, congestion control and efficiency. DMN (Directional Mesh Network) become more adaptive to the local environments and robust to spectrum changes. The existing computing units in the mesh network systems are Fog nodes, the DMN architecture is more economic and efficient since it doesn’t require architecture- level changes from existing systems. The cluster head (CH) manages a group of nodes such that the network has the hierarchical structure for the channel access, routing and bandwidth allocation. The feature extraction and situational awareness is conducted, each Fog node sends the information regarding the current situation to the cluster head in the contextual format. A Markov logic network (MLN) based reasoning engine is utilized for the final routing table updating regarding the system uncertainty and complexity.


2012 ◽  
Vol 3 (3) ◽  
pp. 368-374
Author(s):  
Usha Kumari ◽  
Udai Shankar

IEEE 802.16 based wireless mesh networks (WMNs) are a promising broadband access solution to support flexibility, cost effectiveness and fast deployment of the fourth generation infrastructure based wireless networks. Reducing the time for channel establishment is critical for low latency/interactive Applications. According to IEEE 802.16 MAC protocol, there are three scheduling algorithms for assigning TDMA slots to each network node: centralized and distributed the distributed is further divided into two operational modes coordinated distributed and uncoordinated distributed. In coordinated distributed scheduling algorithm, network nodes have to transmit scheduling message in order to inform other nodes about their transfer schedule. In this paper a new approach is proposed to improve coordinated distributed scheduling efficiency in IEEE 802.16 mesh mode, with respect to three parameter Throughput, Average end to end delay and Normalized Overhead. For evaluating the proposed networks efficiency, several extensive simulations are performed in various network configurations and the most important system parameters which affect the network performance are analyzed


Electronics ◽  
2021 ◽  
Vol 10 (11) ◽  
pp. 1244
Author(s):  
Hana Rhim ◽  
Damien Sauveron ◽  
Ryma Abassi ◽  
Karim Tamine ◽  
Sihem Guemara

Wireless sensor networks (WSNs) have been widely used for applications in numerous fields. One of the main challenges is the limited energy resources when designing secure routing in such networks. Hierarchical organization of nodes in the network can make efficient use of their resources. In this case, a subset of nodes, the cluster heads (CHs), is entrusted with transmitting messages from cluster nodes to the base station (BS). However, the existence of selfish or pollution attacker nodes in the network causes data transmission failure and damages the network availability and integrity. Mainly, when critical nodes like CH nodes misbehave by refusing to forward data to the BS, by modifying data in transit or by injecting polluted data, the whole network becomes defective. This paper presents a secure protocol against selfish and pollution attacker misbehavior in clustered WSNs, known as (SSP). It aims to thwart both selfish and pollution attacker misbehaviors, the former being a form of a Denial of Service (DoS) attack. In addition, it maintains a level of confidentiality against eavesdroppers. Based on a random linear network coding (NC) technique, the protocol uses pre-loaded matrices within sensor nodes to conceive a larger number of new packets from a set of initial data packets, thus creating data redundancy. Then, it transmits them through separate paths to the BS. Furthermore, it detects misbehaving nodes among CHs and executes a punishment mechanism using a control counter. The security analysis and simulation results demonstrate that the proposed solution is not only capable of preventing and detecting DoS attacks as well as pollution attacks, but can also maintain scalable and stable routing for large networks. The protocol means 100% of messages are successfully recovered and received at the BS when the percentage of lost packets is around 20%. Moreover, when the number of misbehaving nodes executing pollution attacks reaches a certain threshold, SSP scores a reception rate of correctly reconstructed messages equal to 100%. If the SSP protocol is not applied, the rate of reception of correctly reconstructed messages is reduced by 90% at the same case.


Sign in / Sign up

Export Citation Format

Share Document