Effect of Temperature on Optical and Photovoltaic Properties of nc-TiO2 Thin Films for Dye Sensitized Solar Cell

2015 ◽  
Vol 1110 ◽  
pp. 207-210
Author(s):  
M.T. Sarode ◽  
Y.B. Khollam ◽  
S.R. Jadkar ◽  
B.B. Kale ◽  
K.C. Mohite

In this investigation, anatase nanocrystalline TiO2 (nc-TiO2) films are deposited by using sol-gel dip coating method on ITO substrates followed by annealing at 200, 300, 400 and 500 °C / 2 hr in air. To examine the structure and morphology of films, XRD, Raman spectroscopy, SEM and HRTEM techniques are used. The XRD studies showed the evolution of pure anatase TiO2 phase with average crystallite size = 12-15 nm in resultant films. The morphological studies using SEM and HRTEM indicated ~ uniform size distribution of spherical agglomerates in films and nanocrystalline state of films (average particle size ~ 20 nm) respectively. The optical properties calculated from UV-Visible transmission spectra are found to be indirect band gap energy = 3.20 eV, absorbance coefficient = 9.2 x 104 cm-1, transmittance = 88.5 %, refractive index = 2.12 and porosity ratio = 36.6 % for the 400 °C annealed film. The better photovoltaic performance: JSC = 2.34 mA/cm2, VOC = 0.562V, FF = 35.23 % & η = 0.46 % is obtained for eosin-Y dye sensitized solar cell made with 400 °C annealed film.

2020 ◽  
Vol 19 (06) ◽  
pp. 2050009
Author(s):  
Swati S. Kulkarni ◽  
Gajanan A. Bodkhe ◽  
Pasha W. Sayyad ◽  
Megha A. Deshmukh ◽  
S. S. Hussaini ◽  
...  

Well crystallized Aluminium (Al) doped Titanium dioxide (TiO2) nanoparticles with various doping concentration (0, 0.05[Formula: see text]M, 0.07[Formula: see text]M, 0.09[Formula: see text]M and 0.11[Formula: see text]M) were synthesized successfully by sol–gel route to develop the photo anode of Dye Sensitized Solar Cell (DSSC). Anatase crystalline nature of TiO2 nanoparticles was confirmed using X-ray diffraction (XRD) and Raman spectrophotometer. The Atomic Force Microscopy (AFM) was used to investigate the morphology of the photo anode (Al-doped TiO2 nanoparticles). The photovoltaic performance of the DSSC in terms of Current, Voltage and efficiency was investigated with a standard illumination of AM1.5G having an irradiance 100[Formula: see text]mW/cm2. Optimized values of Short Circuit Current density ([Formula: see text]), Open Circuit Voltage ([Formula: see text]) and efficiency ([Formula: see text]) obtained was 247.62[Formula: see text][Formula: see text]A/cm2, 359[Formula: see text]mV and 0.02456%, respectively for 0.07[Formula: see text]M Al doping concentration. Eco-friendly Eosin Y dye was used for sensitization of the photo anode. The optimized photovoltaic cell exhibits very good efficiency (80.05% more than the earlier reported work).


2019 ◽  
Vol 26 (03) ◽  
pp. 1850164 ◽  
Author(s):  
SWATI S. KULKARNI ◽  
S. S. HUSSAINI ◽  
GAJANAN A. BODKHE ◽  
MAHENDRA D. SHIRSAT

Titanium dioxide (TiO[Formula: see text] nanoparticles have been synthesized by the cost effective Sol–Gel technique. Characteristics of TiO2 nanoparticles were investigated by X-ray diffraction and Fourier Transform Infrared spectroscopy. The Eosin Y dye and dye extracted from Hibiscus tea have been successfully used in fabrication of the dye sensitized solar cell. The photovoltaic performance of the dye sensitized solar cell indicates that the short circuit photo current, open circuit voltage and efficiency of the DSSC using Eosin Y dye is 10 times more compared to the DSSC using the Hibiscus dye.


2013 ◽  
Vol 134 ◽  
pp. 59-62 ◽  
Author(s):  
Qingbei Li ◽  
Jianming Lin ◽  
Jihuai Wu ◽  
Zhang Lan ◽  
Yue Wang ◽  
...  

2021 ◽  
Vol 68 (10) ◽  
pp. 4982-4988
Author(s):  
Yu-Hsun Nien ◽  
Zhen-Rong Yong ◽  
Jung-Chuan Chou ◽  
Chih-Hsien Lai ◽  
Po-Yu Kuo ◽  
...  

RSC Advances ◽  
2015 ◽  
Vol 5 (124) ◽  
pp. 102803-102810 ◽  
Author(s):  
Chang-Yun Cai ◽  
Sheng-Kai Tseng ◽  
Meng Kuo ◽  
Kun-Yi Andrew Lin ◽  
Hongta Yang ◽  
...  

Photovoltaic performance of dye-sensitized solar cell with transparent macroporous anti-ultraviolet photonic crystal coatings.


2018 ◽  
Vol 273 ◽  
pp. 146-153 ◽  
Author(s):  
Nurnaeimah Jamalullail ◽  
Ili Salwani Mohamad ◽  
Mohd Natashah Norizan ◽  
Norsuria Mahmed

Dye sensitized solar cell (DSSC) is a well-known photovoltaic device that is used for low power application. One of the main components for DSSC is semiconductor material photoanode which will provide the pathway for electron transportation and thus determine the energy conversion efficiency of the DSSC. The most commonly used material for the semiconductor photoanode is titanium dioxide (TiO2).TiO2is a semiconductor material with wide bandgap material that is existed in three crystalline phase; rutile, anatase and brookite. This paper emphasizes the best annealing temperature for commercialized TiO2, 98% anatase powder where the temperature varies from 300 oC – 600 oC. Through this research, the best annealing temperature for anatase TiO2photoanode is at 420 °C (0.094%) with the crystallite size of 18.76 nm and particle size of 19 nm that is favorable for the dye attached and thus enhances the energy conversion efficiency of the DSSC.


Sign in / Sign up

Export Citation Format

Share Document