Time-History Dynamic Behaviour of Reinforced Concrete Buildings Strengthened using Steel Shear Walls

Author(s):  
A.C. Masri
2013 ◽  
Vol 40 (8) ◽  
pp. 693-710 ◽  
Author(s):  
Murat Saatcioglu ◽  
Dan Palermo ◽  
Ahmed Ghobarah ◽  
Denis Mitchell ◽  
Rob Simpson ◽  
...  

The paper presents observed damage in reinforced concrete buildings during the 27 February 2010 Maule earthquake in Chile. Performance of concrete frame and shear wall buildings are discussed with emphasis on seismic deficiencies in design and construction practices. It is shown that the majority of structural damage in multistorey and high-rise buildings can be attributed to poor performance of slender shear walls, without confined boundary elements, suffering from crushing of concrete and buckling of vertical wall reinforcement. Use of irregular buildings, lack of seismic detailing, and the interference of nonstructural elements were commonly observed seismic deficiencies. A comparison is made between Chilean and Canadian design practices with references made to the applicable code clauses. Lessons are drawn from the observed structural performance.


2004 ◽  
Vol 20 (1_suppl) ◽  
pp. 221-255 ◽  
Author(s):  
Luis D. Decanini ◽  
Adriano De Sortis ◽  
Agostino Goretti ◽  
Laura Liberatore ◽  
Fabrizio Mollaioli ◽  
...  

About 10% of the almost 20,000 buildings damaged by the 2002 Molise, Italy, seismic sequence were reinforced concrete (RC). The most frequent type of damage affected the infill masonry walls, but in some cases cracks in concrete columns were observed. Heavy damage to both infills and structural elements was restricted to a few cases in the meizoseismal area. Almost all the affected municipalities were only classified as seismic in May 2003, following this earthquake. Consequently, construction generally used vertical-load-bearing moment-resisting frames with no explicit design for seismic lateral forces. In particular, the reinforced concrete buildings typically consist of cast-in-place unidirectional RC slabs lightened with hollow clay tiles, supported by RC beams and columns. Usually no shear walls are present, except in some cases for the elevator shaft. This paper covers: a) an overview and statistical analysis of damage to RC buildings, and b) a detailed analysis of two damaged buildings.


Sign in / Sign up

Export Citation Format

Share Document