scholarly journals Analysis of Factors Affecting Thermodynamic Efficiency in Generation III+ PWR Nuclear Power Plants.

2017 ◽  
Vol 4 ◽  
pp. 141-154
Author(s):  
Marcus Vitlin ◽  
Miroshan Naicker ◽  
Augustine Frederick Gardner

Generation III+ reactors are the latest generation of Nuclear Power Plants to enter the market. The key evolution in these reactors is the introduction of stringent safety standards. This is done through thorough incident scenario analysis and preparation, resulting in the addition of novel active and passive auxiliary safety systems, affecting the power consumption in the balance of plant. This paper analyses the parameters of PWR power plants of similar design, to determine the parameters for optimal efficiency, regarding gross and net electrical output, determining the impact the balance of plant has on this efficiency. While two of the three main factors affecting the Rankine cycle – boiler pressure and steam temperature – behaved as theoretically expected, there was a notable point of departure with the third parameter – condenser pressure. The relationship between steam temperature and gross electrical efficiency was linear across all reactors but the relation between the steam temperature and the net electrical efficiency ceased to be linear for secondary loop steam temperatures above 290°C. The relationship between boiler pressure and both gross and net electrical efficiency was linear, proving the Rankine cycle. A relationship was not observed between the condenser pressure and either the gross or net electrical efficiency

Work ◽  
2012 ◽  
Vol 41 ◽  
pp. 714-721 ◽  
Author(s):  
Yong Zhou ◽  
HaiYing Mu ◽  
Jianjun Jiang ◽  
Li Zhang

2021 ◽  
Vol 2083 (2) ◽  
pp. 022020
Author(s):  
Jiahuan Yu ◽  
Xiaofeng Zhang

Abstract With the development of the nuclear energy industry and the increasing demand for environmental protection, the impact of nuclear power plant radiation on the environment has gradually entered the public view. This article combs the nuclear power plant radiation environmental management systems of several countries, takes the domestic and foreign management of radioactive effluent discharge from nuclear power plants as a starting point, analyses and compares the laws and standards related to radioactive effluents from nuclear power plants in France, the United States, China, and South Korea. In this paper, the management improvement of radioactive effluent discharge system of Chinese nuclear power plants has been discussed.


2021 ◽  
pp. 309-314
Author(s):  
Irma Martyn ◽  
Yaroslav Petrov ◽  
Sergey Stepanov ◽  
Artem Sidorenko

Author(s):  
Yuchen Hao ◽  
Yue Li ◽  
Jinhua Wang ◽  
Bin Wu ◽  
Haitao Wang

Abstract In nuclear power plants, the amount of spent fuel stored on-site is limited. Therefore, it is necessary to be shipped to off-site storage or disposal facilities regularly. The key risk in the transfer of spent fuel involves a release of radiation that could cause harmful effects to people and the environment. Transfer casks with impact limiters on both ends are always employed to ensure safe containment of radioactive materials, which should be verified by the 9 meters drop test onto an unyielding surface according to IAEA SSR-6. In this paper, we focus on the influence of the impact-limiter parameters, including geometry dimensions and mechanical properties, on the results of drop events to achieve an optimized approach for design. The typical structure of impact limiter is bulk energy-absorbed material wrapped by thin stainless-steel shells. Compared to traditional wood, foam has advantages of isotropy and steady quality. In this paper, theoretical and numerical methods are both adopted to investigate the influence of impact limiters during hypothetical accidental conditions for optimizing buffer influence and protecting the internal fuel components. First of all, a series of polyurethane foam is selected according to the theoretical method, because its mechanical property is related to density. Therefore, using explicit finite element method to investigate the influence of parameters of foam in impact limiter. These discrete points from the above result can be utilized to establish damage curves by date fitting. Finally, a design approach for spent fuel transfer cask is summarized, to provide a convenient formula to predict the damage and optimize structure design in drop condition. Furthermore, this design approach can be applied in the multi-module shared system of SNF, which can contain different fuel assemblies.


Kerntechnik ◽  
2004 ◽  
Vol 69 (3) ◽  
pp. 84-87
Author(s):  
H. R. V. de Oliveira ◽  
A. S. Martinez

Author(s):  
Xinyu Wei ◽  
Hongbin Ma ◽  
Xiaowei Xiong ◽  
Duanjie Yang ◽  
Zhaorong Shang

In China, the radioactive environmental impact assessment (EIA) for nuclear power plants (NPPs) had been carried out in detail due to the specific characteristic of radiation and the social universal attention. However, the nonradioactive environment impact assessment for NPP doesn’t get enough attention. This should be improved, since the operation of NPPs could cause some serious nonradioactive environment impacts. Based on the investigation of EIA for American NPPs, the following suggestions were put forward for Chinese EIA: (1) the laws and regulations in China need to be revised for the EIA of NPPs; (2) the statistics of chemicals or biocides used in the operation of NPPs and their discharged concentration need to be tested; (3) the impact assessments of nonradioactive gas emissions as well as hazardous wastes need to be carried out to meet the national requirements; and (4) the monitoring of nonradioactive waste also needs to be carried out for NPPs to obtain the basic data.


1997 ◽  
Author(s):  
R.E. Davis ◽  
A.L. Hanson ◽  
V. Mubayi ◽  
H.P. Nourbakhsh

Sign in / Sign up

Export Citation Format

Share Document