scholarly journals A Study for the Use of Solar Energy for Agricultural Industry - Solar Drying System Using Evacuated Tubular Solar Collector and Auxiliary Heater -

2013 ◽  
Vol 38 (1) ◽  
pp. 41-47 ◽  
Author(s):  
Gwi Hyun Lee
Keyword(s):  
Solar Energy ◽  
Solar Collector ◽  
Solar Drying ◽  
Agricultural Industry ◽  
Drying System ◽  
Auxiliary Heater

scholarly journals THE EFFECT OF CONVECTIVE FIXED BED DRYING BASED ON A SOLAR COLLECTOR AND PHOTOVOLTAIC (CSD) TO THE QUALITY ATRIBUTES OF RED PEPPER COMPARED WITH CONVENTIONAL CONVECTIVE FIXED BED DRYING (CCD)

2019 ◽  
Vol 7 (1) ◽  
pp. 24-33
Author(s):  
Siti Asmaniyah Mardiyani ◽  
Sumardi Hadi Sumarlan ◽  
Bambang Dwi Argo ◽  
Amin Setyo Leksono
Keyword(s):  
Ascorbic Acid ◽  
Solar Collector ◽  
Fixed Bed ◽  
Quality Attributes ◽  
Red Pepper ◽  
Convective Drying ◽  
Solar Drying ◽  
Rehydration Ratio ◽  
Drying System

The effect of conventional convective drying (CCD) and convective solar drying (CSD) based on a solar collector and photovoltaic on the quality of dried red pepper was researched. The study was aimed to determine the effect of five drying system (CCD 50°C, CCD 60°C, CCD 70°C, CSD, and open sun drying) on the quality attributes of dried red pepper. The quality observed were rehydration ratio, ascorbic acid, capsaicin, non-enzymatic browning index, anthocyanin, and carotenoids. The results of the study confirmed that the drying system significantly affected the quality attributes of dried red pepper except for anthocyanin.  The CSD had a satisfactory result, shown by some attributes  (carotenoids, ascorbic acid, and ratio) which were not statistically different from the quality of dried red pepper gained from CCD 50°C.

scholarly journals An Experimental Study of Vegetable Solar Drying Systems with and without Auxiliary Heat

2012 ◽  
Vol 2012 ◽  
pp. 1-8 ◽  
Author(s):  
Abdul Jabbar N. Khalifa ◽  
Amer M. Al-Dabagh ◽  
W. M. Al-Mehemdi
Keyword(s):  
Experimental Data ◽  
Experimental Study ◽  
Solar Drying ◽  
Drying Time ◽  
Exponential Equations ◽  
Drying System ◽  
Auxiliary Heater ◽  
Best Fit ◽  
Drying Chamber ◽  
Natural Drying

An experimental study is conducted to investigate the performance of a solely solar drying system and a system equipped with an auxiliary heater as a supplement to the solar heat. The performances of both are compared to that of natural drying. Beans and peas are dehydrated in a system that consists of two flat plate collectors, a blower, and a drying chamber. Tests with four different airflow rates, namely, 0.0383, 0.05104, 0.0638, and 0.07655 m3/s are conducted. It was found that the drying time was reduced from 56 hours for natural drying to 12–14 hours for solar drying and to 8-9 hours for mixed (solar and auxiliary) drying. The efficiency of the mixed drying system was found to increase by 25% to 40% compared to the solely solar drying. A best fit to the experimental data of peas and beans was obtained by six exponential equations for the various systems with a correlation coefficient in the range 0.933 and 0.997.

scholarly journals CFD investigation of a combined biomass furnace and solar drying system for paver blocks

2021 ◽  
Vol 1109 (1) ◽  
pp. 012057
Author(s):  
A H Atienza ◽  
L A Adorador ◽  
J A Hernandez ◽  
F J Vinagrera
Keyword(s):  
Solar Drying ◽  
Drying System

Experimental Study of Notoginseng Drying Based on a Solar Air Heating System

2011 ◽  
Vol 71-78 ◽  
pp. 2073-2076
Author(s):  
Fen E Hu ◽  
Zhi Juan Wang
Keyword(s):  
Winter Season ◽  
Heating System ◽  
Solar Drying ◽  
Mass Rate ◽  
Drying Time ◽  
Air Heating ◽  
Solar Air Collector ◽  
Air Blower ◽  
Drying System ◽  
Air Channels

A solar air drying system including solar air collector, drying cabinet and air blower for notoginseng drying has been constructed and tested. Two identical air solar collectors with two air channels, V-groove absorption heat plates and a single glass cover have been employed. The results of test show that the solar air collectors can obtain a good thermal performance in winter season. When the air flow mass rate is fixed at 0.0597kg·s-1, the maximum values of thermal efficiency and outlet air temperature are 76.0% and 62.2°C, respectively. The experimental analysis between two sampling notoginseng drying suggests that the solar drying is very effective, and the drying time has been shorten to about 440 minutes from 990 minutes of the traditional drying by sun. It is also observed that using the solar drying system notoginseng has a higher quality than traditional drying method.

Energy Analysis of the Direct and Indirect Solar Drying System

2017 ◽  
pp. 529-542
Author(s):  
Om Prakash ◽  
Anil Kumar ◽  
Prashant Singh Chauhan ◽  
Daniel I. Onwude
Keyword(s):  
Energy Analysis ◽  
Solar Drying ◽  
Drying System

Parabolic Solar Collector Coverage Made of High-Performance Concrete with Addition of Active Rice Husk Silica Integrated to a Biomass Thermoelectric Unit

2014 ◽  
Vol 634 ◽  
pp. 72-82
Author(s):  
Rosa Ana Conte ◽  
Daltro Garcia Pinatti ◽  
Luiz Fernando M. Marton ◽  
Sebastião Ribeiro ◽  
Thaís Witt Acosta ◽  
...  
Keyword(s):  
Solar Energy ◽  
Rice Husk ◽  
Solar Collector ◽  
High Performance ◽  
High Performance Concrete ◽  
Electrical Energy ◽  
Energy Generation ◽  
Boiler Water ◽  
Rice Husk Silica ◽  
Short Rotation

Production of active rice husk silica (ARHS) in bubbling fluidized bed boiler of a thermoelectric unit (TEU) and its addition to high performance concrete (HPC) with a compression resistance of 90 MPa was developed in the last 10 years. A first factory in Brazil was established at Alegrete town, RS, and other factories are under planning. Data of ARHS production, specification and HPC trace are presented. Design of parabolic solar collector coverage (PSCC) for air heating for biomass drying in a special silo of the TEU is presented as well. Cost of HPC/ARHS is 10 times less than steel (USD 200/ton vs. USD 2000/ton, specific mass 2.5 vs. 7.6 g/cm3, respectively). Those characteristics allow simultaneous solution of four ecological problems: large span coverage, rain water collection, daily solar energy collection and storage, and drying of biomass. The integration of those characteristics results in decrease of biomass consumption maintaining the same UTE efficiency. Tracking parabolic solar collector can be avoided between Cancer and Capricorn Tropics, and it is sufficient its eastern-western orientation with inclination to the Equator by the latitude angle. Coverage of the area occupied by TEU is sufficient to dry its biomass consumption. Preheating of boiler water with solar energy is possible decreasing biomass consumption in sunny days; biomass is partially consummed at night and cloudy days. Coupling the above technologies with high pressure steam TEU and fast-growing short-rotation forest gives to the biomass electrical energy generation a competitive economical position with hydraulic, coal, natural gas, and aeolic energy generation.

Effect of Corrugated Cover Directional Transmittance on the Thermal Performance of a Solar Collector

1981 ◽  
Vol 103 (2) ◽  
pp. 144-152
Author(s):  
T. F. Smith ◽  
S. Chaidar
Keyword(s):  
Solar Energy ◽  
Periodic Function ◽  
Thermal Performance ◽  
Solar Collector ◽  
Radiative Heat ◽  
Structural Strength ◽  
Heat Losses ◽  
Light Weight ◽  
Fiberglass Composite ◽  
Reduced Costs

The benefits of light weight, structural strength, and reduced costs without significant reduction of transmission of solar energy of a corrugated fiberglass composite cover promise wide utilization of this cover in solar collectors to suppress convective and radiative heat losses from the absorber panel. In order to evaluate the thermal performance of a collector with a corrugated cover, the directional transmittance of the cover must be available. A study was undertaken to develop a model for the directional transmittance of a corrugated cover as represented by a sinusoidal periodic function. As an application of this model, hourly and daily thermal efficiencies of a solar collector with a corrugated cover are presented.

scholarly journals Solar Drying Technology in Indonesia: an Overview

2018 ◽  
Vol 9 (4) ◽  
pp. 1804 ◽  
Author(s):  
Ahmad Fudholi ◽  
Abrar Ridwan ◽  
Rado Yendra ◽  
Ari Pani Desvina ◽  
Hartono Hartono ◽  
...  
Keyword(s):  
Solar Energy ◽  
Large Scale ◽  
Clean Energy ◽  
Solar Drying ◽  
Energy Technology ◽  
Important Benefit ◽  
Pollutant Source ◽  
Drying Technology

<span lang="EN-US">The most important benefit of solar energy is renewable and low pollutant source of energy (clean energy). Solar energy technology and research are developing fast and much of the technology needed for these applications in industry and agricultures is already available. Solar drying technology (SDT) is one of the most attractive and promising applications of solar energy technology. In this paper, the various performances of SDTs in Indonesia are summarized with details. Generally, the cabinet-type and tunnel-type SDTs are remarkably well suited to drying small quantities of vegetables and fruit on the household scale. Greenhouse and hybrid SDTs are suitable for use on a large scale by industries.</span>

Sign in / Sign up

Export Citation Format

Share Document