scholarly journals Realistic Simulation Tool for practical Analysis of Solar Cooling Thermal Systems driven by Linear Fresnel Collectors

2021 ◽  
Vol 28 (3) ◽  
pp. 360-377
Author(s):  
Juan J. Diaz ◽  
José A. Fernández
Keyword(s):  
Cooling System ◽  
Simulation Tool ◽  
Ambient Conditions ◽  
Correct Operation ◽  
Realistic Simulation ◽  
Solar Cooling ◽  
Collector System ◽  
Minimum Number ◽  
Solar Thermal Cooling

The objectives of this study were to develop a realistic simulation tool to analyze solar thermal cooling systems driven by Fresnel collectors and carry out a case study in which the performance of a solar cooling system of 190 kW located in Riyadh is simulated to demonstrate the functionality and potentiality of the developed tool. This tool is based on an integrated mathematical model that considers the ambient conditions, the thermal loads of the building, the pre-sizing data of each of the components of the system and the simultaneous interaction among them, to conduct a realistic, simple, and precise analysis. A demonstrative simulation example was performed. During the month of July, with a solar opening area of 704 m2 and a tank of 35200 L, a total amount of 47,5 MWh of cooling energy was obtained, with a reduced contribution of the auxiliary system (5,6 MWh) and a minimum number of solar collector system deactivation hours (0,7 %). The daily COP of the absorption machine remained above 0,69. The obtained results from the case study with the simulation tool allowed to verify its functionality, capabilities and correct operation to carry out hourly and parametric studies of this type of systems.

scholarly journals A solar air-cooled high efficiency absorption system in dry hot climates: Reduction of water consumption and environmental impact

2018 ◽  
Vol 22 (5) ◽  
pp. 2151-2162
Author(s):  
Jose Marcos ◽  
Raquel Lizarte ◽  
Fernando Varela ◽  
Maria Palacios-Lorenzo ◽  
Ana Blanco-Marigorta
Keyword(s):  
Water Consumption ◽  
High Efficiency ◽  
Cooling System ◽  
Double Effect ◽  
Environmental Benefits ◽  
Absorption System ◽  
Solar Cooling ◽  
Single Effect ◽  
Solar Cooling System

A solar cooling system with an optimized air-cooled double-effect water/LiBr absorption machine is proposed as a sustainable alternative to meet cooling demands in dry hot climates. This system allows eliminating the cooling towers in those regions of the planet where water is scarce. This work analyses the environmental benefits of this air-cooled system, as well as its environmental foot-prints, compared to a solar water-cooled single effect. In this regard, a methodology has been applied to calculate the annual saving in water consumption produced in a case study: a hospital located in Almer?a, in South of Spain. Further-more, the reduction in energy consumption and CO2 emissions is also quantified since this machine can be driven by solar energy and with higher efficiency than those of single effect.

Performance Analysis With Future Predictions of Different Solar Cooling Systems in Guayaquil, Ecuador

2014 ◽  
Author(s):  
Carlos Naranjo-Mendoza ◽  
Jesús López-Villada ◽  
Gabriel Gaona ◽  
Jerko Labus
Keyword(s):  
Flow Rate ◽  
Cooling System ◽  
Meteorological Data ◽  
Cooling Systems ◽  
Great Opportunity ◽  
Constant Flow Rate ◽  
Solar Cooling ◽  
Average Annual Temperature ◽  
System Configurations

This paper presents a comparative analysis of three different solar cooling system configurations developed for a case study building in Guayaquil, Ecuador. Guayaquil is a city located at the Ecuadorian coast with an average annual temperature of 25°C. The city’s need for air conditioning throughout the year and the relatively intense solar radiation provide a great opportunity for implementation of solar cooling systems. The first cooling system includes a 175 kWc single-effect absorption chiller powered by evacuated tubes solar thermal collectors. This system was compared with two 140 kWc compression chiller systems (air-cooled (AC) and water-cooled (WC)) powered by grid-connected photovoltaics. Both constant flow rate (CFR) and variable flow rate (VFR) of chilled water were analyzed. The three systems have to satisfy a cooling demand of the top floor in one governmental building (app. 1296 m2) which was selected as case study. Additionally, two 140 kWc conventional compression chiller systems (AC and WC) were included in the comparison as reference systems. Cooling demand of the building was simulated in EnergyPlus and coupled with the appropriate system configurations developed in TRNSYS. The weather file (TMY) was developed based on real meteorological data collected in the last decade. The present analysis was extended with the prediction scenarios for the years 2020, 2050 and 2080 using climate change adapted weather files.

scholarly journals Performance Assessment of Solar Cooling Systems with Energy Storage

2021 ◽  
Vol 312 ◽  
pp. 08014
Author(s):  
Giovanni Brumana ◽  
Giuseppe Franchini ◽  
Elisa Ghirardi
Keyword(s):  
Cooling System ◽  
Evaporative Cooling ◽  
Optimal Size ◽  
Ambient Conditions ◽  
Absorption Chiller ◽  
Cooling Systems ◽  
Detailed Model ◽  
Adsorption Chiller ◽  
Solar Cooling ◽  
Evaporative Cooling System

The paper presents a complete solar cooling comparison. A detailed model of a tertiary sector building has been evaluated in three locations (Riyadh, Abu Dhabi, and Palermo) and coupled with four solar cooling systems: two solar thermal cooling systems (Li-Br absorption chiller and adsorption chiller), a solar Desiccant Evaporative Cooling system and a solar electric cooling (Photovoltaic coupled with Compression chiller). A multi-variable optimization procedure selects the optimal size of each component. The results show that the solar cooling system based on absorption chiller satisfied the cooling demand regardless of the site location whilst the performance of the Desiccant Evaporative Cooling system is dramatically affected by ambient conditions. The electric solar cooling option shows the best overall efficiency and appears a costeffective solution despite the high cost of the storage system.

Solar cooling system using concentrating collectors for office buildings: A case study for Greece

2016 ◽  
Vol 97 ◽  
pp. 697-708 ◽  
Author(s):  
Vassiliki Drosou ◽  
Panos Kosmopoulos ◽  
Agis Papadopoulos
Keyword(s):  
Cooling System ◽  
Office Buildings ◽  
Solar Cooling ◽  
Solar Cooling System

Comparative Analysis of Solar Thermal Cooling and Solar Photovoltaic Cooling Systems

2011 ◽  
Author(s):  
N. Fumo ◽  
V. Bortone ◽  
J. C. Zambrano
Keyword(s):  
Energy Consumption ◽  
Fossil Fuels ◽  
Cooling System ◽  
Solar Thermal ◽  
Solar Photovoltaic ◽  
Solar Thermal Energy ◽  
Cooling Systems ◽  
Solar Cooling ◽  
Solar Thermal Cooling ◽  
Thermal Cooling

The Energy Information Administration of the United States Department of Energy projects that more than 80% of the energy consumption of the U.S. by 2035 will come from fossil fuels. This projection should be the fuel to promote projects related to renewable energy in order to reduce energy consumption from fossil fuels to avoid their undesirable consequences such as carbon dioxide emissions. Since solar radiation match pretty well building cooling demands, solar cooling systems will be an important factor in the next decades to meet or exceed the green gases reduction that will be demanded by the society and regulations in order to mitigate environmental consequences such as global warming. Solar energy can be used as source of energy to produce cooling through different technologies. Solar thermal energy applies to technology such as absorption chillers and desiccant cooling, while electricity from solar photovoltaic can be used to drive vapor compression electric chillers. This study focuses on the comparison of a Solar Thermal Cooling System that uses an absorption chiller driven by solar thermal energy, and a Solar Photovoltaic Cooling System that uses a vapor compression system (electric chiller) driven by solar electricity (solar photovoltaic system). Both solar cooling systems are compared against a standard air cooled cooling system that uses electricity from the grid. The models used in the simulations to obtain the results are described in the paper along with the parameters (inputs) used. Results are presented in two figures. Each figure has one curve for the Solar Thermal Cooling System and one for the Solar Photovoltaic Cooling System. One figure allows estimation of savings calculated based the net present value of energy consumption cost. The other figure allows estimating primary energy consumption reduction and emissions reduction. Both figures presents the result per ton of refrigeration and as a function of area of solar collectors or/and area of photovoltaic modules. This approach to present the result of the simulations of the systems makes these figures quite general. This means that the results can be used to compare both solar cooling systems independently of the cooling demand (capacity of the system), as well as allow the analysis for different sizes of the solar system used to harvest the solar energy (collectors or photovoltaic modules).

scholarly journals Simulation and economic analysis of solar cooling for building in tropical climate of Surabaya, Indonesia

2018 ◽  
Vol 49 ◽  
pp. 02009
Author(s):  
Elieser Tarigan
Keyword(s):  
Economic Analysis ◽  
Cooling System ◽  
Solar Thermal ◽  
Emission Analysis ◽  
Solar Cooling ◽  
Profitability Analysis ◽  
Absorption Cooling ◽  
Absorption Cooling System ◽  
Thermal Absorption

The possibility of solar cooling technologies is simulated and discussed in this work. Cooling system application for a six-floor university building in Surabaya Indonesia was taken as a case study. Two different solar technologies systems were designed and compared: (i) photovoltaic powered cooling system, and (ii) solar thermal absorption cooling system. Economic analysis was carried out based on the economic key-figures as well as the CO2 emission analysis. Based on the results gained in the profitability analysis, the most economically feasible system is solar thermal absorption cooling system due to the good agreement between solar radiation andcooling demand. Besides, this systems allows the maximum CO2 emissions savings.

Comparative Analysis of Solar Thermal Cooling and Solar Photovoltaic Cooling Systems

2012 ◽  
Vol 135 (2) ◽  
Author(s):  
N. Fumo ◽  
V. Bortone ◽  
J. C. Zambrano
Keyword(s):  
Energy Consumption ◽  
Fossil Fuels ◽  
Cooling System ◽  
Solar Thermal ◽  
Solar Photovoltaic ◽  
Solar Thermal Energy ◽  
Cooling Systems ◽  
Solar Cooling ◽  
Solar Thermal Cooling ◽  
Thermal Cooling

The Energy Information Administration of the United States Department of Energy projects that more than 80% of the energy consumption of the U.S. by 2035 will come from fossil fuels. This projection should be the fuel to promote projects related to renewable energy in order to reduce energy consumption from fossil fuels to avoid their undesirable consequences such as carbon dioxide emissions. Since solar radiation match pretty well building cooling demands, solar cooling systems will be an important factor in the next decades to meet or exceed the green gases reduction that will be demanded by the society and regulations in order to mitigate environmental consequences such as global warming. Solar energy can be used as source of energy to produce cooling through different technologies. Solar thermal energy applies to technology such as absorption chillers and desiccant cooling, while electricity from solar photovoltaic can be used to drive vapor compression electric chillers. This study focuses on the comparison of a solar thermal cooling system that uses an absorption chiller driven by solar thermal energy, and a solar photovoltaic cooling system that uses a vapor compression system (electric chiller) driven by solar electricity (solar photovoltaic system). Both solar cooling systems are compared against a standard air cooled cooling system that uses electricity from the grid. The models used in the simulations to obtain the results are described in the paper along with the parameters (inputs) used. Results are presented in two figures. Each figure has one curve for the solar thermal cooling system and one for the solar photovoltaic cooling system. One figure allows estimation of savings calculated based the present value of discounted energy consumption cost. The other figure allows estimating primary energy consumption reduction and emissions reduction. Both figures presents the result per ton of refrigeration and as a function of area of solar collectors or/and area of photovoltaic modules. This approach to present the result of the simulations of the systems makes these figures quite general. This means that the results can be used to compare both solar cooling systems independently of the cooling demand (capacity of the system), as well as allow the analysis for different sizes of the solar system used to harvest the solar energy (collectors or photovoltaic modules).

Sign in / Sign up

Export Citation Format

Share Document