scholarly journals Chemical analysis of the biomass of a native strain of Spirulina subsalsa Oersted ex Gomont 1892 (Spirulinaceae) cultivated in low-cost saline medium

2019 ◽  
Vol 13 (26) ◽  
pp. 438-445
Author(s):  
Romero Maza Lolymar ◽  
Angel Guevara Acosta Miguel ◽  
José Cortez Mago Roraysi
Alloy Digest ◽  
2003 ◽  
Vol 52 (12) ◽  

Abstract Algoma AR225 is a carbon steel developed primarily to supply a low-cost material for high-abrasion applications. It is furnished in the form of as-rolled plate with a relatively high carbon content (0.35-0.45%). AR-225 is sold on the basis of chemical analysis only; the number 225 signifies the approximate Brinell hardness. On thicknesses one-half inch and over, this Brinell value may be lower than 225 because of higher finishing temperatures. This datasheet provides information on composition, physical properties, hardness, and elasticity. It also includes information on forming, heat treating, machining, and joining. Filing Code: CS-138. Producer or source: Algoma Steel Corporation Ltd.


Author(s):  
Jane Lovegrove

Urinalysis simply means analysis of urine. It is an easily performed investigation that can detect a wide variety of abnormalities within a few minutes at low cost. Urinalysis is an investigation which all nurses should be competent to perform and is identified by the NMC (2007) as being an example of an essential skill nurse students should be competent to perform before entering their branch programme. Urinalysis may be performed in a wide variety of clinical settings. It should be performed on every patient entering the acute care setting. Additionally, the National Confidential Enquiry into Patient Outcome and Death (NCEPOD (2009), stresses the need for urinalysis to be performed on all emergency admissions to an acute hospital. It may also be performed in outpatient and general practice clinics, and community areas. To obtain the most accurate information from the test, students need to know how to obtain and assess a sample of urine and be aware of factors that may influence the reliability of the investigation. Urine may be tested in three different ways. ● Macroscopic urinalysis, ● Microscopic urinalysis, ● Chemical analysis. Macroscopic and chemical analysis are the investigations performed in the clinical setting which may be tested by OSCE. Microscopic investigation requires samples to be sent to a laboratory. Macroscopic analysis is the analysis of the urine by the naked eye. Chemical analysis may be performed by use of a plastic diagnostic reagent strip or ‘dipstick’ which contains small pads of chemicals which react to substances that may be found in urine. For purposes of testing urine at random, clients are asked to urinate into a clean but not sterile dry container with no precautions regarding contamination. In females in particular this may result in samples being contaminated by vaginal fluids, such as blood or mucus. Due to the risk of contamination a mid-stream specimen of urine may be required if an abnormality is found in a random sample. A mid-stream specimen requires cleaning of the external urethral meatus prior to urination, passing the first half of the bladder contents into the lavatory, and passing the second part of the urine flow into a sterile container.


RSC Advances ◽  
2018 ◽  
Vol 8 (51) ◽  
pp. 29062-29070 ◽  
Author(s):  
Sonia Andrikaki ◽  
Katerina Govatsi ◽  
Spyros N. Yannopoulos ◽  
George A. Voyiatzis ◽  
Konstantinos S. Andrikopoulos

Simple, reproducible and low-cost SERS substrates for ultra-sensitive chemical analysis/quantification offered by thermal dewetting of thin metallic films.


2016 ◽  
Vol 75 (2) ◽  
pp. 439-450 ◽  
Author(s):  
Asmaa Ali ◽  
Abdelkader Ahmed ◽  
Ali Gad

This study aims to investigate the ability of low cost ceramic membrane filtration in removing three common heavy metals namely; Pb2+, Cu2+, and Cd2+ from water media. The work includes manufacturing ceramic membranes with dimensions of 15 by 15 cm and 2 cm thickness. The membranes were made from low cost materials of local clay mixed with different sawdust percentages of 0.5%, 2.0%, and 5.0%. The used clay was characterized by X-ray diffraction (XRD) and X-ray fluorescence analysis. Aqueous solutions of heavy metals were prepared in the laboratory and filtered through the ceramic membranes. The influence of the main parameters such as pH, initial driving pressure head, and concentration of heavy metals on their removal efficiency by ceramic membranes was investigated. Water samples were collected before and after the filtration process and their heavy metal concentrations were determined by chemical analysis. Moreover, a microstructural analysis using scanning electronic microscope (SEM) was performed on ceramic membranes before and after the filtration process. The chemical analysis results showed high removal efficiency up to 99% for the concerned heavy metals. SEM images approved these results by showing adsorbed metal ions on sides of the internal pores of the ceramic membranes.


2014 ◽  
Vol 39 (1) ◽  
pp. 131
Author(s):  
Kátia Isabel Milagres ◽  
Camila Rodrigues Amaral ◽  
Érica M. da Silva Santos ◽  
Tarcísio B. Marques ◽  
Guilherme De O. Gomes

The photometry in the visual field has wide application in analytical laboratories and research physical, chemical, biochemical, pharmacological, etc. It is essential that students of physics and chemistry have knowledge about this quantitative technique. One obstacle to the widespread use of this technique is the cost of equipment and materials to be used. The objective of this work is the introduction of a photometer didactic, whose construction and technique with a low operating cost and the easy using and producing results, as a practical solution to put school improvement. The features highlighted in the work do the proposed photometer an economically viable alternative tool for chemical analysis in the laboratories of the Faculty for research and / or teaching.


2008 ◽  
Vol 128 (2) ◽  
pp. 422-426 ◽  
Author(s):  
G.S. Virdi ◽  
R.K. Chutani ◽  
P.K. Rao ◽  
Sushil Kumar

2012 ◽  
Vol 11 (2) ◽  
pp. 111-116 ◽  
Author(s):  
Oľga Šestinová ◽  
Lenka Findoráková ◽  
Jozef Hančuľák

Abstract This study presents the results of the testing toxicity of the contaminated sediments from the water reservoir of Ružín No.I deposit (Slovak Republic) by using Phytotoxkit tests (MicroBioTests Inc., Belgium). The Phytotoxkit system is a screening tool used for a variety of toxicity testing applications. The advantages of this toxicity bioassay are its speed, relative simplicity and low cost compared to chemical analysis and many other biotests. Evaluation of sediments phytotoxicity was based on the testing of seed germination and the assesment of the root growth decrease of the plant Sinapis alba which allows to complete the assays after only 3 days of incubacion. Chemical analysis of the sediment samples involved determination of heavy metal (Cu, Zn, Ni, As, Sb and Hg) concentration. No potential phytotoxic effect of heavy metals in contaminated sediments was observed in the majority of tested seeds of Sinapis alba.


2011 ◽  
Vol 130-134 ◽  
pp. 3329-3333
Author(s):  
An Liang Zhang ◽  
Qin Jiang Han

A new low cost microfluidic device has been designed and fabricated. Three thread microchannels were fabricated using tape and three indicting filter papers were also made by dipping three filter papers into sodium nitrite with different concentration. The side of the thread microchannels was connected to the indicting filter papers and then mounted on a 1280yx-LiNbO3piezoelectric substrate, on which an interdigital transducer and reflector were fabricated using microeletric technology. PDMS film was coated to avoid the evaporation of microfluid transporting in the thread based microchannels. When a 25.5MHz RF signal with 25.4dBm power was applied on the IDT, the microfluid on the piezoelectric substrate was actuated by surface acoustic wave and transported along the thread microchannels, and reacted with nitrite ion in the indicting filter paper. Experimental results show that the thread-piezoelectric substrate microfluidic device can be used for biological or chemical analysis.


Sign in / Sign up

Export Citation Format

Share Document