AGGREGATION OF MS-MONOPYRIDYL-Β-OCTAALKYLPORPHYRINS IN DICHLOROMETHANE IN PRESENCE OF Pd(II)

Aggregation of 13,17-diethyl-2,3,7,8,12,18-hexamethyl-5-(pyridin-4-yl) porphyrin (I), 13,17-diethyl-2,3,7,8,12,18-hexamethyl-5-(pyridin-3-yl)porphyrin (II) and 13.17-diethyl-2,3,7,8,12,18-hexamethyl-5-(pyridin-2-yl)porphyrin (III) in the presence of trans-bis(benzonitrile)palladium(II) dichloride was studied by dynamic light scattering and electronic absorption spectroscopy in dichloromethane at 293 K. The average aggregate size and the nature of their distribution were determined. Using scanning electron microscopy, it was determined the size and composition of clusters formed by aggregates of complexes of the palladium(II) cation with the studied porphyrins. It was shown that minimal acetic acid additions lead to the destruction of the corresponding clusters. At the same time, complete destruction of the aggregates does not occur even with a 100-fold molar excess of acid.We used the Zetasizer Nano ZS (model ZEN3600, Malvern Instruments), equipped with a 633nm laser and non-invasive backscattering (NIBS) technology when the scattered light detector is positioned at an angle of 173° to the incident light. Confirmation of porphyrin aggregation was performed by additional study of the structure using a Hitachi TM4000Plus desktop electron microscope equipped with a 4-segment highly sensitive semiconductor detector and a secondary electron detector for low vacuum mode. Elemental analysis of the obtained aggregates in the cluster was performed using a silicon drift detector with a working area of 30 mm2, combined with a Hitachi TM4000Plus microscope. It was found that aggregates consisting of a para-pyridyl derivative of alkylporphyrin and trans-bis (benzonitrile) palladium (II) dichloride are formed in dichloromethane at 293 K. The best results of porphyrin structures were observed for mixtures of 13,17-diethyl-2,3,7,8,12,18-5-hexamethyl-5-(pyridine-4-yl)porphyrin with TRANS-bis(benzonitrile)- palladium (II) dichloride in a ratio of 1:3, which is probably due to less spatial shielding of the reaction center of the macrocycle and, as a result, better stabilization of the resulting particles. The size of a cluster consisting of individual aggregates was measured using scanning electron microscopy. An elemental analysis of a single aggregate was obtained.