Effect of Heat Treatment on Microstructure and Mechanical Properties of AlSi10Mg Alloy Fabricated by Selective Laser Melting

The effects of the heat treatment process parameters on the microstructure and mechanical properties of a selective laser melted (SLMed) AlSi10Mg alloy were systematically investigated. The SLMed AlSi10Mg alloy was treated with T1 (180°C× 4h + air cooling) process, which had the microstructure of fine α-Al grains, fine Si phase, and nano-sized precipitations. The microhardness significantly increased to 150 HV, which is even higher than as-SLMed one (126 HV). The microhardness of SLMed AlSi10Mg alloy treated with T4 (540°C × 2h + water cooling) heat-treatment process significantly decreased to 62 HV due to the growth of α-Al grains, Si phase and the formation of β-AlFeSi phase. However, the microhardness and ultimate tensile strength of AlSi10Mg alloy treated with T6 (540°C × 2 h water cool + 180°C × 4 h air cool) process decreased to 91 HV, although the strengthening precipitation of Mg2Si phase formed. It indicates that the Mg2Si phase cannot compensate for the adverse effect of grain growth. It may provide the best potential heat treatment method for fabricating the high strength SLMed AlSi10Mg alloy.

The COOL-Process—A Selective Approach for Recycling Lithium Batteries

The global market of lithium-ion batteries (LIB) has been growing in recent years, mainly owed to electromobility. The global LIB market is forecasted to amount to $129.3 billion in 2027. Considering the global reserves needed to produce these batteries and their limited lifetime, efficient recycling processes for secondary sources are mandatory. A selective process for Li recycling from LIB black mass is described. Depending on the process parameters Li was recovered almost quantitatively by the COOL-Process making use of the selective leaching properties of supercritical CO2/water. Optimization of this direct carbonization process was carried out by a design of experiments (DOE) using a 33 Box-Behnken design. Optimal reaction conditions were 230 °C, 4 h, and a water:black mass ratio of 90 mL/g, yielding 98.6 ± 0.19 wt.% Li. Almost quantitative yield (99.05 ± 0.64 wt.%), yet at the expense of higher energy consumption, was obtained with 230 °C, 4 h, and a water:black mass ratio of 120 mL/g. Mainly Li and Al were mobilized, which allows for selectively precipitating Li2CO3 in battery grade-quality (>99.8 wt.%) without the need for further refining. Valuable metals, such as Co, Cu, Fe, Ni, and Mn, remained in the solid residue (97.7 wt.%), from where they are recovered by established processes. Housing materials were separated mechanically, thus recycling LIB without residues. This holistic zero waste-approach allows for recovering the critical raw material Li from both primary and secondary sources.

Three-Dimensional Numerical Simulation of Temperature Field and Force Field of T-Type Turbe during Welding

Residual stress affect the lifetime of weldments directly. Temperature Generated from the welding process is the major reason that influences the microstructure and mechanical properties of the metal weldments. Therefore it is necessary to simulate the temperature field for optimizing the structure of weldments. In this work the three-dimension finite element analysis software SYSWELS was used to simulate T-type tube, and carried on a detailed analysis of temperature field and residual stress in cool process of weld.