Experimental study on the aerodynamic influence of purge flow in a turbine cascade with different mainstream incidence angles

Demand for high reliability and long life of modern turbine requires that turbine components should be cooled adequately. The cooling flow purged into the rotor-stator disk cavity will inevitably interact with the mainstream. The current paper mainly focuses on the aerodynamic influence of cooling flow on the secondary flows in the mainstream. Both particle image velocimetry and blade wall pressure measurement were utilized to study the flow field within the turbine blade passage under different mainstream incidence angles and purge flow rates. The purge flow was found to promote the development of the passage vortex by inducing vortices which can enhance the vorticity of the passage vortex. In addition, the mainstream incidence angle also has an impact on the development of the passage vortex through affecting the blade loading and the horseshoe vortex. Furthermore, the transient results demonstrate that the time-averaged vortex is the superposition of large number of transient vortices, and the purge flow causes more transient vortices with large size and high strength.

Cooling holes with different structures effects on coolant cross flow and heat transfer at the outlet of the combustion chamber

The major effects of cylindrical and row trenched cooling holes with angles of alpha=30, beta=0, alpha=40, beta=0 and alpha=50, beta=0 at BR=3.18 on the effectiveness of film cooling near the combustor end wall surface is an important subject to study in detail. In the current study, researchers used a FLUENT package 16/11 to simulate a 3-D model of a Pratt and Whitney gas turbine engine. In this research, RNG turbulence model K-ε model was used to analyze the flow behavior on the passage ways of internal cooling. In the combustor simulator, the dilution jets and cooling flow staggered in the streamwise direction and aligned in the spanwise direction as well. In comparison with the baseline case of cooling holes, the application of trenched hole near the end wall surface increased the effectiveness of film cooling up to 100% for different trench cases.

Effect of Rotation on Heat Transfer in AR = 2:1 and AR = 4:1 Channels Connected by a Series of Crossover Jets

Detailed heat transfer measurements using transient liquid crystal thermography were performed on a novel cooling design covering the mid-chord and trailing edge region of a typical gas turbine blade under rotation. The test section comprised of two channels with aspect ratio (AR) of 2:1 and 4:1, where the coolant was fed into the AR = 2:1 channel. Rib turbulators with a pitch-to-rib height ratio (p/e) of 10 and rib height-to-channel hydraulic diameter ratio (e/Dh) of 0.075 were placed in the AR = 2:1 channel at 60° relative to flow direction. The coolant after entering this section was routed to the AR = 4:1 section through a set of crossover jets. The 4:1 section had a realistic trapezoidal shape that mimics the trailing edge of an actual gas turbine blade. The pin fins were arranged in a staggered array with a center-to-center spacing of 2.5 times pin diameter. The trailing edge section consisted of radial and cutback exit holes for flow exit. Experiments were performed for Reynolds number of 20,000 at Rotation numbers (Ro) of 0, 0.1 and 0.14. The channel averaged heat transfer coefficient on trailing side was ~28% (AR = 2:1) and ~7.6% (AR = 4:1) higher than the leading side for Ro = 0.1. It is shown that the combination of crossover jets and pin-fins can be an effective method for cooling wedge shaped trailing edge channels over axial cooling flow designs.