The influence of liquid rubber on selected properties of rubber compound and its vulcanizates

The aim of the work was to determine the influence of liquid rubber on selected properties of rubber compound and its vulcanizates. Due to the liquid form of this rubber, it is not possible to completely replace the conventional solid rubber used in the mixture because of problems in further processing. In four experimental tests, we used different amounts of liquid rubber in the recipe together with butadiene-styrene rubber and the compounds we mixed according to the general conditions. We studied the curing characteristics of prepared mixture and we measuremend physical and mechanical properties of study vulcanizates and summarized the individual measured values for each parameter and suggested the greatest importance of the recipe for rubber practice.

The Effect of Liquid Rubber Addition on the Physicochemical Properties, Cytotoxicity and Ability to Inhibit Biofilm Formation of Dental Composites

The aim of this study was to evaluate the effect of modification with liquid rubber on the adhesion to tooth tissues (enamel, dentin), wettability and ability to inhibit bacterial biofilm formation of resin-based dental composites. Two commercial composites (Flow-Art–flow type with 60% ceramic filler and Boston–packable type with 78% ceramic filler; both from Arkona Laboratorium Farmakologii Stomatologicznej, Nasutów, Poland) were modified by addition of 5% by weight (of resin) of a liquid methacrylate-terminated polybutadiene. Results showed that modification of the flow type composite significantly (p < 0.05) increased the shear bond strength values by 17% for enamel and by 33% for dentine. Addition of liquid rubber significantly (p < 0.05) reduced also hydrophilicity of the dental materials since the water contact angle was increased from 81–83° to 87–89°. Interestingly, modified packable type material showed improved antibiofilm activity against Steptococcus mutans and Streptococcus sanguinis (quantitative assay with crystal violet), but also cytotoxicity against eukaryotic cells since cell viability was reduced to 37% as proven in a direct-contact WST-8 test. Introduction of the same modification to the flow type material significantly improved its antibiofilm properties (biofilm reduction by approximately 6% compared to the unmodified material, p < 0.05) without cytotoxic effects against human fibroblasts (cell viability near 100%). Thus, modified flow type composite may be considered as a candidate to be used as restorative material since it exhibits both nontoxicity and antibiofilm properties.

Dielectric Relaxation Characteristics of Epoxy Resin Modified with Hydroxyl-Terminated Nitrile Rubber

Utilizing liquid rubber to toughen epoxy resin is one of the most mature and promising methods. However, the dielectric relaxation characteristics of the epoxy/liquid rubber composites have not been studied systematically, while the relaxation behaviours are a critical factor for both micro and macro properties. In this paper, hydroxyl-terminated liquid nitrile rubber (HTBN) is employed to reinforce a kind of room-temperature-cured epoxy resin. The dielectric spectrum is measured and analysed. Results show that two relaxation processes are introduced in the binary composites. The α relaxation of HTBN shows a similar temperature dependence with the β relaxation of epoxy resin. The interfacial polarization leads to an increase of complex permittivity, which reaches its maximum at 70 °C. In addition, affected by interfacial polarization, the thermionic polarization is inhibited, and the samples with filler ratios of 15% and 25% show lower DC-conductivity below 150 °C. In addition, the α relaxation and thermionic polarization of epoxy resin obey the Vogel‒Fulcher‒Tammann law, while the interfacial polarization and DC-conductivity satisfy with the Arrhenius law. Furthermore, the fitting results of the Vogel temperature of α relaxation, glass transition temperature, apparent activation energy of interfacial polarization and DC-conductivity all decline with HTBN content. These results can provide a reference and theoretical guidance for the assessment of dielectric properties and the improvement of the formulation of liquid-rubber-toughened epoxy resin.