Analysis of The Phase Velocities of (Pure, Slow And Fast ) Alfvèn Waves In The E Region of The Ionosphere For Low Latitudes

In this paper, (pure, slow, and fast) Alfvèn waves for the accepted conditions in Northern-hemisphere at E-region of ionospheric plasma were calculated with low latitudes by using Eq. (20,25-26) and the real geometry of Earth’s magnetic field, at hours 12.00 LT for the 1990 year which sunspot is maximum. One of the most important results of this study is to show analytically that the “MHD modes= (pure, slow and fast) Alfvèn waves” depend not only on the angle between the wave propagation vector (k) and the magnetic field (B) but also on the declination (D=It is the angle value between the direction of the sun's rays and the equatorial plane) and magnetic dip angle (I=It is the angle between real north and magnetic north). From the results obtained, the behavior of the magnitudes of the squares of the phase velocities of all MHD modes is consistent with the behavior of the distribution of electron density with low geographic latitude, even if the magnetic field vector is both perpendicular and parallel to the propagation vector of the wave. In parallel, the phase velocities of the waves are greater in summer than in winter. It has been determined that the propagation velocities of the fast and slow MHD mode in the magnetic equatorial trough region at (q = I) are very small, the energy is almost non-existent, but if q = 90 + I, the energy increases with latitude and is approximately maximum at the low latitude limit. It can be said that the minimum points are between 0-10 oN latitudes where the wave energies are the smallest, and the maximum points are between 20-30 oN latitudes the wave energies are the biggest.

Decoupling approximation of P- and S-wave phase velocities in orthorhombic media

Characterizing the kinematics of seismic waves in elastic orthorhombic media involves nine independent parameters. All wave modes, P-, S1-, and S2-waves, are intrinsically coupled. Since the P-wave propagation in orthorhombic media is weakly dependent on the three S-wave velocity parameters, they are set to zero under the acoustic assumption. The number of parameters required for the corresponding acoustic wave equation is thus reduced from nine to six, which is very practical for the inversion algorithm. However, the acoustic wavefields generated by the finite-difference scheme suffer from two types of S-wave artifacts, which may result in noticeable numerical dispersion and even instability issues. Avoiding such artifacts requires a class of spectral methods based on the low-rank decomposition. To implement a six-parameter pure P-wave approximation in orthorhombic media, we develop a novel phase velocity approximation approach from the perspective of decoupling P- and S-waves. In the exact P-wave phase velocity expression, we find that the two algebraic expressions related to the S1- and S2-wave phase velocities play a negligible role. After replacing these two algebraic expressions with the designed constant and variable respectively, the exact P-wave phase velocity expression is greatly simplified and naturally decoupled from the characteristic equation. Similarly, the number of required parameters is reduced from nine to six. We also derive an approximate S-wave phase velocity equation, which supports the coupled S1- and S2-waves and involves nine independent parameters. Error analyses based on several orthorhombic models confirm the reasonable and stable accuracy performance of the proposed phase velocity approximation. We further derive the approximate dispersion relations for the P-wave and the S-wave system in orthorhombic media. Numerical experiments demonstrate that the corresponding P- and S-wavefields are free of artifacts and exhibit good accuracy and stability.

Compact Itinerant Microwave Photonics with Superconducting High-Kinetic Inductance Microstrips

Microwave photonics is a remarkably powerful system for quantum simulation and technologies, but its integration in superconducting circuits, superior in many aspects, is constrained by the long wavelengths and impedance mismatches in this platform. We introduce a solution to these difficulties via compact networks of high-kinetic inductance microstrip waveguides and coupling wires with strongly reduced phase velocities. We demonstrate broadband capabilities for superconducting microwave photonics in terms of routing, emulation and generalized linear and nonlinear networks.

Mesh filtration problems with a two-flow structure of phase velocities

This paper deals with the problem of filtration of a two-phase incompressible fluid within the Buckley-Leverett model. From a general point of view, a two-flow structure of conservation laws is investigated. In addition, since the solution in the Buckley-Leverett model is discontinuous, conservation laws are presented in the generalized integral form. A good illustration of the approach presented is the problem of gravitational segregation of oil and water in a porous medium. For this problem, a two-flow mesh structure of conservation laws is described.

Finite-Difference Modeling and Characteristics Analysis of Love Waves in Anisotropic-Viscoelastic Media

ABSTRACT In this study, the characteristics of Love waves in viscoelastic vertical transversely isotropic layered media are investigated by finite-difference numerical modeling. The accuracy of the modeling scheme is tested against the theoretical seismograms of isotropic-elastic and isotropic-viscoelastic media. The correctness of the modeling results is verified by the theoretical phase-velocity dispersion curves of Love waves in isotropic or anisotropic elastic or viscoelastic media. In two-layer half-space models, the effects of velocity anisotropy, viscoelasticity, and attenuation anisotropy of media on Love waves are studied in detail by comparing the modeling results obtained for anisotropic-elastic, isotropic-viscoelastic, and anisotropic-viscoelastic media with those obtained for isotropic-elastic media. Then, Love waves in three typical four-layer half-space models are simulated to further analyze the characteristics of Love waves in anisotropic-viscoelastic layered media. The results show that Love waves propagating in anisotropic-viscoelastic media are affected by both the anisotropy and viscoelasticity of media. The velocity anisotropy of media causes substantial changes in the values and distribution range of phase velocities of Love waves. The viscoelasticity of media leads to the amplitude attenuation and phase velocity dispersion of Love waves, and these effects increase with decreasing quality factors. The attenuation anisotropy of media indicates that the viscoelasticity degree of media is direction dependent. Comparisons of phase velocity ratios suggest that the change degree of Love-wave phase velocities due to viscoelasticity is much less than that caused by velocity anisotropy.

Analysis of S waves singularity points in porous rock with two orthogonal sets of mesoscale fractures

SUMMARY The shear waves phase velocity surfaces in orthorhombic (ORT) and lower symmetry anisotropic models touch each other in one or more points resulting in so called singularity points or acoustic axes. These singularity points result in dramatic changes of velocities, amplitudes and polarizations creating problems in seismic data processing and analysis. Considering the frequency-dependent anisotropy due to mesoscale fractures in Chapman's model, we describe the singularity points in porous rock with two orthogonal sets of mesoscale fractures. First, we give the equations for frequency-dependent phase velocities of P, S1 and S2 waves in this anelastic ORT media. Then, we derive the expressions for frequency-dependent singularity points within the symmetry planes and discuss the conditions to detect the existence of singularity point. Finally, the influences of frequency, porosity, fracture density, fracture scale and saturating fluid style on the positions of singularity points within the symmetry plane are investigated.

Theoretical Issues with Rayleigh Surface Waves and Geoelectrical Method Used for the Inversion of Near Surface Geophysical Structure

We numerically simulate the field measurements of Rayleigh surface waves and electrical resistivity in which the target depth is set to be less than 50-m. The Rayleigh surface waves are simulated in terms of fundamental mode group and phase velocities. The seismic field data is assumed to be collected through a conventional shot-gather. The group velocities are found from the application of the multiple filter technique in a single-station fashion while for the phase velocities the slant stacking, or linear radon transform are applied in fashion of multichannel analysis of surface waves (MASW). The average seismic structure from the source to the receiver (or geophone) is represented by the group velocity curve while the average seismic structure underneath the geophone array is represented by the phase velocity curve. The single-station group velocity curves are transformed into local group velocity curves by setting a linear system through grid points. The shear-wave velocity cross section underneath the examined area is constructed by inverting these local group velocity curves. The electrical resistivity structure of the underground is similarly studied. The field compilation of the resistivity data is assumed to be completed by the application of the multiple electrode Pole-Pole array. The actual resistivity assemble underneath the analyzed area is inverted by considering the apparent (measured) resistivity values. Unique forms such as ore body, cavity, sinkhole, melt, salt, and fluid within the Earth may be examined by joint interpretation of electrical resistivities and seismic velocities. These formations may be better outlined by following their distinct signs such as high/low resistivities and high/low seismic velocities. Doi: 10.28991/HEF-2021-02-03-01 Full Text: PDF