iberian chain
Recently Published Documents


TOTAL DOCUMENTS

93
(FIVE YEARS 14)

H-INDEX

22
(FIVE YEARS 1)

CATENA ◽  
2022 ◽  
Vol 211 ◽  
pp. 105965
Author(s):  
David Badía-Villas ◽  
Rosa M. Poch ◽  
Luis A. Longares ◽  
Alfonso Yuste ◽  
Blanca Bauluz
Keyword(s):  

2021 ◽  
pp. 1-16
Author(s):  
Alba Peiro ◽  
José L. Simón

Abstract The NNW–SSE-trending extensional Río Grío–Pancrudo Fault Zone is a large-scale structure that obliquely cuts the Neogene NW–SE Calatayud Basin. Its negative inversion during the Neogene–Quaternary extension gave rise to structural and geomorphological rearrangement of the basin margin. Geological mapping has allowed two right-relayed fault segments to be distinguished, whose recent extensional activity has been mainly characterized using a deformed planation surface (Fundamental Erosion Surface (FES) 3; 3.5 Ma) as a geomorphic marker. Normal slip along the Río Grío–Lanzuela Fault Segment has induced hanging-wall tilting, subsequent drainage reversal at the Güeimil valley after the Pliocene–Pleistocene transition, as well as morphological scarps and surficial ruptures in Pleistocene materials. In this sector, an offset of FES3 indicates a total throw of c. 240 m, resulting in a slip rate of 0.07 mm a–1, while retrodeformation of hanging-wall tilting affecting a younger piedmont surface allows the calculation of a minimum throw in the range of 140–220 m after the Pliocene–Pleistocene transition, with a minimum slip rate of 0.07–0.11 mm a–1. For the late Pleistocene period, vertical displacement of c. 20 m of a sedimentary level dated to 66.6 ± 6.5 ka yields a slip rate approaching 0.30–0.36 mm a–1. At the Cucalón–Pancrudo Fault Segment, the offset of FES3 allows the calculation of a maximum vertical slip of 300 m for the last 3.5 Ma, and hence a net slip rate close to 0.09 mm a–1. Totalling c. 88 km in length, the Río Grío–Pancrudo Fault Zone could be the largest recent macrostructure in the Iberian Chain, probably active, with the corresponding undeniable seismogenic potential.


2021 ◽  
Vol 65 ◽  
pp. 101185
Author(s):  
Davinia Moreno ◽  
Francisco Gutiérrez ◽  
Miren del Val ◽  
Domingo Carbonel ◽  
Fernando Jiménez ◽  
...  

2021 ◽  
Vol 145 ◽  
pp. 104298
Author(s):  
J.L. Simón ◽  
A.M. Casas-Sainz ◽  
A. Gil-Imaz
Keyword(s):  

2021 ◽  
Author(s):  
David Badía-Villas ◽  
Rosa M. Poch ◽  
Luis A. Longares ◽  
Alfonso Yuste ◽  
Blanca Bauluz
Keyword(s):  

2020 ◽  
Vol 115 ◽  
pp. 104544
Author(s):  
Jordi Pérez-Cano ◽  
Telm Bover-Arnal ◽  
Carles Martín-Closas
Keyword(s):  

2020 ◽  
Vol 12 (21) ◽  
pp. 9034
Author(s):  
Eugenio Sanz ◽  
Ignacio Menéndez Pidal ◽  
José Ignacio Escavy ◽  
Joaquin Sanz de Ojeda

The response of springs to earthquakes in the zone of moderate seismicity associated with the fault under study (the Talamantes–Castilruiz fault, Soria, Spain) always leads to a flow decrease regardless of the magnitude of the earthquake and the distance from the epicenter. The sensitivity of the springs is explained by the different degrees of the confinement of their aquifers. The semi-confined aquifer of the Vozmediano spring (1100 L/s) experiences short post-seismic events with a variable decrease in flow and an increase in turbidity, depending on the intensity of the earthquakes felt at the site (Intensity). These changes are likely due to elastic deformation and an increased permeability in their aquifers. This spring is an example of how previous (historical) earthquakes can break the aquifer through the fault causing horizontal movements of the groundwater and displacing the discharge point to a different fracture site located six kilometers from the initial point.


Geomorphology ◽  
2020 ◽  
Vol 363 ◽  
pp. 107233
Author(s):  
Francisco Gutiérrez ◽  
Davinia Moreno ◽  
Gloria I. López ◽  
Fernando Jiménez ◽  
Miren del Val ◽  
...  

2020 ◽  
Vol 403 ◽  
pp. 105673
Author(s):  
Elisa Laita ◽  
Blanca Bauluz ◽  
Marcos Aurell ◽  
Beatriz Bádenas ◽  
José Ignacio Canudo ◽  
...  

2020 ◽  
Vol 18 ◽  
pp. 1-26
Author(s):  
F. Ortí ◽  
J. Guimerà ◽  
A.E. Götz

The present study provides new data of the Middle-Upper Triassic successions and their deformation in the eastern Iberian Chain, where contractional tectonics during the Cenozoic disrupted this Mediterranean type of Triassic rocks. The succession, divided into three Muschelkalk units, was studied in the Alt Palància area. In this area, both the lower and upper Muschelkalk consist of two main types of sub-units, those made up of carbonate and those of carbonate-marl alternation. The marked similarity observed between the evaporite units of the middle Muschelkalk and the Keuper humpers their unambiguous discrimination in the field. The integration of geological mapping, stratigraphic logging, palynological dating and gypsum isotope analysis carried out provided that: i) a change in the structural style, facies, and depositional thickness occurs across a SW to NE transect at both sides of the Espina-Espadà Fault, providing evidence for the extensional activity of this major structure; ii) palynological data assign Anisian age to the Röt facies and the lower and the middle Muschelkalk units, and Ladinian to the upper Muschelkalk unit; iii) the δ34SCDT and δ18OSMOW values of gypsum reveal as a useful proxy to discriminate between the middle Muschelkalk (δ34S: 15.6 to 17.8‰) and the Keuper (δ34S: 14 to 15.5‰) units; and iv) the isotopic signature also helps to identify clayey-marly gypsiferous outcrops made up of the two evaporite facies due to tectonic juxtaposition. These results confirm the Mediterranean type of Triassic rocks for the entire Alt Palància and other areas to the NE. This multidisciplinary approach reveals as a robust methodology to study Triassic basins in Iberia and to other geological domains where the carbonate-evaporite successions have been greatly disrupted by tectonism.


Sign in / Sign up

Export Citation Format

Share Document