DEVELOPMENT OF RANGE FINDER BASED ON ULTRASONIC DISTANCE SENSOR HC-SR04

The article considers the development of a range meter to an object in centimeters based on an ultrasonic distance sensor HC-SR04.

Exploring Torricelli's theorem with Arduino

We explore the dynamics of the water in a PVC pipe during the drain using two independent sensors simultaneously. We track the height of the water column and the discharge velocity of the water through the hole made in the lower part of the pipe. The ultrasonic distance sensor and the flow meter used as sensors were controlled by an Arduíno board. The acquired data follows the theoretical models but, with a coefficient of discharge smaller than 1.

Mirau-Based CSI with Oscillating Reference Mirror for Vibration Compensation in In-Process Applications

We present a Mirau-type coherence scanning interferometer (CSI) with an oscillating reference mirror and an integrated interferometric distance sensor (IDS) sharing the optical path with the CSI. The IDS works simultaneously with the CSI and measures the distance changes during the depth scanning process with high temporal resolution. The additional information acquired by the IDS is used to correct the CSI data disturbed by unwanted distance changes due to environmental vibrations subsequent to the measurement. Due to the fixed reference mirror in commercial Mirau objectives, a Mirau attachment (MA) comprising an oscillating reference mirror is designed and built. Compared to our previous systems based on the Michelson and the Linnik interferometer, the MA represents a novel solution that completes the range of possible applications. Due to its advantages, the Mirau setup is the preferred and most frequently used interferometer type in industry. Therefore, the industrial use is ensured by this development. We investigate the functioning of the system and the capability of the vibration compensation by several measurements on various surface topographies.

Long-Exposure RGB Photography with a Fixed Stand for the Measurement of a Trajectory of a Dynamic Impact Device in Real Scale

The present manuscript proposes a novel method for the measurement of a trajectory of a falling impact hammer in the dynamic loading of conveyor belts and the determination of their impact resistance. The proposed method has been experimentally tested and the results of the measurements are presented in this manuscript. The proposed method is based on the long-exposure photography with a long-duration opened shutter of the Nikon D5000 DSLR camera. Results of the experimental research were compared with direct reference measurements performed using the L-GAGE LT3 laser distance sensor. Differences between values, obtained by the new method and by the reference measurements were up to ±3 mm. The standard deviation identified in all the experiments was 1 mm.