Anatomic Reconstruction of the Triangular Fibrocartilage Complex for the Treatment of Chronic Instability of the Distal Radioulnar Joint. A Systematic Review

Introduction Peripheral injuries of the triangular fibrocartilage complex (TFCC) can produce pain and instability of the distal radioulnar joint (DRUJ). There are several techniques for the reconstruction of the TFCC. The aim of the present paper was to summarize the tendon plasties of the DRUJ ligaments for the anatomic reconstruction of TFCC, to analyze the surgical techniques, and to evaluate their outcomes. Methods In order to perform a systematic review, we searched in the literature the terms DRUJ instability OR chronic distal radioulnar joint instability OR distal radioulnar tendon plasty. Results In total, 11 articles with level of evidence IV (case series) were retrieved. Most studies achieved good results, with recovery of wrist stability, improvement of the pain, and increase in grip strength in the functionality tests. In the historical evolution of the published series, wrist surgeons tried to perform a more anatomical plasty, with a more stable fixation and less invasive techniques. Conclusion The Adams procedure continues to be a valid and reproducible technique for the treatment of chronic DRUJ instability. If wrist arthroscopy and implants are available and surgeons have been technically trained, the authors recommend an arthroscopy-assisted technique, or, if possible, an all-arthroscopic TFCC reconstruction with implant fixation of the plasty in its anatomical points of insertion. Comparative studies between open and arthroscopic TFCC reconstruction techniques are needed.

Reconstructive Principles for the Metacarpal Hand: Case Report

Metacarpal hand is one of the most devastating upper-extremity lesions. We report a case of a multidigit amputation corresponding to a Wei et al.5 IA metacarpal hand in a 56 year-old-male. He underwent a sequential toe-to-hand transfer to the third and fourth radii. Reconstruction of the metacarpal hand, either in an acute or deferred presentation, must consider some reconstructive principles, including the identification of the structures to be spared and the coverage strategies for the acute stage. Toe-to-hand transfer is the preferred technique when replantation is not an option. It is critical to know which structures should be transferred to which positions, as well as to adapt the reconstructive plan to the characteristics from each patient.

AMIC Technique for the Treatment of Chondral Injuries of the Hand and Wrist

Scaffolds, either alone or combined with cultured chondrocyte cells, are an effective treatment for chondral or osteochondral defects of the knee and ankle joints.Scaffolds are a more sophisticated solution and have some advantages compared with the isolated use of the more traditional treatments of microfractures or nanofractures.In addition, scaffolds represent a less complicated technique and a less expensive treatment compared with chondrocyte culture treatments, which are accessible by very few patients.In the present article, we detail the surgical technique and provide advices and tips for the treatment of ostecochondral hand and wrist lesions using the Chondro-Gide (Geistlich Pharma AG, Wolhausen, Switzerland) scaffold and its patented autologous matrix-induced chondrogenesis (AMIC, Geistlich Pharma AG) technique.

Four-Corner Fusion with Locking Dorsal Circular Plate versus Headless Compression Screws: A Clinico-Radiological Comparative Study

Introduction Four-corner fusion is a technique for the treatment of carpal advanced collapse. It consists of scaphoid excision and arthrodesis of the lunate, triquetrum, hamate, and capitate bones. This can be accomplished with different kinds of osteosynthesis. In the first reports of the use of a circular plate, poor outcomes are described, with high rates of non-union, which decreased in later studies, which highlight certain aspects of the surgical technique. Objective To report our experience with four-corner fusion with the use of a dorsal locking plate (Xpode, Trimed Inc., Santa Clarita, CA, US), and compare it with another traditional fixation method (3.0-mm headless compression screws [HCSs], Synthes, Slothurn, Switzerland), with an emphasis on union, an assessment of the fincitonal outcomes, and the presence of complications. Material and Methods A comparative study of two prospective series of patients operated on through two fixation techniques for four-corner fusion using autologous bone graft from the iliac crest.The first group of patients, evaluated between 2010 and 2012, underwent osteosynthesis with 2 HCSs, with a minimum follow up of 18 months. The second group, evaluated between 2011 and 2014, underwent osteosynthesis with a dorsal locking plate, with a minimium foloow up of 12 months. The patients were operated on by four different surgeons in four centers.The patients were evaluated with radiographs to establish the presence of union and the time it took to occur. In case of doubt, union was confirmed through a computed tomography (CT) scan at 8 weeks postoperatrively. We also assessed the range of motion, the presence of complications, and function through the Disabilities of the Arm, Shoulder and Hand (DASH) questionnaire and a grip strength score. Results We achieved a union rate of 100% in both groups at similar times. In the dorsal locking plate group, we obtained better full range of motion, particularly in wrist extension, which was statistically significant (p = 0.0016), as well as lower DASH scores, which was also statistically significant (p = 0.0066). Complications were only present in two patients in the HCS group. Conclusion Both techniques are valid and reproducible for the treatment of wrists with scapholunate advanced collapse (SNAC) and scaphoid non-union advanced collapse (SLAC). Based on the outcomes, with the Xpode plate, the patients presented better ranges of motion and DASH scores; therefore it may be an excellent fixation option in the open four-corner fusion surgical technique. The entry point and configuration of the HCS are fundamental variables to analyze.The union rate of 100% obtained in the present study contrasts with the high rates of non-union reported in the literature published in the early 2000s.

Diaphyseal Radius Fracture Associated with Irreducible Head Dislocation. Case Report

Irreducible dislocation of the radial head is an extremely rare lesion, especially in an adult patient. We present a case of diaphyseal radius fracture associated with a posterior elbow dislocation and an irreducible radial head dislocation. After closed reduction of the elbow, we performed open reduction and ostheosynthesis of the radius, and the radial head remained irreducible. We finally found, surrounding the radius, the interposition of the insertion of the biceps, and, after extracting it, we performed the correct reduction of the radial head. Six months after the surgery, the patient presented a full articular balance, with no pain. We have not found any similar case in the literature.

Usefulness of the Ultrasound in Hand Surgery: Part I

In the last years, ultrasonography (US) of the wrist and hand have increased in popularity. Technical advances led us to improve image quality and have the ability to see superficial soft-tissue structures with high resolution with the patient in our office.The advantages of US are the fact that it is noninvasive, its lack of ionising radiation, low cost, and portability. The dynamic real-time assessment in the office is an additional benefit.Ultrasound can be used in hand surgery for both diagnostic and therapeutic purposes. We can use US for injections with needle guidance, for the evaluation of soft-tissue masses, foreign bodies, tendon injuries, compressive neuropathies, and rheumatologic joint disease. It also helps us perform ultrasound-guided procedures: carpal tunnel syndrome, trigger finger, and intersection syndrome or compartimental syndrome.The aim of the present review is to describe different uses of US in hand surgery to show its important role of providing to the surgeon more information on the diseases of their patients.

Percutaneous Dorsal Approach for Fractures of the Hook of the Hamate: A Less Common but Effective Option

Introduction Hook of hamate fractures are rare. The best treatment option is a source of debate; it ranges from conservative to surgical techniques, including resection of the hook or a volar approach followed by internal fixation. These techniques are not exempt from risk. Minimal invasive fixation using a dorsal percutaneous approach and a headless, cannulated mini screw is another option, although not commonly considered. We present a case series of patients who underwent this surgical technique. Methods This is a retrospective review of four patients with nondisplaced hook of hamate fractures treated with dorsal percutaneous fixation. The evaluation included symptoms, physical examination, and radiological (radiographs, magnetic resonance imaging [MRI], and computed tomography [CT]) findings, as well as pre and postoperative strength (determined with a Jamar (JLW Instruments, Chicago, USA) hydraulic dynamometer) and quick disabilities of the arm, shoulder and hand (QuickDASH) scores. Results The union rate was 100% with no associated complications. All patients resumed their preinjury activities 3 months after the surgery and reported they would undergo surgery again if needed. Conclusion This retrospective study shows that safe treatment of nondisplaced hook of hamate fractures with percutaneous dorsal fixation is feasible, with excellent clinical outcomes. In any case, our sample is limited, and further studies are required.

Madelung Deformity: Diagnosis and Treatment Options

Madelung deformity (MD) comprises an increased volar and ulnar tilt of the joint facet of the distal radius, secondary to an idiopathic physeal dysplasia. Such change causes radial shortening and consequent distal ulnar prominence, along with wrist pain and loss of motion. Surgery becomes an option in patients with severe deformity that do not respond to conservative treatment.The classic surgical techniques are problematic for adults, as they are specific for children and adolescents, whose radial physis is still open. Very few papers discuss the treatment of adult patients; furthermore, most are focused on the distal radioulnar joint, and thus do not approach the origin of the pathology.When analyzing computed tomography scans with tridimensional reconstruction, a feature of MD, growth arrest of the volar and ulnar portions of the distal radius, is noted, causing the typical distal radius deformity that leads to lack of coverage of the lunate bone. That leads to palmar subluxation of the lunate bone and consequent radiocarpal instability.We herein describe the possibilities of treatment in different stages of evolution, summarizing the authors' view on MD.

Fifth Metacarpal Neck Fractures: Outcome-influencing Factors

Introduction Fifth metacarpal neck fractures are extremely common, but there is still no consensus regarding the ideal course of treatment.Volar angulation and shortening are decisive factors; however, there is still controversy about the cut-off values that translate into worse clinical results.The present study aims to answer these questions in order to provide additional data to aid in the clinical practice and decision making. Materials and Methods A retrospective study evaluated patients with fifth metacarpal fractures treated between 2013 and 2018. A total of 133 patients were included, with an average follow-up of 2 months. Surgery was performed in 21 patients, and 112 were treated conservatively. The radiological assessment of volar anguation and shortening was based in the first and last radiographs of the follow-up. The patients were contacted and submited to a questionnaire that included the Quick Disabilities of the Arm, Shoulder and Hand (QuickDASH) score and subjective evaluations of pain (Visual Analogue Scale, VAS), hand strength, stiffness and finger mobility, and cosmetic result. Results Surgery was more successful in reducing angulation than the conservative treatment, achieving more anatomic final values for angulation and shortening (p < 0.05). On the other hand, surgery seems to be associated with a higher notion of limited finger mobility (p = 0.02).Among patients treated conservatively, inicial angulations > 60° and final angulations > 50° were associated with worse cosmetic results (p = 0,039). Final shortening > 4 mm translated into a higher notion of stiffness and limited finger mobility (p = 0.034).More advanced age showed a correlation with higher scores on the VAS (p = 0.023) and QuickDASH (p < 0,001). Female patients (p = 0.02) were also associated with higher VAS scores. The overall satisfaction rate was of 97%. Conclusion Although globally the functional outcome of these fractures is very good, the present study reports several factors that should be considered when treating fifth metacarpal neck fractures.