scholarly journals Determination of the platelet structure in natural diamond by ADF-STEM

Author(s):  
Svetlana Korneychuk ◽  
Stuart Turner ◽  
Artem Abakumov ◽  
Johan Verbeeck
2020 ◽  
Vol 6 (12) ◽  
pp. 125630
Author(s):  
Guangfeng Shi ◽  
Wang Fu ◽  
Shukun Wang ◽  
Dongdong Han ◽  
Min Chen ◽  
...  

1985 ◽  
Vol 52 (5) ◽  
pp. 623-641 ◽  
Author(s):  
P. Humble ◽  
D. F. Lynch ◽  
A. Olsen

1994 ◽  
Vol 356 ◽  
Author(s):  
Sandrine Bec ◽  
André Tonck ◽  
Jean-Luc Loubet

AbstractUltra thin films (50 nm and 180 nm) of amorphous diamond-like carbon on a silicon substrate produced by laser ablation are tested by nanoindentation with a new instrument deriving from a Surface Force Apparatus. Quasi-static measurements of the load and dynamic measurements of the contact stiffness are continuously and simultaneously recorded versus the penetration depth. Scanning lines on the tested surface before and after indentation are made by means of tangential displacement of the diamond indenter on the surface.The tests are conducted with maximum loads from 50 μN to 2500 μN, which correspond to maximum indentation depths between 7 nm and 70 nm. The indentation curves show near elastic recovery but scanning lines and/or topographic images on the surfaces show detectable plastic prints. Despite the extremely small residual indentation depths for these ultra thin films, we show how the hardness value we calculate from the indentation curves with an elastoplastic theory is in good agreement with the hardness value we calculate from the indentation print profile. The determination of the Young's modulus, even at the smallest indentation depths, must take into account the mechanical properties of the substrate. The determination of both values, hardness and elastic modulus, also requires a calibration procedure for the geometry of the tip and knowledge of the piling-up effect.We find that the apparent hardness and the apparent Young's modulus of the tested diamondlike films are high. They are underestimated in comparison with the real values. A rough correction which overestimates the Young’s modulus gives higher values than those of natural diamond.


1966 ◽  
Vol 25 ◽  
pp. 93-97
Author(s):  
Richard Woolley

It is now possible to determine proper motions of high-velocity objects in such a way as to obtain with some accuracy the velocity vector relevant to the Sun. If a potential field of the Galaxy is assumed, one can compute an actual orbit. A determination of the velocity of the globular clusterωCentauri has recently been completed at Greenwich, and it is found that the orbit is strongly retrograde in the Galaxy. Similar calculations may be made, though with less certainty, in the case of RR Lyrae variable stars.


1999 ◽  
Vol 190 ◽  
pp. 549-554
Author(s):  
Nino Panagia

Using the new reductions of the IUE light curves by Sonneborn et al. (1997) and an extensive set of HST images of SN 1987A we have repeated and improved Panagia et al. (1991) analysis to obtain a better determination of the distance to the supernova. In this way we have derived an absolute size of the ringRabs= (6.23 ± 0.08) x 1017cm and an angular sizeR″ = 808 ± 17 mas, which give a distance to the supernovad(SN1987A) = 51.4 ± 1.2 kpc and a distance modulusm–M(SN1987A) = 18.55 ± 0.05. Allowing for a displacement of SN 1987A position relative to the LMC center, the distance to the barycenter of the Large Magellanic Cloud is also estimated to bed(LMC) = 52.0±1.3 kpc, which corresponds to a distance modulus ofm–M(LMC) = 18.58±0.05.


1961 ◽  
Vol 13 ◽  
pp. 29-41
Author(s):  
Wm. Markowitz
Keyword(s):  

A symposium on the future of the International Latitude Service (I. L. S.) is to be held in Helsinki in July 1960. My report for the symposium consists of two parts. Part I, denoded (Mk I) was published [1] earlier in 1960 under the title “Latitude and Longitude, and the Secular Motion of the Pole”. Part II is the present paper, denoded (Mk II).


1972 ◽  
Vol 1 ◽  
pp. 27-38
Author(s):  
J. Hers

In South Africa the modern outlook towards time may be said to have started in 1948. Both the two major observatories, The Royal Observatory in Cape Town and the Union Observatory (now known as the Republic Observatory) in Johannesburg had, of course, been involved in the astronomical determination of time almost from their inception, and the Johannesburg Observatory has been responsible for the official time of South Africa since 1908. However the pendulum clocks then in use could not be relied on to provide an accuracy better than about 1/10 second, which was of the same order as that of the astronomical observations. It is doubtful if much use was made of even this limited accuracy outside the two observatories, and although there may – occasionally have been a demand for more accurate time, it was certainly not voiced.


2000 ◽  
Vol 179 ◽  
pp. 205-208
Author(s):  
Pavel Ambrož ◽  
Alfred Schroll

AbstractPrecise measurements of heliographic position of solar filaments were used for determination of the proper motion of solar filaments on the time-scale of days. The filaments have a tendency to make a shaking or waving of the external structure and to make a general movement of whole filament body, coinciding with the transport of the magnetic flux in the photosphere. The velocity scatter of individual measured points is about one order higher than the accuracy of measurements.


1975 ◽  
Vol 26 ◽  
pp. 341-380 ◽  
Author(s):  
R. J. Anderle ◽  
M. C. Tanenbaum

AbstractObservations of artificial earth satellites provide a means of establishing an.origin, orientation, scale and control points for a coordinate system. Neither existing data nor future data are likely to provide significant information on the .001 angle between the axis of angular momentum and axis of rotation. Existing data have provided data to about .01 accuracy on the pole position and to possibly a meter on the origin of the system and for control points. The longitude origin is essentially arbitrary. While these accuracies permit acquisition of useful data on tides and polar motion through dynamio analyses, they are inadequate for determination of crustal motion or significant improvement in polar motion. The limitations arise from gravity, drag and radiation forces on the satellites as well as from instrument errors. Improvements in laser equipment and the launch of the dense LAGEOS satellite in an orbit high enough to suppress significant gravity and drag errors will permit determination of crustal motion and more accurate, higher frequency, polar motion. However, the reference frame for the results is likely to be an average reference frame defined by the observing stations, resulting in significant corrections to be determined for effects of changes in station configuration and data losses.


Sign in / Sign up

Export Citation Format

Share Document