Effect of volume ratio of acetonitrile to water on the morphology and property of polypyrrole prepared by chemical oxidation method

2012 ◽  
Vol 52 (7) ◽  
pp. 1600-1605 ◽  
Author(s):  
Zhenhao Huang ◽  
Shuchun Hu ◽  
Nan Zhang ◽  
Xiaolang Chen ◽  
Dan Chen ◽  
...  
Author(s):  
Shohei Kawamoto ◽  
Kosuke Koyano ◽  
Miyo Ozaki ◽  
Takeshi Arai ◽  
Takashi Iwase ◽  
...  

Background Direct-reacting bilirubin concentrations measured using vanadate chemical oxidation method do not exactly match the conjugated bilirubin concentration. One of the causes is the effect of bilirubin photoisomers. However, the quantitative evaluation of the effects of these photoisomers has not been sufficiently conducted. In particular, the influence of bilirubin configurational isomers on direct bilirubin is the most critical factor. Methods Sixteen residual serum samples were used. For quantitative analysis based on the change in direct bilirubin and bilirubin configurational isomer, samples were irradiated via blue light-emitting diodes to suppress the production of bilirubin structural isomers. Total bilirubin and direct bilirubin concentrations were measured using the vanadate chemical oxidation method. Concentrations of 4Z,15Z-bilirubin IXα and its photoisomers were measured using high-performance liquid chromatography. The sum of 4Z,15E-bilirubin IXα and 4E,15Z-bilirubin IXα was notated as bilirubin configurational isomer, and the differences between the measured values of the irradiated and non-irradiated samples were calculated and notated as ΔDB and ΔBCI. Results In non-irradiated and irradiated samples, total bilirubin and direct bilirubin concentrations were 10.73 mg/dL with significant a decrease to 10.60 mg/dL and 0.69 mg/dL with a significant increase to 0.78 mg/dL, while bilirubin configurational isomer values were 1.00 mg/dL and 1.52 mg/dL, respectively. The linear regression equation revealed a significant positive correlation of Y = 0.187X−0.006 between ΔDB (Y) and ΔBCI (X). Conclusion Applying the vanadate chemical oxidation method affected approximately 19% of the bilirubin configurational isomer concentration for direct bilirubin. Extreme caution is necessary when interpreting the measured values of samples indicative of unconjugated hyperbilirubinaemia.


2020 ◽  
Vol 4 (2) ◽  

In the present work NiO/ZnO was synthesized from combustion method, polyaniline and the polyaniline based NiO/ZnO using chemical oxidation method. The synthesized materials were characterized using XRD and UV/Vis absorbance spectroscopy. From XRD, the formation of NiO/ZnO was confirmed. The study investigates the applicability of NiO/ZnO Nanocomposite as photo catalyst for the degradation of organic dyes. Results suggested an increase in degradation efficiency in the case of polymer nanocomposite when compared to counter parts.


Author(s):  
Munish Pandey ◽  
Richa Badlani

In polymerization of was carried out in the presence of to synthesize – composites by chemical oxidation method. The / have been synthesized with various compositions (10, 15, 20, 25 and 30 ) of in in aquas medium at room temperature. The – composites were characterized by infrared spectroscopy (IR). The d.c. conductivity was studied in the temperature range from 40–100°C. The dimensions of in the matrix have a greater influence on the observed conductivity values.


2015 ◽  
Vol 1094 ◽  
pp. 61-67
Author(s):  
Guo Jiang Zhou ◽  
Xiao Tong Feng ◽  
Guang Chao Lv

The sulfur-free exfoliated graphite(EG) was prepared by chemical oxidation method using the mixture of HClO4 and CH3COOH as reaction medium, the 100 orders natural flake graphite(NG) as raw material, and KMnO4 as oxidant. The effects of influence factors on the exfoliation volume(EV) were analyzed by single factor experiments and orthogonal experiments, the structure of NG and EG were characterized by X-ray diffraction. Results show that the optimum preparation conditions were as follows: graphite(g): KMnO4(g): the mixed acid (mL) = 1:0.35:4, HClO4 (mL):CH3COOH (mL) = 3:1, reaction temperature at 35°C for 90 minutes, the maximum EV of up to 500mL/g. The influence factors are governed the descending order: the volume ratio of HClO4 :CH3COOH, reaction temperature, the dosage of mixed acid, the dosage of KMnO4, reaction time.


RSC Advances ◽  
2018 ◽  
Vol 8 (32) ◽  
pp. 17950-17957 ◽  
Author(s):  
Guolong Yuan ◽  
Junan Pan ◽  
Yaguang Zhang ◽  
Junxi Yu ◽  
Yanjia He ◽  
...  

The cathode composite materials for lithium sulfur batteries with a stable network structure consisting of natural sepiolite powders, carbon nanotubes and conductive polymer were synthesized by vacuum heat treatment and chemical oxidation method.


2020 ◽  
Vol 718 ◽  
pp. 137390 ◽  
Author(s):  
Benjuan Liu ◽  
Qi Liu ◽  
Xiaojie Wang ◽  
Qicheng Bei ◽  
Yanhui Zhang ◽  
...  

RSC Advances ◽  
2016 ◽  
Vol 6 (30) ◽  
pp. 25449-25459 ◽  
Author(s):  
Mohd Hanief Najar ◽  
Kowsar Majid

Charge transport across a potential barrier is important in determining the properties of many devices ranging from solar cells to the production of H2.


Sign in / Sign up

Export Citation Format

Share Document