Strain Hardening and Annealing

1996 ◽  
pp. 67-74
Author(s):  
Donald R. Askeland
Keyword(s):  
Strain Hardening

SELECTION OF THE DRIVE OF THE PULSE GENERATOR FOR WAVE DEFORMATION HARDENING

2020 ◽  
Author(s):  
Andrey Kirichek ◽  
Dmitriy Solovyev
Keyword(s):  
Strain Hardening ◽  
Pulse Generator ◽  
Surface Plastic Deformation ◽  
Surface Plastic ◽  
Impact Frequency ◽  
Metal Consumption ◽  
Pulse Generators ◽  
Energy Impact ◽  
Deformation Hardening ◽  
Selection Of

The article is devoted to the analysis of known structures of impact devices used in industry in order to obtain recommendations for their adaptation or when creating new structures for wave strain hardening by surface plastic deformation. The analysis was carried out on the used drive and on the main parameters of impact devices: impact energy, impact frequency, relative metal consumption and efficiency. The options are the best combinations of parameters for electric, pneumatic and hydraulic drives. Recommendations are given on the use of such devices, with appropriate adaptation, as pulse generators for wave strain hardening.

MANUFACTURE INVESTIGATION OF CARTRIDGE WITH BOTTOM-MOST PART FLANGE BY DIRECT EXTRUSION WITH COUNTERPUNCH. REPORT 18. EXPERIMENTAL CHECK OF THEORETICAL RESULTS FOR DIFFERENT HOLLOW RADIUSES AND BOTTOM-MOST PART THICKNESSES

2020 ◽  
Vol 0 (9) ◽  
pp. 16-23
Author(s):  
A. L. Vorontsov ◽  
◽  
I. A. Nikiforov ◽  
Keyword(s):  
Strain Hardening ◽  
Theoretical Calculations ◽  
High Accuracy ◽  
Geometric Parameters ◽  
Strength Characteristics ◽  
Experimental Check ◽  
Hardening Material ◽  
Direct Extrusion ◽  
Theoretical Results

The results of an experimental check of the obtained theoretical formulae allowing us to determine the most important parameters of extrusion cartridges with a counterpunch for different hollow radiuses and bottom-most part thicknesses are presented. Characteristics of used tools, geometric parameters of extrusion experiments, strength characteristics of deformed materials and lubricants are described in detail. Both strain-hardening material and strain-unhardening material were studied. Methodology of the theoretical calculations is demonstrated in detail. High accuracy of the obtained design formulae was confirmed.

Effect of diamond burnishing parameters on the state of the processed surface layer of billets made of high-strength "30ХГСН2А-ВД" steel

2020 ◽  
pp. 82-86
Author(s):  
A.N. Shvetsov ◽  
D.L. Skuratov
Keyword(s):  
Surface Layer ◽  
Residual Stresses ◽  
Strain Hardening ◽  
Processing Speed ◽  
Synthetic Diamond ◽  
High Strength ◽  
The State ◽  
Diamond Burnishing

The influence of the burnishing force, tool radius, processing speed and feed on the distribution of circumferential and axial residual strses, microhardness and the depth of strain hardening in the surface layer when pr ssing of "30ХГСН2А-ВД" steel with synthetic diamond "ACB-1" is considered. Empirical dependencies determining these parameters are given. Keywords diamond burnishing, strain hardening depth, circumferential residual stresses, axial residual stresses, microhardness. [email protected], [email protected]

Sign in / Sign up

Export Citation Format

Share Document