Alloy Surface Behavior: Experimental Methods and Results

1992 ◽  
pp. 199-217
Author(s):  
T. M. Buck
Keyword(s):  
Experimental Methods ◽  
Alloy Surface ◽  
Surface Behavior

ANALISIS VARIASI JUMLAH SUDU TURBIN BERPENAMPANG PELAT DATAR PADA TURBIN AIR ALIRAN VORTEX DENGAN TIPE SALURAN MASUK INVOLUTE

2020 ◽  
Vol 7 (2) ◽  
pp. 72-78
Author(s):  
Adnan Al Farisi ◽  
Yopi Handoyo ◽  
Taufiqur Rokhman
Keyword(s):  
Power Plant ◽  
Alternative Energy ◽  
Vortex Flow ◽  
Experimental Methods ◽  
Turbine Efficiency ◽  
A Value ◽  
Current Voltage ◽  
Materials Research ◽  
The One ◽  
Flow Vortex

The One of alternative energy that is environmentally friendly is by untilize water energy and turn it into a Microhydro power plant. Microhydro power plant usually made from utilize the waterfall with the head fell. While utilization for streams with a head small drop is not optimal yet. This is a reference to doing research on harnessing the flow of a river that has a value of head low between 0.7 m – 1.4 m with turning it into a Vortex flow (vortex). The purpose of this research is to know  the effect variation number of blade on power and efficiency in the vortex turbine. This research uses experimental methods to find current, voltage, torque and rpm using a reading instrument. The materials research vortex turbine used 6 blade, 8 blade and 10 blade with flat plate. The result showed the highest efficiency is 29,93 % with produce turbine power is 19,58 W, generated on turbine with variation 10 blade with load 3,315 kg and the capacity of water 10,14 l/s. Followed with an efficiency 24,17% and produce turbine power is 15,81 W, generated on turbine with the variation 8 blade with load 3,315 kg and the capacity of water is 10,14 l/s. The the lowest turbine efficiency 22,32% with produce tuebine power 14,60 W, generated on turbine with the variation 6 blade with load 3,315 kg, the capacity of water is 10,14 l/s.

Utilisation of High-Energy Heat Sources in Magnesium Alloy Surface Layer Treatment

2013 ◽  
Vol 58 (2) ◽  
pp. 619-624 ◽  
Author(s):  
M. Szafarska ◽  
J. Iwaszko ◽  
K. Kudła ◽  
I. Łegowik
Keyword(s):  
Surface Layer ◽  
Magnesium Alloy ◽  
Physicochemical Properties ◽  
Treatment Effectiveness ◽  
High Energy ◽  
Alloy Surface ◽  
Heat Sources ◽  
X Ray ◽  
Additional Equipment ◽  
Alloy Surface Layer

The main aim of the study was the evaluation of magnesium alloy surface treatment effectiveness using high-energy heat sources, i.e. a Yb-YAG Disk Laser and the GTAW method. The AZ91 and AM60 commercial magnesium alloys were subject to surface layer modification. Because of the physicochemical properties of the materials studied in case of the GTAW method, it was necessary to provide the welding stand with additional equipment. A novel two-torch set with torches operating in tandem was developed within the experiment. The effectiveness of specimen remelting using a laser and the GTAW method was verified based on macro- and microscopic examinations as well as in X-ray phase analysis and hardness measurements. In addition, the remelting parameters were optimised. The proposed treatment methodology enabled the achieving of the intended result and effective modification of a magnesium alloy surface layer.

Lateral Adsorbate Interactions Inhibit HCOO- While Promoting CO Selectivity for CO2 Electrocatalysis on Ag

2018 ◽  
Author(s):  
Divya Bohra ◽  
Isis Ledezma-Yanez ◽  
Guanna Li ◽  
Wiebren De Jong ◽  
Evgeny A. Pidko ◽  
...  
Keyword(s):  
Electrochemical Reduction ◽  
Experimental Approach ◽  
Decisive Role ◽  
Experimental Methods ◽  
Reaction Intermediates ◽  
Intermediate Species ◽  
Experimental Knowledge ◽  
Complex Interactions ◽  
Ag Catalysts

<p>The analysis presented in this manuscript helps bridge an important fundamental discrepancy between the existing theoretical and experimental knowledge regarding the performance of Ag catalysts for CO<sub>2</sub> electrochemical reduction (CO<sub>2</sub>ER). The results demonstrate how the intermediate species *OCHO is formed readily en-route the HCOO<sup>– </sup>pathway and plays a decisive role in determining selectivity of a predominantly CO producing catalyst such as Ag. Our theoretical and experimental approach develops a better understanding of the nature of competition as well as the complex interactions between the reaction intermediates leading to CO, HCOO<sup>–</sup> and H<sub>2</sub> during CO<sub>2</sub>ER.</p><p><br></p><p>Details of computational and experimental methods are present in the Supporting Information provided. </p><p><br></p><p><br></p>

Sign in / Sign up

Export Citation Format

Share Document