Static Electrical Conductivity at the Droplet-Lamella Phase Transition of a Water-in-Oil Microemulsion

Author(s):  
C. Cametti ◽  
P. Codastefano ◽  
P. Tartaglia ◽  
S.-H. Chen ◽  
J. Rouch
Crystals ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 746
Author(s):  
Meiling Hong ◽  
Lidong Dai ◽  
Haiying Hu ◽  
Xinyu Zhang

A series of investigations on the structural, vibrational, and electrical transport characterizations for Ga2Se3 were conducted up to 40.2 GPa under different hydrostatic environments by virtue of Raman scattering, electrical conductivity, high-resolution transmission electron microscopy, and atomic force microscopy. Upon compression, Ga2Se3 underwent a phase transformation from the zinc-blende to NaCl-type structure at 10.6 GPa under non-hydrostatic conditions, which was manifested by the disappearance of an A mode and the noticeable discontinuities in the pressure-dependent Raman full width at half maximum (FWHMs) and electrical conductivity. Further increasing the pressure to 18.8 GPa, the semiconductor-to-metal phase transition occurred in Ga2Se3, which was evidenced by the high-pressure variable-temperature electrical conductivity measurements. However, the higher structural transition pressure point of 13.2 GPa was detected for Ga2Se3 under hydrostatic conditions, which was possibly related to the protective influence of the pressure medium. Upon decompression, the phase transformation and metallization were found to be reversible but existed in the large pressure hysteresis effect under different hydrostatic environments. Systematic research on the high-pressure structural and electrical transport properties for Ga2Se3 would be helpful to further explore the crystal structure evolution and electrical transport properties for other A2B3-type compounds.


NANO ◽  
2017 ◽  
Vol 12 (04) ◽  
pp. 1750045
Author(s):  
Jun-Xing Pan ◽  
Yu-Qi Guo ◽  
Yu-Fang Han ◽  
Min-Na Sun ◽  
Jin-Jun Zhang

Computer simulation is carried out for investigating the effect of nanoparticles on diblock copolymer morphology under cylindrical confinement. The phase diagrams of polymer nanocomposites with nanoparticle-block wetting strength and concentration of nanoparticles are obtained in different nanopores. In small diameter nanopore, there is almost no influence of nanoparticles on the diblock copolymer morphology because of the stronger confinement effect; in middle diameter nanopore, the system can self-assemble into various novel structures due to the interaction between confinement effect and nanoparticles effect; in large diameter nanopore, due to the stronger effect of nanoparticles, a disorder-order-disorder phase transition occurs with the wetting strength and concentration of nanoparticles increasing. This result can be useful in designing new nanocomposites with advanced electrical conductivity and/or mechanical strength.


2018 ◽  
Vol 60 (9) ◽  
pp. 1656
Author(s):  
А.И. Наджафов ◽  
Н.А. Алиева ◽  
К.Г. Халилова

AbstractThe complex methods of the physicochemical analysis are used to study TlGaTe_2–Te and TlInTe_2–Te alloys in which the tellurium solubility region up to 5.0 at % is observed. The temperature dependences of the lattice parameters and the electrical conductivity of TlGaTe_2 + x and TlInTe_2 + x have been studied in different crystallographic directions. The TlGaTe_2 + x and TlInTe_2 + x solid solutions undergo a phase transition at a temperature of 498 K. The transition nature is interpreted.


Crystals ◽  
2020 ◽  
Vol 10 (2) ◽  
pp. 75 ◽  
Author(s):  
Linfei Yang ◽  
Lidong Dai ◽  
Heping Li ◽  
Haiying Hu ◽  
Meiling Hong ◽  
...  

The phase stability of epsomite under a high temperature and high pressure were explored through Raman spectroscopy and electrical conductivity measurements in a diamond anvil cell up to ~623 K and ~12.8 GPa. Our results verified that the epsomite underwent a pressure-induced phase transition at ~5.1 GPa and room temperature, which was well characterized by the change in the pressure dependence of Raman vibrational modes and electrical conductivity. The dehydration process of the epsomite under high pressure was monitored by the variation in the sulfate tetrahedra and hydroxyl modes. At a representative pressure point of ~1.3 GPa, it was found the epsomite (MgSO4·7H2O) started to dehydrate at ~343 K, by forming hexahydrite (MgSO4·6H2O), and then further transformed into magnesium sulfate trihydrate (MgSO4·3H2O) and anhydrous magnesium sulfate (MgSO4) at higher temperatures of 373 and 473 K, respectively. Furthermore, the established P-T phase diagram revealed a positive relationship between the dehydration temperature and the pressure for epsomite.


1983 ◽  
Vol 38 (5) ◽  
pp. 593-594 ◽  
Author(s):  
W. D. Basler ◽  
I. V. Murin ◽  
S. V. Chernov

The diffusion of fluorine in KSn2F5 has been studied by T1 and T2 relaxation time measurements of 19F NMR (200-500 K) and pulsed magnetic Field gradient tech­niques (390-480 K). Near 423 K a sharp transition into the superionic state has been found, the fluorine diffusion increasing by a factor of 4 within a range of 3 K. Conduc­tivity measurements only show a change in the activation energy.


Sign in / Sign up

Export Citation Format

Share Document