Structural and Magnetic Properties of Nanosized Half-Doped Rare-Earth Ho0.5Ca0.5MnO3 Manganite

We investigated the structural and magnetic properties of 20 nm-sized nanoparticles of the half-doped manganite Ho0.5Ca0.5MnO3 prepared by sol-gel approach. Neutron powder diffraction patterns show Pbnm orthorhombic symmetry for 10 K < T < 290 K, with lattice parameters a, b, and c in the relationship c/√2 < a < b, indicating a cooperative Jahn–Teller effect, i.e., orbital ordering OO, from below room temperature. In contrast with the bulk samples, in the interval 250 < T < 300 K, the fingerprint of charge ordering (CO) does not manifest itself in the temperature dependence of lattice parameters. However, there are signs of CO in the temperature dependence of magnetization. Accordingly, below 100 K superlattice magnetic Bragg reflections arise, which are consistent with an antiferromagnetic phase strictly related to the bulk Mn ordering of a charge exchange-type (CE-type), but characterized by an increased fraction of ferromagnetic couplings between manganese species themselves. Our results show that in this narrow band half-doped manganite, size reduction only modifies the balance between the Anderson superexchange and Zener double exchange interactions, without destabilizing an overall very robust antiferromagnetic state.

Influence of Molybdenum on the Microstructure, Mechanical Properties and Corrosion Resistance of Ti20Ta20Nb20(ZrHf)20−xMox (Where: x = 0, 5, 10, 15, 20) High Entropy Alloys

The presented work was focused on investigating the influence of the (hafnium and zirconium)/molybdenum ratio on the microstructure and properties of Ti20Ta20Nb20(ZrHf)20−xMox (where: x = 0, 5, 10, 15, 20 at.%) high entropy alloys in an as-cast state. The designed chemical composition was chosen due to possible future biomedical applications. Materials were obtained from elemental powders by vacuum arc melting technique. Phase analysis revealed the presence of dual body-centered cubic phases. X-ray diffraction showed the decrease of lattice parameters of both phases with increasing molybdenum concentration up to 10% of molybdenum and further increase of lattice parameters. The presence of two-phase matrix microstructure and hafnium and zirconium precipitates was proved by scanning and transmission electron microscopy observation. Mechanical property measurements revealed decreased micro- and nanohardness and reduced Young’s modulus up to 10% of Mo content, and further increased up to 20% of molybdenum addition. Additionally, corrosion resistance measurements in Ringers’ solution confirmed the high biomedical ability of studied alloys due to the presence of stable oxide layers.

The Effect of Substituting Ga for Alon Crystal Structure of Phosphors MAl 2Si2O8: Eu2+ (M= Ca, Sr, Ba)

A series of luminescence phosphors M0.955Al2 –xGaxSi2O8∶Eu2+ (M=Ca, Sr, Ba, x = 0~1.0) were prepared via solid-state reaction in weak reductive atmosphere. The lattice positions were discussed. It was found that when Ga3+ entered MAl2Si2O8 lattice and substituted Al3+, complete solid solutions formed. The lattice parameters (a, b, c) and unit cell volume of phosphors M 0.955Al2 –xGaxSi2O8: Eu2+ (M=Ca, Sr, Ba, x = 0~1.0) increased linearly, the lattice parameters (α, β,γ) of Ca0.955Al2–xGaxSi2O8∶Eu2+(CAS) decreased linearly and the lattice parameter β of Sr0.955Al2–xGaxSi2O8∶Eu2+(SAS) and Ba0.955Al2–xGaxSi2O8∶Eu2+(BAS) increased linearly as Ga3+ content increased.

Atom species energy dependence on magnetic configurations in the perovskite yttrium orthoferrite

The article represents the results of studying of the influence of atom species in the perovskite multiferroic yttrium orthoferrite YFeO3 on magnetic configurations by ab-initio methods. Four magnetic configurations possible in magnetic sublattice that were formed by iron atoms were analyzed. It is shown that different magnetic orderings change the lattice parameters and the ions occupied positions while preserving symmetry of the unit cell, the lowest state responds G-AFM type magnetic ordering. The lattice parameters are in good relevant published experimental data. The atom species energy dependence shows that the main role in magnetic properties goes to iron and oxygen. In the ground state, magnetic properties relate with Dzyaloshinskii – Moriya interaction, while in other configurations, these relate with superexchange through Fe- O-Fe chains. Obtained results are useful for analyzing and designing straintronics devices. Also, the results can be interesting for interpretation and predicting magnetic properties of partially or fully substituted orthoferrites including substitution on rare-earth elements.

Lattice Parameters, Electronic, and Magnetic Properties of Cubic Perovskite Oxides ARuO3 (A=Sr, Rb): A First‑Principles Study

Trioxides of rubidium, strontium, and ruthenium belong to the family of alkali and alkaline earth ruthenates. SrRuO3 crystallizes in various symmetry classes—orthorhombic, tetragonal, or cubic—whereas RbRuO3 is perovskite (cubic) structured and crystallizes only in the cubic space group Pm3¯¯¯m(No. 221). In this study, we investigated the structural stability as well as the electronic and magnetic properties of two cubic perovskites SrRuO3 and RbRuO3. We established the corresponding lattice parameters, magnetic moments, density of states (DOS), and band structures using ab‑initio density‑functional theory (DFT). Both compounds exhibited a metallic ferromagnetic ground state with lattice parameter values between 3.83 and 3.96 Å; RbRuO3 had magnetic moments between 0.29 and 0.34 µBwhereas SrRuO3 had magnetic moments between 1.33 and 1.66 µB. This study paves way for further RbRuO3 research.

Correlating the Voltage Hysteresis in Li- and Mn-Rich Layered Oxides to Reversible Structural Changes by Using X-ray and Neutron Powder Diffraction

Li- and Mn-rich layered oxides (LMR-NCMs) are promising cathode active materials (CAMs) in future lithium-ion batteries (LIBs) due to their high energy density. However, the material undergoes a unique open circuit voltage (OCV) hysteresis between charge and discharge after activation, which compromises its roundtrip energy efficiency and affects the thermal management requirements for an LIB system. The hysteresis is believed to be caused by transition metal (TM) migration and/or by oxygen redox activities. Using in-situ X-ray powder diffraction (XPD), we monitor the lattice parameters of over-lithiated NCMs during the initial cycles and show that also the lattice parameters feature a distinct path dependence. When correlated to the OCV instead of the state of charge (SOC), this hysteresis vanishes for the unit cell volume and gives a linear correlation that is identical for different degrees of over-lithiation. We further aimed at elucidating the role of TM migration on the hysteresis phenomena by applying joint Rietveld refinements to a series of ex-situ XPD and neutron powder diffraction (NPD) samples. We critically discuss the limitations of this approach and compare the results with DFT simulations, showing that the quantification of TM migration in LMR-NCMs by diffraction is not as straightforward as often believed.

Structural, Electronic and Magnetic Properties of Mn2Co1-xVxZ (Z = Ga, Al) Heusler Alloys: An Insight from DFT Study

Structural, electronic, and magnetic properties of Mn2Co1-xVxZ (Z = Ga, Al, x = 0, 0.25, 0.5, 0.75, 1) Heusler alloys were theoretically investigated for the case of L21 (space group Fm3¯m), L21b (L21 structure with partial disordering between Co and Mn atoms) and XA (space group F4¯3m) structures. It was found that the XA structure is more stable at low V concentrations, while the L21 structure is energetically favorable at high V concentrations. A transition from L21 to XA ordering occurs near x = 0.5, which qualitatively agrees with the experimental results. Comparison of the energies of the L21b and XA structures leads to the fact that the phase transition between these structures occurs at x = 0.25, which is in excellent agreement with the experimental data. The lattice parameters linearly change as x grows. For the L21 structure, a slight decrease in the lattice constant a was observed, while for the XA structure, an increase in a was found. The experimentally observed nonlinear behavior of the lattice parameters with a change in the V content is most likely a manifestation of the presence of a mixture of phases. Almost complete compensation of the magnetic moment was achieved for the Mn2Co1-xVxZ alloy (Z = Ga, Al) at x = 0.5 for XA ordering. In the case of the L21 ordering, it is necessary to consider a partial disorder of atoms in the Mn and Co sublattices in order to achieve compensation of the magnetic moment.

Automated prediction of lattice parameters from X-ray powder diffraction patterns

A key step in the analysis of powder X-ray diffraction (PXRD) data is the accurate determination of unit-cell lattice parameters. This step often requires significant human intervention and is a bottleneck that hinders efforts towards automated analysis. This work develops a series of one-dimensional convolutional neural networks (1D-CNNs) trained to provide lattice parameter estimates for each crystal system. A mean absolute percentage error of approximately 10% is achieved for each crystal system, which corresponds to a 100- to 1000-fold reduction in lattice parameter search space volume. The models learn from nearly one million crystal structures contained within the Inorganic Crystal Structure Database and the Cambridge Structural Database and, due to the nature of these two complimentary databases, the models generalize well across chemistries. A key component of this work is a systematic analysis of the effect of different realistic experimental non-idealities on model performance. It is found that the addition of impurity phases, baseline noise and peak broadening present the greatest challenges to learning, while zero-offset error and random intensity modulations have little effect. However, appropriate data modification schemes can be used to bolster model performance and yield reasonable predictions, even for data which simulate realistic experimental non-idealities. In order to obtain accurate results, a new approach is introduced which uses the initial machine learning estimates with existing iterative whole-pattern refinement schemes to tackle automated unit-cell solution.

PHASE EQUILIBRIUM IN THE INAS2SE4 -INAS2SSE3 AND PROPERTIES OF THE FORMED PHASES

The character of the interaction in the InAs2Se4 -InAs2SSe3 system was investigated and its phase diagram was constructed by DTA, XRD, MSA, as well as by measuring the microhardness and determining the density of the alloys. It was found that the InAs2Se4 -InAs2SSe3 section is a quasi-binary section of the In-As-S-Se quaternary system. Solid solutions based on InAs2Se4 at room temperature reach 10 mol % InAs2SSe3, and on the basis of InAs2SSe3 it extends to 15 mol % InAs2Se4. The lattice parameters are calculated from the region of solid solutions based on InAs2Se4 and InAs2SSe3.