Computational Investigations of Varying Solidity LP Turbine Cascade with Gurney Flap for Low Reynolds Numbers

2020 ◽  
pp. 105-117
Author(s):  
G. S. Srivatsa ◽  
Gajanan Tatpatti
Keyword(s):  
Reynolds Numbers ◽  
Turbine Cascade ◽  
Low Reynolds Numbers ◽  
Gurney Flap ◽  
Low Reynolds ◽  
Lp Turbine

Actuated Transition in an LP Turbine Laminar Separation: An Experimental Approach

2011 ◽  
Author(s):  
Jenny Baumann ◽  
Ulrich Rist ◽  
Martin Rose ◽  
Tobias Ries ◽  
Stephan Staudacher
Keyword(s):  
Boundary Layer ◽  
Separation Bubble ◽  
Turbine Blades ◽  
Reynolds Numbers ◽  
Experimental Investigations ◽  
Stream Velocity ◽  
Laminar Separation ◽  
Low Reynolds Numbers ◽  
Low Reynolds ◽  
Lp Turbine

The reduction of blade counts in the LP turbine is one possibility to cut down weight and therewith costs. At low Reynolds numbers the suction side laminar boundary layer of high lift LP turbine blades tends to separate and hence cause losses in turbine performance. To limit these losses, the control of laminar separation bubbles has been the subject of many studies in recent years. A project is underway at the University of Stuttgart that aims to suppress laminar separation at low Reynolds numbers (60,000) by means of actuated transition. In an experiment a separating flow is influenced by disturbances, small in amplitude and of a certain frequency, which are introduced upstream of the separation point. Small existing disturbances are therewith amplified, leading to earlier transition and a more stable boundary layer. The separation bubble thus gets smaller without need of a high air mass flow as for steady blowing or pulsed vortex generating jets. Frequency and amplitude are the parameters of actuation. The non-dimensional actuation frequency is varied from 0.2 to 0.5, whereas the normalized amplitude is altered between 5, 10 and 25% of the free stream velocity. Experimental investigations are made by means of PIV and hot wire measurements. Disturbed flow fields will be compared to an undisturbed one. The effectiveness of the presented boundary layer control will be compared to those of conventional ones. Phase-logged data will give an impression of the physical processes in the actuated flow.

scholarly journals Simulation of flow over high-lifted turbine cascade at low Reynolds numbers

2021 ◽  
Vol 1891 (1) ◽  
pp. 012018
Author(s):  
A P Duben ◽  
T K Kozubskaya ◽  
O V Marakueva ◽  
D V Voroshnin
Keyword(s):  
Reynolds Numbers ◽  
Turbine Cascade ◽  
Low Reynolds Numbers ◽  
Low Reynolds

Investigation on the effect of leading edge tubercles of sweptback wing at low reynolds number

2020 ◽  
Vol 21 (6) ◽  
pp. 621
Author(s):  
Veerapathiran Thangaraj Gopinathan ◽  
John Bruce Ralphin Rose ◽  
Mohanram Surya
Keyword(s):  
Leading Edge ◽  
Reynolds Numbers ◽  
Sweep Angle ◽  
Laminar Separation ◽  
Low Reynolds Numbers ◽  
Flow Energy ◽  
Airplane Wing ◽  
Low Reynolds ◽  
Naca 0015 ◽  
Wing Performance

Aerodynamic efficiency of an airplane wing can be improved either by increasing its lift generation tendency or by reducing the drag. Recently, Bio-inspired designs have been received greater attention for the geometric modifications of airplane wings. One of the bio-inspired designs contains sinusoidal Humpback Whale (HW) tubercles, i.e., protuberances exist at the wing leading edge (LE). The tubercles have excellent flow control characteristics at low Reynolds numbers. The present work describes about the effect of tubercles on swept back wing performance at various Angle of Attack (AoA). NACA 0015 and NACA 4415 airfoils are used for swept back wing design with sweep angle about 30°. The modified wings (HUMP 0015 A, HUMP 0015 B, HUMP 4415 A, HUMP 4415 B) are designed with two amplitude to wavelength ratios (η) of 0.1 & 0.24 for the performance analysis. It is a novel effort to analyze the tubercle vortices along the span that induce additional flow energy especially, behind the tubercles peak and trough region. Subsequently, Co-efficient of Lift (CL), Co-efficient of Drag (CD) and boundary layer pressure gradients also predicted for modified and baseline (smooth LE) models in the pre & post-stall regimes. It was observed that the tubercles increase the performance of swept back wings by the enhanced CL/CD ratio in the pre-stall AoA region. Interestingly, the flow separation region behind the centerline of tubercles and formation of Laminar Separation Bubbles (LSB) were asymmetric because of the sweep.

Low Reynolds number flow around and heat transfer from a heated circular cylinder

2010 ◽  
Vol 1 (1-2) ◽  
pp. 15-20 ◽  
Author(s):  
B. Bolló
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Lift Coefficient ◽  
Reynolds Numbers ◽  
Low Reynolds Numbers ◽  
Reynolds Number Flow ◽  
Two Dimensional Flow ◽  
Number Flow ◽  
Low Reynolds ◽  
Increasing Temperature

Abstract The two-dimensional flow around a stationary heated circular cylinder at low Reynolds numbers of 50 < Re < 210 is investigated numerically using the FLUENT commercial software package. The dimensionless vortex shedding frequency (St) reduces with increasing temperature at a given Reynolds number. The effective temperature concept was used and St-Re data were successfully transformed to the St-Reeff curve. Comparisons include root-mean-square values of the lift coefficient and Nusselt number. The results agree well with available data in the literature.

Experimental and Numerical Determination of Micropropulsion Device Efficiencies at Low Reynolds Numbers

2004 ◽  
Author(s):  
Andrew D. Ketsdever ◽  
Michael T. Clabough ◽  
Sergey F. Gimelshein ◽  
Alina Alexeenko
Keyword(s):  
Reynolds Numbers ◽  
Numerical Determination ◽  
Low Reynolds Numbers ◽  
Low Reynolds
Sign in / Sign up

Export Citation Format

Share Document