Minimizing the modulus of the reflection coefficient of a polychromatic wave from an inhomogeneous absorbing layer

1977 ◽  
Vol 17 (3) ◽  
pp. 435-439
Author(s):  
I. L. Dorot ◽  
M. M. Machevariani
Keyword(s):  
Reflection Coefficient ◽  
Absorbing Layer

The method of determining the metrological performance of unit reference standards of reflection coefficient in waveguides at millimeter waves

2020 ◽  
pp. 59-63
Author(s):  
A.S. Bondarenko ◽  
A.S. Borovkov ◽  
I.M. Malay ◽  
V.A. Semyonov
Keyword(s):  
Reflection Coefficient ◽  
Millimeter Waves ◽  
Primary Standard ◽  
Reference Standards ◽  
Measurement Scale ◽  
Current State ◽  
Coefficient Measurement ◽  
Mathematical Equations ◽  
Electrodynamic Modeling ◽  
Metrological Performance

The analysis of the current state of the reflection coefficient measurements in waveguides at millimeter waves is carried out. An approach for solving the problem of reproducing the reflection coefficient measurement scale is proposed. Mathematical equations, which are the basis of the reflection coefficient measurement equation are obtained. The method of determining the metrological performance of reflection coefficient unit’s reference standards is developed. The results of electrodynamic modeling and analytical calculations by the developed method are compared. It is shown that this method can be used for reproducing the reflection coefficient unit in the development of the State primary standard.

REFLECTION COEFFICIENT OF AN ELECTROMAGNETIC WAVE IN CONDUCTIVE MEDIA

2018 ◽  
pp. 100-106
Author(s):  
M. S. Sudakova ◽  
M. L. Vladov ◽  
M. R. Sadurtdinov
Keyword(s):  
Reflection Coefficient ◽  
Ground Penetrating Radar ◽  
Electromagnetic Waves ◽  
Water Contamination ◽  
Survey Design ◽  
Direct And Inverse Problems ◽  
The Difference ◽  
Ground Penetrating ◽  
Ideal Dielectric

Within the ground penetrating radar bandwidth the medium is considered to be an ideal dielectric, which is not always true. Electromagnetic waves reflection coefficient conductivity dependence showed a significant role of the difference in conductivity in reflection strength. It was confirmed by physical modeling. Conductivity of geological media should be taken into account when solving direct and inverse problems, survey design planning, etc. Ground penetrating radar can be used to solve the problem of mapping of halocline or determine water contamination.

Dual Band Paper Substrate CPW Antenna for Wireless Applications

2019 ◽  
Vol 8 (9S3) ◽  
pp. 605-608
Keyword(s):  
Reflection Coefficient ◽  
Mobile Communication ◽  
Coplanar Waveguide ◽  
Dual Band ◽  
Antenna Feed ◽  
Paper Substrate ◽  
Frequency Bands ◽  
Wireless Applications

In this paper, a 15* 80 sized antenna is designed over a paper substrate to test its flexible properties. The proposed antenna feed by a grounded coplanar waveguide(GCPW) is stimulated and the measured results show the operating Dual Band of the antenna cover(3.34-3.62 GHz) and (5.92-6.24 GHz) with the reflection coefficient |S11|< -15dB.These frequency bands operate over SHF bands and hence supports Fixed Mobile Communication and WLAN applications.

Nanocomposite Graphene based Tunable Absorber for Combating Electromagnetic Pollution

2019 ◽  
Vol 15 ◽  
Author(s):  
Surekha Rani ◽  
Anupma Marwaha ◽  
Sanjay Marwaha
Keyword(s):  
Reflection Coefficient ◽  
Traffic Congestion ◽  
Microwave Absorber ◽  
Electromagnetic Properties ◽  
Electric Conductor ◽  
High Frequency Structure Simulator ◽  
Bias Potential ◽  
External Bias ◽  
Tunable Microwave ◽  
Tunable Absorber

Background: Advancement in wireless communication technology has raised today’s living standards but consequently leads to the problems of electromagnetic (EM) air pollution as well as spectrum congestion particularly in radio frequency band. To overcome traffic congestion problem in lower bands, terahertz frequency bands are explored but EM pollution still persists as global issue which can be addressed by a tunable microwave absorber. At THz frequencies, 2-D nanostructured graphene has been observed to be less lossy than using other materials and further finds its most interesting applications on account of the plasmonic mode supported by graphene resulting in extreme device miniaturization. At micro and mm-waves graphene is resistive hence can be electronically controlled, ensuring its suitability for the design of tunable microwave absorber. Objective: Designing of a frequency reconfigurable or frequency tunable absorber is the prime objective of current work. Two-dimensional graphene absorber has been proposed here having inherent bandgap tunability property which means the electromagnetic properties of graphene can be controlled via varying external bias potential. Methods: The numerical modelling of graphene microwave absorber utilizing bulk graphene backed by glass and perfect electric conductor layer is reported in this paper. Finite element Method (FEM) based high frequency structure simulator (HFSS) platform is used to simulate the graphene absorber model. The whole structure is placed into a rectangular waveguide with two ports for absorber excitation. Results: The variation of electromagnetic properties of graphene absorber is achieved by changing bias potential and further the absorption tunability for the designed absorber is investigated in the range from 2 GHz to 18 GHz. From reflection coefficient curves, it is authenticated that -72.6 dB reflection coefficient dip has been obtained at 14 GHz for 5 volt bias potential which shifts to higher side of frequency as the potential changes from 5 volts to 25 volts. Conclusion: The results show that by increasing bias potential, absorption coefficient shifts to higher frequency and proves to be a tunable wideband absorber whose resonant frequency can changed from one value to another without changing thickness or material properties of absorber thus can effectively incorporate with antenna substrate or surface of radar.

Sign in / Sign up

Export Citation Format

Share Document