Dielectric properties of pure and Mn-doped CaCu3Ti4O12 ceramics over a wide temperature range

2016 ◽  
Vol 36 (1-4) ◽  
pp. 46-57 ◽  
Author(s):  
ChunChang Wang ◽  
Wei Ni ◽  
Da Zhang ◽  
Xiaohong Sun ◽  
Jing Wang ◽  
...  
2000 ◽  
Vol 15 (6) ◽  
pp. 1342-1348 ◽  
Author(s):  
Liqin Zhou ◽  
P. M. Vilarinho ◽  
P. Q. Mantas ◽  
J. L. Baptista

The dielectric properties of Mn-doped Pb(Fe2/3W1/3)1−xMnxO3 (x = 0, 0.001, 0.003, and 0.005) in the temperature range 200–600 K were investigated. Two sets of dielectric peaks, located at 200–350 K and 350–600 K, were observed. The intensity of the dielectric permittivity and loss factor peaks for both relaxations decreased with the increase in the Mn content and no peak occurred when x = 0.005. Nonlinear current–voltage (I–V) behavior was observed in the samples containing less than 0.005Mn. The activation energy values for the relaxations at 200–350 K and at 350–600 K were around 0.42 and 0.56 eV, respectively. The direct current conduction activation energies were around 0.41 eV. Nitrogen annealing eliminated the relaxation peaks at 200–350 K while oxygen annealing enhanced them. Both annealings eliminated the dielectric peaks at 350–600 K. The nonlinear I–V characteristic tended to vanish either after the oxygen or the nitrogen annealing treatments. Relaxation mechanisms are proposed and discussed. It is suggested that the relaxation at 200–350 K is related to electron hole while the relaxation at 350–600 K is attributed to microstructure-dependent space-charge polarization.


2008 ◽  
Vol 55-57 ◽  
pp. 885-888 ◽  
Author(s):  
Uraiwan Intatha ◽  
K. Sathitada ◽  
Sukum Eitssayeam ◽  
Kamonpan Pengpat ◽  
Gobwute Rujijanagul ◽  
...  

BaFe0.5Nb0.5O3 (BFN) exhibits very high dielectric constant over a wide temperature range. However, these materials normally require high-temperature sintering to achieve a maximum densification. The aim of this study is to determine the effect of potassium fluoride salt on the sintering and dielectric properties of BFN ceramics. The results show that KF additive lower the sintering temperature by 100-200°C without affecting the formation of BFN phase. Ceramics doped with 1% KF show optimum densities of about 95% of the theoretical value when sintered at 1300°C. The addition of fluoride salt in the BFN ceramics causes very broad dielectric constant curves over a wide temperature range indicating the diffuse phase transition characteristic. Furthermore, this addition also reduces in the dielectric loss when compared with pure BFN ceramics


RSC Advances ◽  
2016 ◽  
Vol 6 (29) ◽  
pp. 24518-24526 ◽  
Author(s):  
Bowen Zhang ◽  
Lingxia Li

In this paper, the micro-mechanism in a (1 − x)BaTiO3–xBi(Zn2/3Nb1/3)O3–0.01NaNbO3 system, benefiting the realization of ultra-wide temperature range stability, was proposed and applied to study the dielectric properties.


2015 ◽  
Vol 41 (10) ◽  
pp. 14773-14779 ◽  
Author(s):  
Haibo Li ◽  
Chunchang Wang ◽  
Hong Wang ◽  
Da Zhang ◽  
Nan Zhang

RSC Advances ◽  
2021 ◽  
Vol 11 (38) ◽  
pp. 23228-23234
Author(s):  
Hailong Pan ◽  
Jiangshui Luo ◽  
Bing Li ◽  
Michael Wübbenhorst

Phase-dependent dielectric properties and proton conduction of neopentyl glycol (NPG) are studied systematically over a wide temperature range via broadband dielectric spectroscopy.


Author(s):  
Jinpeng Li ◽  
Junhao Jiang ◽  
Qilin Cheng ◽  
Zhong-Kai Cui ◽  
Xiaoyun Liu ◽  
...  

Polymeric dielectrics with high-temperature resilience are of critical importance in developing advanced electrostatic capacitors. Poly-(p-phenylene benzobisoxazole) (PBO) is a polymer with excellent thermal stability. However, the poor processability and low...


2019 ◽  
Vol 45 (14) ◽  
pp. 16842-16847 ◽  
Author(s):  
Zhiyong Liu ◽  
An Zhang ◽  
Xinhui Geng ◽  
Jinshan Lu ◽  
Yuqing Mao ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document