The effect of an amplitude-modulated high-frequency magnetic field on the low-frequency noise of an amorphous ferromagnetic sensor

2012 ◽  
Vol 55 (6) ◽  
pp. 702-705 ◽  
Author(s):  
O. L. Sokol-Kutylovsky
Keyword(s):  
Magnetic Field ◽  
High Frequency ◽  
Low Frequency ◽  
Frequency Noise ◽  
Low Frequency Noise ◽  
Frequency Magnetic Field ◽  
High Frequency Magnetic Field

scholarly journals ANALYSIS OF HIGH-FREQUENCY C-CORE MAGNETIC FLUX LEAKAGES FOR BONE TUMOR WITH INDUCTION HEATING BY USING MULTI-COIL

2019 ◽  
Author(s):  
Metharak Jokpudsa ◽  
Supawat Kotchapradit ◽  
Chanchai Thongsopa ◽  
Thanaset Thosdeekoraphat
Keyword(s):  
Magnetic Field ◽  
High Frequency ◽  
Tumor Tissue ◽  
Low Frequency ◽  
Heat Energy ◽  
High Frequencies ◽  
Frequency Magnetic Field ◽  
High Frequency Magnetic Field ◽  
The Magnetic Field ◽  
Flux Leakage

High-frequency magnetic field has been developed pervasively. The induction of heat from the magnetic field can help to treat tumor tissue to a certain extent. Normally, treatment by the low-frequency magnetic field needed to be combined with magnetic substances. To assist in the induction of magnetic fields and reduce flux leakage. However, there are studies that have found that high frequencies can cause heat to tumor tissue. In this paper present, a new magnetic application will focus on the analysis of the high-frequency magnetic nickel core with multi-coil. In order to focus the heat energy using a high-frequency magnetic field into the tumor tissue. The magnetic coil was excited by 915 MHz signal and the combination of tissues used are muscle, bone, and tumor. The magnetic power on the heating predicted by the analytical model, the power loss density (2.98e-6 w/m3) was analyzed using the CST microwave studio.

Aerodynamic noise from an asymmetric airfoil with perforated extension plates at the trailing edge

2020 ◽  
pp. 1475472X2097838
Author(s):  
CK Sumesh ◽  
TJS Jothi
Keyword(s):  
High Frequency ◽  
Sound Pressure ◽  
Pore Diameter ◽  
Low Frequency ◽  
Aerodynamic Noise ◽  
Frequency Noise ◽  
Low Frequency Noise ◽  
Trailing Edge ◽  
High Frequency Noise ◽  
Displacement Thickness

This paper investigates the noise emissions from NACA 6412 asymmetric airfoil with different perforated extension plates at the trailing edge. The length of the extension plate is 10 mm, and the pore diameters ( D) considered for the study are in the range of 0.689 to 1.665 mm. The experiments are carried out in the flow velocity ( U∞) range of 20 to 45 m/s, and geometric angles of attack ( αg) values of −10° to +10°. Perforated extensions have an overwhelming response in reducing the low frequency noise (<1.5 kHz), and a reduction of up to 6 dB is observed with an increase in the pore diameter. Contrastingly, the higher frequency noise (>4 kHz) is observed to increase with an increase in the pore diameter. The dominant reduction in the low frequency noise for perforated model airfoils is within the Strouhal number (based on the displacement thickness) of 0.11. The overall sound pressure levels of perforated model airfoils are observed to reduce by a maximum of 2 dB compared to the base airfoil. Finally, by varying the geometric angle of attack from −10° to +10°, the lower frequency noise is seen to increase, while the high frequency noise is observed to decrease.

scholarly journals Acoustic measures of low-frequency noise in extended high-frequency audiometry

2007 ◽  
Vol 121 (3) ◽  
pp. EL120-EL124 ◽  
Author(s):  
Nicolas Schmuziger ◽  
Matthias Brechbuehl ◽  
Rudolf Probst
Keyword(s):  
High Frequency ◽  
Low Frequency ◽  
Frequency Noise ◽  
Low Frequency Noise ◽  
Acoustic Measures ◽  
High Frequency Audiometry

Motion behavior of non-metallic particles under high frequency magnetic field

2009 ◽  
Vol 19 (3) ◽  
pp. 674-680 ◽  
Author(s):  
Zhong-tao ZHANG ◽  
Qing-tao GUO ◽  
Feng-yun YU ◽  
Jie LI ◽  
Jian ZHANG ◽  
...  
Keyword(s):  
Magnetic Field ◽  
High Frequency ◽  
Metallic Particles ◽  
Frequency Magnetic Field ◽  
High Frequency Magnetic Field ◽  
Motion Behavior

High frequency magnetic field sensors based on the Faraday effect in garnet thick films

1992 ◽  
Vol 60 (17) ◽  
pp. 2048-2050 ◽  
Author(s):  
R. Wolfe ◽  
E. M. Gyorgy ◽  
R. A. Lieberman ◽  
V. J. Fratello ◽  
S. J. Licht ◽  
...  
Keyword(s):  
Magnetic Field ◽  
High Frequency ◽  
Faraday Effect ◽  
Thick Films ◽  
Magnetic Field Sensors ◽  
Frequency Magnetic Field ◽  
High Frequency Magnetic Field

scholarly journals Low-Frequency Noise Evaluation on a Commercial Magnetoimpedance Sensor at Submillihertz Frequencies for Space Magnetic Field Detection

Sensors ◽  
2019 ◽  
Vol 19 (22) ◽  
pp. 4888
Author(s):  
Tao Wang ◽  
Chen Kang ◽  
Guozhi Chai
Keyword(s):  
Magnetic Field ◽  
Low Frequency ◽  
Temperature Stability ◽  
Space Missions ◽  
Low Noise ◽  
Integration Time ◽  
Frequency Noise ◽  
Low Frequency Noise ◽  
Field Detection ◽  
Measurement Limit

The purpose of this study was to measure the low-frequency noise and basic performance of a commercial magnetoimpedance (MI) sensor at sub-millihertz frequencies for use in space missions. Normally, space missions require measuring very weak magnetic fields with a long integration time, such as the space gravitational wave detection mission requiring sub-millihertz frequencies. We set up a platform for measuring the performance on this MI sensor, including low-frequency noise, measurement limit, linearity, and temperature stability. The results show that the low-frequency noise of the MI sensor is below 10 nT/√Hz at 1 mHz and below 100 nT/√Hz at 0.1 mHz; its measurement limit is 600 pT. The MI sensor is characterized by high precision, small size, and low noise, demonstrating considerable potential for application in magnetically sensitive experiments requiring long integration time. This is an effect way to solve the problem that there is on one suitable magnetic sensor at space magnetic field detection, but the sensor requires improvements in temperature stability.

Sign in / Sign up

Export Citation Format

Share Document