Sludge Particle Size and Correlation with Soluble Organic Matter and Conditioning Characteristics After Freezing Treatments

2019 ◽  
Vol 230 (3) ◽  
Author(s):  
M. Carrasco ◽  
W. Gao
2009 ◽  
Vol 59 (2) ◽  
pp. 289-293 ◽  
Author(s):  
C. H. Wu ◽  
C. Y. Kuo ◽  
S. L. Lo

Heavy metals were removed from industrial sludge by traditional and microwave-assisted acid extraction approaches. The effects of acid concentration, extraction time, sludge particle size and solid/liquid (S/L) ratio on copper-extraction efficiency were assessed. Leaching with increased acid concentrations increased the yield of heavy metals from the industrial sludge. In microwave-assisted acid extraction, reducing the S/L ratio and sludge particle size increased copper-extraction efficiency. These experimental findings indicate that S/L ratio most strongly influenced microwave-assisted acid extraction. Both traditional and microwave-assisted acid extraction demonstrate that sulfuric acid was an effective extractant, and the copper fraction in extracted sludge shifted from being primarily bound to Fe–Mn oxides and organic-matter partition, to being mostly bound to organic matter, remaining as a residue during acid extraction.


1984 ◽  
Vol 19 (1) ◽  
pp. 27-36 ◽  
Author(s):  
Alena Mudroch

Abstract Surface sediment samples obtained at the offshore and nearshore area of Lake Erie were separated into eight different size fractions ranging from <2 µm to 250 µm. The concentration of major elements (Si, Al, Ca, Mg, K, Na, Fe, Mn and P), metals (Zn, Cu, Cr, Ni, V, Co and Pb) and organic matter was determined together with the mineralogical composition and morphology of the particles in each size fraction. The distribution of the metals in the offshore sediment was bimodal with the majority of the metals divided between the 63 to 250 um size fraction which also contained the highest concentration of organic matter (about 20%) and the <4 µm fraction containing up to 60% of clay minerals. However, the metals in the nearshore sediment were associated mainly with the clay minerals.


1997 ◽  
Vol 35 (8) ◽  
pp. 83-90
Author(s):  
Shigeo Fujii ◽  
Chiaki Niwa ◽  
Mitsuo Mouri ◽  
Ranjna Jindal

Applicability of the rock-bed filtration technique was investigated through pilot-plant experiments in Bangkok, Thailand. Polluted canal water was used as horizontal flow influent to two reactor channels filled with rocks. During one year operation, HRT, filter media, and aeration mode, were changed in several runs. The results showed that 1) the rock-bed filtration with aeration and the HRT more than 6 h can successfully improve polluted klong water by reducing the pollutants (e.g. 60-120mg/L of SS to 20-40 mg/L and 15-30 mg/L of BOD to 5-20 mg/L); 2) main removal mechanism seems to be the sedimentation resulting from the settleability enhanced by aeration, and the biofilm attached onto rocks also works in the reduction of soluble organic matter; 3) a combination of three rock sizes arranged in descending order showed best results; 4) longer HRT (13 h) produces better effluent but is not so effective if it exceeds 9 hours; 5) 60-70% of sediment IL was decomposed in a year, and porosity in rock beds reduced approximately 16%.


2012 ◽  
Vol 38 (1) ◽  
pp. 40-42 ◽  
Author(s):  
O. A. Gutorova ◽  
A. Kh. Sheudzhen ◽  
A. G. Ladatko

Sign in / Sign up

Export Citation Format

Share Document