Performance evaluation of a continuous flow photocatalytic reactor for wastewater treatment

2014 ◽  
Vol 21 (21) ◽  
pp. 12505-12517 ◽  
Author(s):  
Mohammad Rezaei ◽  
Fariborz rashidi ◽  
Sayed Javid Royaee ◽  
Morteza Jafarikojour
Keyword(s):  
Wastewater Treatment ◽  
Performance Evaluation ◽  
Continuous Flow ◽  
Photocatalytic Reactor

Facile Preparation of P-25 Films Dip-Coated Nickel Foam and High Photocatalytic Activity for the Degradation of Quinoline and Industrial Wastewater

2011 ◽  
Vol 9 (1) ◽  
Author(s):  
Suiyi Zhu ◽  
Xia Yang ◽  
Gu-Ning Wang ◽  
Lei-Lei Zhang ◽  
He-Feng Zhu ◽  
...  
Keyword(s):  
Photocatalytic Activity ◽  
Aqueous Solutions ◽  
Specific Surface ◽  
Continuous Flow ◽  
Industrial Wastewater ◽  
Nickel Foam ◽  
High Photocatalytic Activity ◽  
Photocatalytic Reactor ◽  
X Ray ◽  
Three Phase

A kind of P-25 TiO2 films coated nickel foam was synthesized by a facile dip-coating/calcination route, and used to fabricate a continuous-flow three-phase photocatalytic reactor. The morphology, crystal phase structure, surface composition and specific surface area of P-25 films coated nickel foam were investigated by field emission scanning electron microscope (FE-SEM), X-ray diffractometer (XRD), X-ray photoelectron spectroscopy (XPS) and nitrogen adsorption-desorption measurements, respectively. The results indicated that the coated/ calcined P-25 films had the porous surface structure fabricated by nano-sized titanium dioxide consisted of two crystal phases and incorporated with a NiO interlayer. The increase of P-25 contents enhanced the specific surface area; however, 20 percent of initial P-25 sol would result in visible large cracks because of too high P-25 content and consequently cause the peeling of films. The photocatalytic activities of nickel foam with different coating amounts of P-25 for the degradation of quinoline aqueous solutions were investigated with a continuous-flow three-phase photocatalytic reactor based on the P-25 films coated nickel foam. The results suggested that nickel foam coated with 10 percent of P-25 sol had an optimal photocatalytic activity for the degradation of quinoline aqueous solutions. The continuous-flow three-phase photocatalytic reactor fabricated with P-25 films coated nickel foam with an optimal P-25 coating amount shows high photocatalytic activity and stability for the degradation of quinoline aqueous solutions and industrial wastewater. The treated industrial wastewater meets the international discharge standard.

Simple Fabrication of a Continuous-Flow Photocatalytic Reactor Using Dopamine-Assisted Immobilization onto a Fluoropolymer Tubing

2022 ◽  
Author(s):  
Chetsada Khositanon ◽  
Siwada Deepracha ◽  
Suttichai Assabumrungrat ◽  
Makoto Ogawa ◽  
Nopphon Weeranoppanant
Keyword(s):  
Continuous Flow ◽  
Photocatalytic Reactor

scholarly journals Investigation of the Efficiency of Phosphorus Removal Using Anionic Resins From the Continuous Flow in the Waste Stabilization Pond Outlet: A Case Study of Kaboodrahang Wastewater Treatment Plant

2019 ◽  
Vol 6 (1) ◽  
pp. 16-20
Author(s):  
Ali Akbar Rahmani Sarmazdeh ◽  
Mostafa Leili
Keyword(s):  
Wastewater Treatment ◽  
Wastewater Treatment Plant ◽  
Phosphorus Removal ◽  
Continuous Flow ◽  
Removal Rate ◽  
Treatment Plant ◽  
Oxygen Demand ◽  
Cold Season ◽  
Stabilization Pond ◽  
The Mean

This research mainly aimed to investigate phosphorus removal from stabilization pond effluent by using anionic resins in the continuous flow mode of operation due to high amounts of phosphorus in the wastewater treatment plant effluent of Kaboodrahang, western Iran, as well as the violation from a prescribed effluent standard to discharge receiving the surface waters. For this purpose, the pilot was made of a plexiglass cylinder and other equipment such as pump and other accessories, as well as Purolite A-100 resin. The reactor effects on the desired study parameters were assessed in two warm and cold seasons. The results showed that the phosphorus concentrations reduced from 7-10 mg/L to 4-7 mg/L and the rate of phosphorus removal was higher in the hot season compared to the cold season. Moreover, the optimum temperature and pH were obtained 21ºC and 8.5, respectively. The mean inlet biological oxygen demand (BOD) was 150 mg/L for both warm and cold seasons, where the highest removal rate of 17% was obtained in the cold season. The mean chemical oxygen demand concentration of the pilot was 250 mg/L for both seasons, and the highest removal rate was observed in the cold season with an efficiency of 18%. Regarding the total suspended solids with the mean inlet of 230 mg/L, the highest removal efficiency was obtained 6% in the warm season.

scholarly journals Wastewater treatment in flow photobioreactors continuous illuminated by artificial and solar light

2020 ◽  
Vol 9 (6) ◽  
pp. e183963748
Author(s):  
Rafael Souza Leopoldino Nascimento ◽  
Ludymyla Marcelle Lima Silva ◽  
Lucas Periard ◽  
Anibal da Fonseca Santiago
Keyword(s):  
Organic Matter ◽  
Wastewater Treatment ◽  
Chemical Oxygen Demand ◽  
Continuous Flow ◽  
Suspended Solids ◽  
Oxygen Demand ◽  
Total Suspended Solids ◽  
Operational Stability ◽  
Artificial Light ◽  
Light Emitting

The technology of microalgae photobioreactors and illuminated by LEDs has been widely studied for the treatment of wastewater. However, sunlight is a free resource and should be taken advantage of. But the question remains whether photobioreactors illuminated by natural (sunlight) light in combination with artificial light can have greater operational stability or greater performance when compared to systems illuminated only by artificial light. In this context, continuous flow photobioreactors illuminated by Light Emitting Diodes (LEDs) combined, or not, with sunlight were operated and had their performance evaluated. The variables analyzed were pH, OD, chemical oxygen demand (COD), chlorophyll - a and total suspended solids. The photobioreactors were effective for removing organic matter, with 75 ± 15% in the photobioreactor illuminated by LED and 65 ± 10% in the photobioreactor illuminated by sunlight and LED. The results showed that the use of combined lighting favors the production of dissolved oxygen and ensures greater operational stability in the removal of carbonaceous organic matter.

Sign in / Sign up

Export Citation Format

Share Document