scholarly journals On the effects of pore water pressure buildup and dissipation on the seismic performance of a propped r.c. diaphragm wall in sand

2020 ◽  
Author(s):  
Kateryna Oliynyk ◽  
Nicola Pontani ◽  
Claudio Tamagnini

AbstractThe study concerns the analysis of a retaining structure composed by a couple of r.c. diaphragm walls propped at the crest in loose and medium-dense, variably saturated sand under seismic conditions. Fully coupled dynamic equilibrium conditions and pore water flow in the porous soil have been taken into account, in order to assess the effects that the development and subsequent dissipation of excess pore water pressures can have on the performance of such structures under seismic conditions. To this end, a series of simulations in which the saturated soil permeability is varied of about two orders of magnitude has been carried out, in order to consider different evolution rates for the dynamic consolidation process. The von Wolffersdorff hypoplastic model and the van Genuchten water retention equation have been used to describe the mechanical and hydraulic behavior of the sand. The results obtained in a large series of finite element simulations show a significant dependence of the seismic performance of the structure evaluated in terms of permanent rotations and structural loads, in view of the modern performance-based design criteria on the excess pore pressures buildup during the seismic shaking and on its dissipation with time. For the particular seismic input considered, neither fully drained nor fully undrained conditions can be considered applicable in most of the cases considered. In such conditions, the quantitative assessment of wall and soil displacements, pore water pressures and effective stress distributions within the soil requires necessarily the solution of a fully coupled, nonlinear dynamic consolidation problem.

2019 ◽  
Vol 2019 ◽  
pp. 1-9 ◽  
Author(s):  
Wei Huang ◽  
Kejun Wen ◽  
Dongsheng Li ◽  
Xiaojia Deng ◽  
Lin Li ◽  
...  

The unloading creep behavior of soft soil under lateral unloading stress path and excess pore water pressure is the core problem of time-dependent analysis of surrounding rock deformation under excavation of soft soil. The soft soil in Shenzhen, China, was selected in this study. The triaxial unloading creep tests of soft soil under different initial excess pore water pressures (0, 20, 40, and 60 kPa) were conducted with the K0 consolidation and lateral unloading stress paths. The results show that the unloading creep of soft soil was divided into three stages: attenuation creep, constant velocity creep, and accelerated creep. The duration of creep failure is approximately 5 to 30 mins. The unloading creep behavior of soft soil is significantly affected by the deviatoric stress and time. The nonlinearity of unloading creep of soft soil is gradually enhanced with the increase of the deviatoric stress and time. The initial excess pore water pressure has an obvious weakening effect on the unloading creep of soft soil. Under the same deviatoric stress, the unloading creep of soft soil is more significant with the increase of initial excess pore water pressure. Under undrained conditions, the excess pore water pressure generally decreases during the lateral unloading process and drops sharply at the moment of unloading creep damage. The pore water pressure coefficients during the unloading process were 0.73–1.16, 0.26–1.08, and 0.35–0.96, respectively, corresponding to the initial excess pore water pressures of 20, 40, and 60 kPa.


2011 ◽  
Vol 243-249 ◽  
pp. 3306-3310 ◽  
Author(s):  
Hong Bo Zhang ◽  
Xiu Guang Song ◽  
Hong Hong Wang ◽  
Zheng Ma

The dynamic consolidation method has been used widely in various engineering domain. With this method, the velocity of reconsolidation settlement was enhanced, the consolidation result was good, and the cost was lower than other methods. However, in the flooded area of Yellow River, the groundwater level is higher, and the shallow saturated silty soil liquefaction will be happened with this single method of dynamic consolidation. It goes against the roadbed stability. According to engineering practice, the vacuum dewatering with lower energy dynamic consolidation method was proposed in this paper. In order to monitor the effect of this consolidation method, the water-level observation hole, pore water pressure gauge, standard guide pile, level gauge have been set up. They could be used to get the groundwater level, the excess pore water pressure, horizontal displacement and land subsidence, respectively. These monitors would last the whole period of the consolidation experiment. Field test results shows that the excess pore water pressure was reduced by 80%-90% during one to three days.


2006 ◽  
Vol 43 (6) ◽  
pp. 638-652 ◽  
Author(s):  
Zhen Fang ◽  
Jian-Hua Yin

In this study, a small-scale physical model with full instrumentation was set up and used to measure the full consolidation process of a cylinder of clay with one prefabricated vertical drain (PVD) in its middle. The model test produced several interesting phenomena: (i) a delayed pore-water pressure increase under a constant pressure during loading stages, (ii) a delayed pore-water pressure decrease under a constant pressure during unloading stages, and (iii) residual excess pore-water pressures at the end of loading. Two analytical solutions accounting for the well resistance and a smear zone with reduced permeability are used to calculate the variation of average excess pore-water pressure with time, and these are compared with the measured variation. The well resistance of the PVD has a larger influence on the consolidation process than the permeability of the smear zone, especially during the latter stages of consolidation. The analytical solutions are able to show the influence of the well resistance of the PVD strip, but they cannot satisfactorily simulate the pattern of the residual excess pore-water pressure with time.Key words: consolidation, vertical drain, marine clay, physical modelling.


1980 ◽  
Vol 17 (2) ◽  
pp. 225-235 ◽  
Author(s):  
J. H. A. Crooks ◽  
E. L. Matyas ◽  
H. M. McKay

High excess pore-water pressures were measured within a confined stratum of loose silt underlying an excavation slope during pile-driving operations at the slope toe.The range of observed pore-water pressure increase with distance is generally in excess of previously published data. This is attributed to a combination of factors including superposition of increments of excess pore-water pressures generated during driving of individual piles within a group, redistribution of excess pore-water pressures with time, the effect of soil displacement in a confined loose silt layer, and the greater disturbance associated with driving batter piles as opposed to vertical piles. A further contributing factor was considered to be the increase in pore-water pressures due to small straining within the silt layer.Because of uncertainty regarding the accuracy of pore-water pressure predictions and the presence of deformation-sensitive services at the slope crest, the observational approach was adopted during construction.Based on the results of stability analyses using observed pore-water pressures in the field, the construction procedures were modified to maintain an adequate factor of safety and to minimize slope deformation. It was recognized that the method of analysis may have been conservative because changes in total stresses along potential failure surfaces were not taken into account.


2016 ◽  
Vol 53 (9) ◽  
pp. 1460-1473 ◽  
Author(s):  
Dharma Wijewickreme ◽  
Achala Soysa

The cyclic shear response of soils is commonly examined using undrained (or constant-volume) laboratory element tests conducted using triaxial and direct simple shear (DSS) devices. The cyclic resistance ratio (CRR) from these tests is expressed in terms of the number of cycles of loading to reach unacceptable performance that is defined in terms of the attainment of a certain excess pore-water pressure and (or) strain level. While strain accumulation is generally commensurate with excess pore-water pressure, the definition of unacceptable performance in laboratory tests based purely on cyclic strain criteria is not robust. The shear stiffness is a more fundamental parameter in describing engineering performance than the excess pore-water pressure alone or shear strain alone; so far, no criterion has considered shear stiffness to determine CRR. Data from cyclic DSS tests indicate consistent differences inherent in the patterns between the stress–strain loops at initial and later stages of cyclic loading; instead of relatively “smooth” stress–strain loops in the initial parts of loading, nonsmooth changes in incremental stiffness showing “kinks” are notable in the stress–strain loops at large strains. The point of pattern change in a stress–strain loop provides a meaningful basis to determine the CRR (based on unacceptable performance) in cyclic shear tests.


2011 ◽  
Vol 261-263 ◽  
pp. 1534-1538
Author(s):  
Yu Guo Zhang ◽  
Ya Dong Bian ◽  
Kang He Xie

The consolidation of the composite ground under non-uniformly distributed initial excess pore water pressure along depth was studied in two models which respectively considering both the radial and vertical flows in granular column and the vertical flow only in granular column, and the corresponding analytical solutions of the two models were presented and compared with each other. It shows that the distribution of initial excess pore water pressure has obvious influence on the consolidation of the composite ground with single drainage boundary, and the rate of consolidation considering the radial-vertical flow in granular column is faster than that considering the vertical flow only in granular column.


2012 ◽  
Vol 193-194 ◽  
pp. 1010-1013
Author(s):  
Shu Qing Zhao

The construct to precast pile in thick clayey soil can cause the accumulation of excess pore water pressure. The high excess pore pressure can make soil, buildings and pipes surrounded have large deflection, even make them injured. Combining with actual projects, this paper presents an in-situ model test on the changes of excess pore water pressure caused by precast pile construct. It is found that the radius of influence range for single pile driven is about 15m,the excess pore water pressure can reach or even exceed the above effective soil pressure, and there are two relatively stable stages.


2012 ◽  
Vol 446-449 ◽  
pp. 1621-1626 ◽  
Author(s):  
Yan Mei Zhang ◽  
Dong Hua Ruan

A practical saturated sand elastic-plastic dynamic constitutive model was developed on the base of Handin-Drnevich class nonlinear lag model and multidimensional model. In this model, during the calculation of loading before soil reaches yielding, unloading and inverse loading, corrected Handin-Drnevich equivalent nonlinear model was adopted; after soil yielding, based on the idea of multidimensional model, the composite hardening law which combines isotropy hardening and follow-up hardening, corrected Mohr-Coulomb yielding criterion and correlation flow principle were adopted. A fully coupled three dimension effective stress dynamic analysis procedure was developed on the base of this model. The seismic response of liquefaction foundation reinforced by stone columns was analyzed by the developed procedure. The research shows that with the diameter of stone columns increasing, the excess pore water pressure in soil between piles decreases; with the spacing of columns increasing, the excess pore water pressure increases. The influence of both is major in middle and lower level of composite foundation.


2013 ◽  
Vol 438-439 ◽  
pp. 1171-1175
Author(s):  
Zhi Li Sui ◽  
Zhao Guang Li ◽  
Xu Peng Wang ◽  
Wen Li Li ◽  
Tie Jun Xu

Dynamic consolidation method has been widely used in improving soft land, but always inefficient to saturated soft clay land, which is hard to improve, and even leads to rubber soil. Dynamic and drain consolidation method will deal with it well, with drainage system, pore-water can be expelled instantly from saturated soft clay as impacting. The pore-water pressure and earth pressure test in construction, the standard penetration test, plate loading test, geotechnical test after construction, which are all effective methods for effect testing. There is a comprehensive detection through different depth of soil layer with different detecting means on construction site. The results show that improving saturated soft clay land with dynamic and drain consolidation method has obtained good effect, and the fruit can be guidance for such construction in the future.


Sign in / Sign up

Export Citation Format

Share Document