Surface Shot Peening Post-processing of Inconel 718 Alloy Parts Printed by Laser Powder Bed Fusion Additive Manufacturing

Author(s):  
D. A. Lesyk ◽  
V. V. Dzhemelinskyi ◽  
S. Martinez ◽  
B. N. Mordyuk ◽  
A. Lamikiz
2021 ◽  
Vol 883 ◽  
pp. 234-241
Author(s):  
Timo Rautio ◽  
Jarmo Mäkikangas ◽  
Jani Kumpula ◽  
Antti Järvenpää ◽  
Atef Hamada

This paper focuses on the laser weldability of additively manufactured (AM) Inconel 718. The experiments of this research were conducted on different series of AM Inconel 718 alloy, i.e. as­-built, heat­ treated (HT), and HT after welding, and comprehensively characterized using optical microscope and electron back scattering diffraction (EBSD). The weld morphology and microstruc­tural evolution of the fusion zone were recorded. The mechanical properties of the welded AM Inconel 718 were evaluated by tensile tests and hardness measurements. It was found that solidification crack and micropore defects are induced in the as­built AM Inconel 718. However, defect­free weld was promoted in the HT alloy. The changes in hardness profiles and tensile strength under the experimen­tal parameters were further reported. Homogenous hardness of 500 HV across the weld was obtained when HT was applied after the LW.


2021 ◽  
pp. 102490
Author(s):  
Dongqing Yan ◽  
Milad Ghayoor ◽  
Kai Coldsnow ◽  
Hadi Pirgazi ◽  
Behrang Poorganji ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document