Microstructure Analysis of High-Density 316L Stainless Steel Manufactured by Selective Laser Melting Process

2021 ◽  
Author(s):  
Ismat Ara ◽  
Fardad Azarmi ◽  
X. W. Tangpong
Keyword(s):  
Stainless Steel ◽  
Selective Laser Melting ◽  
316L Stainless Steel ◽  
Melting Process ◽  
High Density ◽  
Microstructure Analysis ◽  
Laser Melting ◽  
Selective Laser Melting Process

Numerical Investigation of Selective Laser Melting Process for 904L Stainless Steel

2012 ◽  
Author(s):  
Miranda Fateri ◽  
Andreas Gebhardt ◽  
Maziar Khosravi
Keyword(s):  
Heat Flux ◽  
Stainless Steel ◽  
Selective Laser Melting ◽  
Melting Process ◽  
Full Density ◽  
Laser Melting ◽  
Scanning Velocity ◽  
Selective Laser Melting Process ◽  
Fine Mesh ◽  
Melt Pool

Selective Laser Melting process (SLM) is an important manufacturing method for producing complex geometries which allows for creation of full density parts with similar properties as the bulk material without extensive post processing. In SLM process, laser power, beam focus diameter, and scanning velocity must be precisely set based on the material properties in order to produce dense parts. In this study, Finite Element Analysis (FEA) method is employed in order to simulate and analyze a single layer of 904L Stainless Steel. A three-dimensional transient thermal model of the SLM process based on phase change enthalpy, irradiation scattering, and heat conductivity of powder is developed. The laser beam is modeled as a moving heat flux on the surface of the layer using a fine mesh which allows for a variation of the shape and distribution of the beam. In this manner, various Gaussian distributions are investigated and compared against single and multi-element heat flux sources. The melt pool and temperature distribution in the part are numerically investigated in order to determine the effects of varying laser intensity, scanning velocity as well as preheating temperature. The results of the simulation are verified by comparing the melt pool width as a function of power and velocity against the experimentally obtained results. Lastly, 3D objects are fabricated with a SLM 50 Desktop machine using the acquired optimized process parameters.

Sign in / Sign up

Export Citation Format

Share Document