A review on hydrothermal pretreatment of sewage sludge: Energy recovery options and major challenges

2022 ◽  
pp. 297-314
Author(s):  
Diwakar Kumar Singh ◽  
Anurag Garg
2018 ◽  
Vol 6 (12) ◽  
pp. 16629-16636 ◽  
Author(s):  
Ye Shen ◽  
Chao He ◽  
Xiaoping Chen ◽  
Alexei A. Lapkin ◽  
Wende Xiao ◽  
...  

2013 ◽  
Vol 111 ◽  
pp. 199-205 ◽  
Author(s):  
Peitao Zhao ◽  
Hongfang Chen ◽  
Shifu Ge ◽  
Kunio Yoshikawa

2018 ◽  
Vol 77 (11) ◽  
pp. 2613-2623 ◽  
Author(s):  
Kerstin Schopf ◽  
Johannes Judex ◽  
Bernhard Schmid ◽  
Thomas Kienberger

Abstract A municipal wastewater treatment plant accounts for a large portion of the total energy consumption of a municipality. Besides their high energy demand, the plants also display a significant bioenergy potential. This is due to the utilisation of the energy content of digester gas and sewage sludge if there exist suitable units. To maximise the energy recovery efficiency of wastewater treatment systems (WWTS), it is important to analyse the amount of digester gas and sludge produced in different types of plants. Therefore, the present paper deals with designing a tool to answer the following research questions: Which bioenergy potentials occur in different plant types? Which mass and energy flows are related to the specific potentials? Which utilisation processes for the potentials can lead to a high energy recovery efficiency of WWTS? Preliminary analyses with the designed tool were focused on estimating the level of electric and thermal energy self-sufficiency of different plant configuration scenarios including or excluding digester gas and/or sludge utilisation units. First results based on the level of self-sufficiency and associated energy and disposal costs show that a digester gas and sewage sludge utilisation should be considered when designing future WWTS.


Energies ◽  
2019 ◽  
Vol 12 (10) ◽  
pp. 1927 ◽  
Author(s):  
Dinko Đurđević ◽  
Paolo Blecich ◽  
Željko Jurić

Croatia produced 21,366 tonnes of dry matter (DM) sewage sludge (SS) in 2016, a quantity expected to surpass 100,000 tonnes DM by 2024. Annual production rates for future wastewater treatment plants (WWTP) in Croatia are estimated at 5.8–7.3 Nm3/people equivalent (PE) for biogas and 20–25 kgDM/PE of sewage sludge. Biogas can be converted into 12–16 kWhel/PE of electricity and 19–24 kWhth/PE of heat, which is sufficient for 30–40% of electrical and 80–100% of thermal autonomy. The WWTP autonomy can be increased using energy recovery from sewage sludge incineration by 60% for electricity and 100% of thermal energy (10–13 kWhel/PE and 30–38 kWhth/PE). However, energy for sewage sludge drying exceeds energy recovery, unless solar drying is performed. The annual solar drying potential is estimated between 450–750 kgDM/m2 of solar drying surface. The lower heating value of dried sewage sludge is 2–3 kWh/kgDM and this energy can be used for assisting sludge drying or for energy generation and supply to WWTPs. Sewage sludge can be considered a renewable energy source and its incineration generates substantially lower greenhouse gases emissions than energy generation from fossil fuels. For the same amount of energy, sewage sludge emits 58% fewer emissions than natural gas and 80% less than hard coal and fuel oil. Moreover, this paper analysed the feasibility of sludge disposal practices by analysing three scenarios (landfilling, co-incineration, and mono-incineration). The analysis revealed that the most cost-effective sewage sludge disposal method is landfilling for 60% and co-incineration for 40% of the observed WWTPs in Croatia. The lowest CO2 emissions are obtained with landfilling and mono-incineration in 53% and 38% of the cases, respectively.


2020 ◽  
Vol 276 ◽  
pp. 122538 ◽  
Author(s):  
Vipin Singh ◽  
Harish C. Phuleria ◽  
Munish K. Chandel

Sign in / Sign up

Export Citation Format

Share Document