scholarly journals Single metal atom oxide anchored Fe3O4-ED-rGO for highly efficient photodecomposition of antibiotic residues under visible light illumination

2022 ◽  
Vol 300 ◽  
pp. 120740
Author(s):  
Karuppaiah Selvakumar ◽  
Yueshuai Wang ◽  
Yue Lu ◽  
Bohai Tian ◽  
Zeyu Zhang ◽  
...  
2013 ◽  
Vol 25 (10) ◽  
pp. 2138-2149 ◽  
Author(s):  
Zhenxuan Zhao ◽  
Hongxing Dai ◽  
Jiguang Deng ◽  
Yuxi Liu ◽  
Yuan Wang ◽  
...  

RSC Advances ◽  
2014 ◽  
Vol 4 (57) ◽  
pp. 30090-30099 ◽  
Author(s):  
Wenshu Tang ◽  
Yu Su ◽  
Xiaoxin Wang ◽  
Qi Li ◽  
Shian Gao ◽  
...  

A novel superparamagnetic Ag@silver-based salt photocatalyst was created with highly efficient visible light photocatalytic performance and easy magnetic separation.


2021 ◽  
Author(s):  
Dong-Eun Lee ◽  
Mi Hyang Bae ◽  
Wan Jo

Abstract Herein, a highly efficient three-dimensional (3D) semiconductor-based heterostructure photocatalyst (i.e., WO3–g-C3N4 monolithic architecture; WOCNM) was developed by immobilizing a WO3–g-C3N4 heterostructure powder on a melamine foam (MF) framework. Subsequently, the sustained control of two harmful model gas-phase pollutants (i.e., n-butanol and o-xylene) over WOCNM and selected monolithic counterparts (i.e., MF-supported WO3 monolith and MF-supported g-C3N4 monolith) was investigated under visible-light irradiation. WOCNM exhibited higher photocatalytic capabilities in the sustained control of the two model pollutants than those of individual WO3 and g-C3N4 monoliths because the WO3–g-C3N4 heterojunction enhanced its charge-separation ability. Notably, WOCNM exhibited highly efficient photocatalytic capabilities in the sustained control of n-butanol (up to 97%) and o-xylene (up to 86%). Moreover, no noticeable changes were observed in the WOCNM photocatalytic capability after the final run of successive applications. The fresh and successively used WOCNMs were nearly identical, and the photocatalyst powder was not observed in the reaction chamber after its successive application. As a result, WOCNM was a highly efficient and stable 3D heterostructure photocatalyst for the sustained control of gas-phase n-butanol and o-xylene, without significant catalyst powder loss. Promisingly, this study will expedite the future development of 3D photocatalysts for the sustained control of harmful gas-phase pollutants.


2018 ◽  
Vol 20 (7) ◽  
pp. 5264-5273 ◽  
Author(s):  
J. Nie ◽  
A. O. T. Patrocinio ◽  
S. Hamid ◽  
F. Sieland ◽  
J. Sann ◽  
...  

Cu nanoparticles were deposited on the surface of commercial TiO2 nanoparticles (Cu–TiO2) using different methods aiming at the production of highly efficient visible light photocatalysts.


2020 ◽  
Vol 31 (25) ◽  
pp. 255702
Author(s):  
Trang Nguyen Thi Thuy ◽  
Soo Kyung Cho ◽  
Yerkezhan Amangeldinova ◽  
Dayoung Yoo ◽  
Gulmaral Tukyei ◽  
...  

2015 ◽  
Vol 19 (6) ◽  
pp. 512-520 ◽  
Author(s):  
Nikolaos Karanasios ◽  
Jenia Georgieva ◽  
Eugenia Valova ◽  
Stephan Armyanov ◽  
Georgios Litsardakis ◽  
...  

Materials ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 3948
Author(s):  
Lingfang Qiu ◽  
Zhiwei Zhou ◽  
Mengfan Ma ◽  
Ping Li ◽  
Jinyong Lu ◽  
...  

Novel visible-light responded aluminosilicophosphate-5 (SAPO-5)/g-C3N4 composite has been easily constructed by thermal polymerization for the mixture of SAPO-5, NH4Cl, and dicyandiamide. The photocatalytic activity of SAPO-5/g-C3N4 is evaluated by degrading RhB (30 mg/L) under visible light illumination (λ > 420 nm). The effects of SAPO-5 incorporation proportion and initial RhB concentration on the photocatalytic performance have been discussed in detail. The optimized SAPO-5/g-C3N4 composite shows promising degradation efficiency which is 40.6% higher than that of pure g-C3N4. The degradation rate improves from 0.007 min−1 to 0.022 min−1, which is a comparable photocatalytic performance compared with other g-C3N4-based heterojunctions for dye degradation. The migration of photo-induced electrons from g-C3N4 to the Al site of SAPO-5 should promote the photo-induced electron-hole pairs separation rate of g-C3N4 efficiently. Furthermore, the redox reactions for RhB degradation occur on the photo-induced holes in the g-C3N4 and Al sites in SAPO-5, respectively. This achievement not only improves the photocatalytic activity of g-C3N4 efficiently, but also broadens the application of SAPOs in the photocatalytic field.


Applied Nano ◽  
2021 ◽  
Vol 2 (3) ◽  
pp. 148-161
Author(s):  
Katerina Govatsi ◽  
Aspasia Antonelou ◽  
Labrini Sygellou ◽  
Stylianos G. Neophytides ◽  
Spyros N. Yannopoulos

The rational synthesis of semiconducting materials with enhanced photoelectrocatalytic efficiency under visible light illumination is a long-standing issue. ZnO has been systematically explored in this field, as it offers the feasibility to grow a wide range of nanocrystal morphology; however, its wide band gap precludes visible light absorption. We report on a novel method for the controlled growth of semiconductor heterostructures and, in particular, core/sheath ZnO/MoS2 nanowire arrays and the evaluation of their photoelectrochemical efficiency in oxygen evolution reaction. ZnO nanowire arrays, with a narrow distribution of nanowire diameters, were grown on FTO substrates by chemical bath deposition. Layers of Mo metal at various thicknesses were sputtered on the nanowire surface, and the Mo layers were sulfurized at low temperature, providing in a controlled way few layers of MoS2, in the range from one to three monolayers. The heterostructures were characterized by electron microscopy (SEM, TEM) and spectroscopy (XPS, Raman, PL). The photoelectrochemical properties of the heterostructures were found to depend on the thickness of the pre-deposited Mo film, exhibiting maximum efficiency for moderate values of Mo film thickness. Long-term stability, in relation to similar heterostructures in the literature, has been observed.


Sign in / Sign up

Export Citation Format

Share Document