An experimental study of emission and combustion characteristics of marine diesel engine with fuel pump malfunctions

2014 ◽  
Vol 65 (1-2) ◽  
pp. 469-476 ◽  
Author(s):  
Jerzy Kowalski
2016 ◽  
Vol 167 (4) ◽  
pp. 53-57
Author(s):  
Joanna LEWIŃSKA

The article presents results of a laboratory study on exhaust gas emission level from a marine diesel engine. The object of the laboratory study was a four-stroke marine diesel engine type Al 25/30 Sulzer, operated at a constant speed. The examination on the engine was carried out according to regulations of the Annex VI to MARPOL 73/78 Convention. The laboratory study consisted of 3 observations: the engine assumed to be operating without malfunctions, delay of the fuel injection by 5° of crankshaft angle in the second engine cylinder, and the leakage of the fuel pump on the second engine cylinder. Additionally, parameters of fuel consumption and thermodynamic parameters of the marine engine were measured during the research. Simulated malfunctions caused changes in total weighed NOx, CO, and CO2 emissions for all considered engine loads. All simulated malfunctions caused a small change in measured thermodynamic parameters of the engine. The engine operation with the delayed fuel injection and the fuel leakage in the fuel pump in one cylinder caused a decrease of NOx and CO emission level. Fuel leakage in the fuel pump causes the CO2 emission to decrease only at low engine load. Calculations of the weighed specific fuel consumption present a 1-2% change in the engine efficiency.


2013 ◽  
Vol 291-294 ◽  
pp. 1889-1894
Author(s):  
Lei Jiang ◽  
Jun Huang

Urea-SCR catalytic converter can effectively reduce the NOx emission of diesel engines, but meanwhile catalytic converter will cause some pressure loss in the exhaust system, which has negative influences on the engine performances. In this paper, the method of theoretical analysis calculated the pressure loss of the SCR catalytic converter, and designing a new type of exhaust gas pipe. Through the test to meet the design requirements,the results can provide a reference for optimum design of SCR catalytic converters and assembling.


Sign in / Sign up

Export Citation Format

Share Document