Estimate of boundary-layer depth in Nanjing city using aerosol lidar data during 2016–2017 winter

2019 ◽  
Vol 205 ◽  
pp. 67-77 ◽  
Author(s):  
Sihui Fan ◽  
Zhiqiu Gao ◽  
John Kalogiros ◽  
Yubin Li ◽  
Jian Yin ◽  
...  
2016 ◽  
Vol 162 (3) ◽  
pp. 503-522 ◽  
Author(s):  
Meng Huang ◽  
Zhiqiu Gao ◽  
Shiguang Miao ◽  
Fei Chen ◽  
Margaret A. LeMone ◽  
...  

2006 ◽  
Vol 19 (11) ◽  
pp. 2347-2365 ◽  
Author(s):  
Gokhan Danabasoglu ◽  
William G. Large ◽  
Joseph J. Tribbia ◽  
Peter R. Gent ◽  
Bruce P. Briegleb ◽  
...  

Abstract New features that may affect the behavior of the upper ocean in the Community Climate System Model version 3 (CCSM3) are described. In particular, the addition of an idealized diurnal cycle of solar forcing where the daily mean solar radiation received in each daily coupling interval is distributed over 12 daylight hours is evaluated. The motivation for this simple diurnal cycle is to improve the behavior of the upper ocean, relative to the constant forcing over each day of previous CCSM versions. Both 1- and 3-h coupling intervals are also considered as possible alternatives that explicitly resolve the diurnal cycle of solar forcing. The most prominent and robust effects of all these diurnal cycles are found in the tropical oceans, especially in the Pacific. Here, the mean equatorial sea surface temperature (SST) is warmed by as much as 1°C, in better agreement with observations, and the mean boundary layer depth is reduced. Simple rectification of the diurnal cycle explains about half of the shallowing, but less than 0.1°C of the warming. The atmospheric response to prescribed warm SST anomalies of about 1°C displays a very different heat flux signature. The implication, yet to be verified, is that large-scale air–sea coupling is a prime mechanism for amplifying the rectified, daily averaged SST signals seen by the atmosphere. Although the use of upper-layer temperature for SST in CCSM3 underestimates the diurnal cycle of SST, many of the essential characteristics of diurnal cycling within the equatorial ocean are reproduced, including boundary layer depth, currents, and the parameterized vertical heat and momentum fluxes associated with deep-cycle turbulence. The conclusion is that the implementation of an idealized diurnal cycle of solar forcing may make more frequent ocean coupling and its computational complications unnecessary as improvements to the air–sea coupling in CCSM3 continue. A caveat here is that more frequent ocean coupling tends to reduce the long-term cooling trends typical of CCSM3 by heating already too warm ocean depths, but longer integrations are needed to determine robust features. A clear result is that the absence of diurnal solar forcing of the ocean has several undesirable consequences in CCSM3, including too large ENSO variability, much too cold Pacific equatorial SST, and no deep-cycle turbulence.


2013 ◽  
Vol 118 (17) ◽  
pp. 9870-9879 ◽  
Author(s):  
Jasper R. Lewis ◽  
Ellsworth J. Welton ◽  
Andrea M. Molod ◽  
Everette Joseph
Keyword(s):  

2007 ◽  
Vol 7 (5) ◽  
pp. 15025-15065 ◽  
Author(s):  
W. J. Shaw ◽  
M. S. Pekour ◽  
R. L. Coulter ◽  
T. J. Martin ◽  
J. T. Walters

Abstract. During the MILAGRO campaign centered in the Mexico City area, Pacific Northwest National Laboratory (PNNL) and Argonne National Laboratory (ANL) operated atmospheric profiling systems at Veracruz and at two locations on the Central Mexican Plateau in the region around Mexico City. These systems included radiosondes, wind profilers, a sodar, and an aerosol backscatter lidar. An additional wind profiler was operated by the University of Alabama in Huntsville (UAH) at the Mexican Petroleum Institue (IMP) near the center of Mexico City. Because of the opportunity afforded by collocation of profilers, radiosondes, and a lidar, and because of the importance of boundary layer depth for aerosol properties, we have carried out a comparison of mixing layer depth as determined independently from these three types of measurement systems during the campaign. We have then used results of this comparison and additional measurements to develop a detailed description of the daily structure and evolution of the boundary layer on the Central Mexican Plateau during MILAGRO. Our analysis indicates that the profilers were more consistently successful in establishing the mixing layer depth during the daytime. The boundary layer growth was similar at the three locations, although the mixing layer tended to be slightly deeper in the afternoon in central Mexico City. The sodar showed that convection began about an hour after sunrise. Maximum daily mixing layer depths always reached 2000 m a.g.l. and frequently extended to 4000 m. The rate and variability of mixing layer growth was essentially the same as that observed during the IMADA-AVER campaign in the same season in 1997. This growth did not seem to be related to whether deep convection was reported on a given day. Wind speeds within the boundary layer exhibited a daily low-altitude maximum in the late afternoon with lighter winds aloft, consistent with previous reports of diurnal regional circulations. Norte events, which produced high winds at Veracruz, did not appreciably modulate the winds on the plateau. Finally, despite the typically dry conditions at the surface, radiosonde profiles showed that relative humidity often exceeded 50% in the early morning and in the upper part of the boundary layer. This suggests that aerosol particles would have experienced hygroscopic growth within the boundary layer on many days.


2020 ◽  
Vol 77 (2) ◽  
pp. 435-442
Author(s):  
John Thuburn ◽  
Georgios A. Efstathiou

Abstract We hypothesize that the convective atmospheric boundary layer is marginally stable when the damping effects of turbulence are taken into account. If the effects of turbulence are modeled as an eddy viscosity and diffusivity, then an idealized analysis based on the hypothesis predicts a well-known scaling for the magnitude of the eddy viscosity and diffusivity. It also predicts that the marginally stable modes should have vertical and horizontal scales comparable to the boundary layer depth. A more quantitative numerical linear stability analysis is presented for a realistic convective boundary layer potential temperature profile and is found to support the hypothesis.


Atmosphere ◽  
2020 ◽  
Vol 11 (2) ◽  
pp. 158 ◽  
Author(s):  
Yifang Ren ◽  
Jun A. Zhang ◽  
Jonathan L. Vigh ◽  
Ping Zhu ◽  
Hailong Liu ◽  
...  

This study analyses Global Positioning System dropsondes to document the axisymmetric tropical cyclone (TC) boundary-layer structure, based on storm intensity. A total of 2608 dropsondes from 42 named TCs in the Atlantic basin from 1998 to 2017 are used in the composite analyses. The results show that the axisymmetric inflow layer depth, the height of maximum tangential wind speed, and the thermodynamic mixed layer depth are all shallower in more intense TCs. The results also show that more intense TCs tend to have a deep layer of the near-saturated air inside the radius of maximum wind speed (RMW). The magnitude of the radial gradient of equivalent potential temperature (θe) near the RMW correlates positively with storm intensity. Above the inflow layer, composite structures of TCs with different intensities all possess a ring of anomalously cool temperatures surrounding the warm-core, with the magnitude of the warm-core anomaly proportional to TC intensity. The boundary layer composites presented here provide a climatology of how axisymmetric TC boundary layer structure changes with intensity.


Sign in / Sign up

Export Citation Format

Share Document