scholarly journals A time-dependent atomistic reconstruction of severe irradiation damage and associated property changes in nuclear graphite

Carbon ◽  
2017 ◽  
Vol 120 ◽  
pp. 111-120 ◽  
Author(s):  
Baptiste Farbos ◽  
Helen Freeman ◽  
Trevor Hardcastle ◽  
Jean-Pierre Da Costa ◽  
Rik Brydson ◽  
...  
2003 ◽  
Vol 802 ◽  
Author(s):  
B. W. Chung ◽  
S. R. Thompson ◽  
C. H. Woods ◽  
D. J. Hopkins ◽  
W. H. Gourdin ◽  
...  

Plutonium, because of its radioactive nature, ages from the “inside out” by means of self-irradiation damage and thus produces Frankel-type defects (vacancies and self-interstitial atoms) and defect clusters. The self-irradiation damage in Plutonium-239 occurs mainly by α-particle decay, where most of the damage comes from the U-235 recoil nucleus. The defects resulting from the residual lattice damage and helium in-growth could result in microstructural and physical property changes. Because these self-irradiation effects would normally require decades to measure, with a fraction (7.5 wt%) of Pu-238 is added to the reference plutonium alloy thus accelerating the aging process by approximately 18 times the normal rate. By monitoring the properties of the Pu-238 spiked alloy over a period of about 3.5 years, the properties of plutonium in storage can be projected for periods up to about 60 years. This paper presents density and volume changes observed from the immersion density and dilatometry measurements equivalent to aging the reference plutonium alloys to nine years.


2005 ◽  
Vol 287 ◽  
pp. 489-494
Author(s):  
Kyeon Hwan Park ◽  
Tatsuya Hinoki ◽  
Akira Kohyama

Irradiation damage produced by neutrons or energetic particles lead to changes of physical- and mechanical-properties of SiC. Radiation hardening and fracture toughness changing of SiC were clarified by indentation method previously. However, the mechanism studies have received little alteration. The purpose of this study is to improve the understanding of the mechanisms of mechanical property changes under irradiation. In this paper, the microstructural observation beneath and near an indentation will be used to infer mechanisms of radiation hardening and toughening. Indenting polycrystalline SiC creates deformation and cracking in the plastically deformed region. In the case of irradiated SiC, however, small-sized deformation zone was observed below contact indent, which resulted in the restricted size of residual impression. Additionally, the indentation cracks showed complex propagation behaviors such as deflecting, branching and microcracking.


Author(s):  
Zhoutong He ◽  
Hui Tang ◽  
Can Zhang ◽  
Yantao Gao ◽  
Huihao Xia ◽  
...  

In thermal Molten Salt Reactors, the nuclear graphite core is in direct contact with the molten salt coolant. Due to the porous nature of nuclear graphite, the molten salt may infiltrate the nuclear graphite, which may affect the mechanical strength and irradiation behavior of the nuclear graphite. In order to evaluate the infiltration behavior of molten salt in nuclear graphite, both FLiNaK and FLiBe salts were used to infiltrate two typical nuclear graphite grades: IG110 and NBG18. The pressure dependence of the infiltration weight gain ratio was measured. The influence of molten salt infiltration on the thermal properties of these two graphite grades, such as their thermal expansion behavior and thermal conductivity, was also measured. The mechanical strength of the FLiNaK-infiltrated graphite was measured at room temperature and elevated temperature, and showed that the mechanical strength of the nuclear graphite was enhanced at room temperature and weakened at elevated temperature by molten salt infiltration. Finally, the thermal expansion coefficient and the fracture surface analysis measured after FLiNaK infiltration indicated that the stress induced by molten salt infiltration could be one of the reasons for the graphite property changes.


2016 ◽  
Vol 61 (3) ◽  
pp. 155-182 ◽  
Author(s):  
B. J. Marsden ◽  
M. Haverty ◽  
W. Bodel ◽  
G. N. Hall ◽  
A. N. Jones ◽  
...  

2015 ◽  
Vol 114 (2) ◽  
pp. 1255-1271 ◽  
Author(s):  
Scott L. Hooper ◽  
Jeffrey B. Thuma ◽  
Christoph Guschlbauer ◽  
Joachim Schmidt ◽  
Ansgar Büschges

We recorded from lobster and leech neurons with two sharp electrodes filled with solutions often used with these preparations (lobster: 0.6 M K2SO4 or 2.5 M KAc; leech: 4 M KAc), with solutions approximately matching neuron cytoplasm ion concentrations, and with 6.5 M KAc (lobster, leech) and 0.6 M KAc (lobster). We measured membrane potential, input resistance, and transient and sustained depolarization-activated outward current amplitudes in leech and these neuron properties and hyperpolarization-activated current time constant in lobster, every 10 min for 60 min after electrode penetration. Neuron properties varied with electrode fill. For fills with molarities ≥2.5 M, neuron properties also varied strongly with time after electrode penetration. Depending on the property being examined, these variations could be large. In leech, cell size also increased with noncytoplasmic fills. The changes in neuron properties could be due to the ions being injected from the electrodes during current injection. We tested this possibility in lobster with the 2.5 M KAc electrode fill by making measurements only 10 and 60 min after penetration. Neuron properties still changed, although the changes were less extreme. Making measurements every 2 min showed that the time-dependent variations in neuron properties occurred in concert with each other. Neuron property changes with high molarity electrode-fill solutions were great enough to decrease neuron firing strongly. An experiment with 14C-glucose electrode fill confirmed earlier work showing substantial leak from sharp electrodes. Sharp electrode work should thus be performed with cytoplasm-matched electrode fills.


Sign in / Sign up

Export Citation Format

Share Document