Picrasma quassioides mediated cerium oxide nanostructures and their post-annealing treatment on the microstructural, morphological and enhanced catalytic performance

2016 ◽  
Vol 42 (6) ◽  
pp. 6610-6618 ◽  
Author(s):  
T.V.M. Sreekanth ◽  
G.R. Dillip ◽  
Yong Rok Lee
2019 ◽  
Vol 7 ◽  
pp. 710-714 ◽  
Author(s):  
Muhammad Luqman Mohd Napi ◽  
Suhana Mohamed Sultan ◽  
Razali Ismail ◽  
Mohd Khairul Ahmad

2021 ◽  
Author(s):  
Yuanwei Jiang ◽  
Shuangying Cao ◽  
Linfeng Lu ◽  
Guanlin Du ◽  
Yinyue Lin ◽  
...  

Abstract Owing to its large work function, MoOX has been widely used for hole-selective contact in both thin film and crystalline silicon solar cells. In this work, thermally evaporated MoOX films are employed on the rear sides of p-type crystalline silicon (p-Si) solar cells, where the optical and electronic properties of the MoOX films as well as the corresponding device performances are investigated as a function of post-annealing treatment. The MoOX film annealed at 100oC shows the highest work function and proves the best hole selectivity based on the results of energy band simulation and contact resistivity measurements. The full rear p-Si/MoOX/Ag contacted solar cells demonstrate the best performance with an efficiency of 19.19%, which is the result of the combined influence of MoOX’s hole selectivity and passivation ability.


Nanomaterials ◽  
2019 ◽  
Vol 9 (11) ◽  
pp. 1555 ◽  
Author(s):  
Bourdin ◽  
Gaudon ◽  
Weill ◽  
Duttine ◽  
Gayot ◽  
...  

Tungsten trioxide (WO3) is well-known as one of the most promising chromogenic compounds. It has a drastic change of coloration induced from different external stimuli and so its applications are developed as gas sensors, electrochromic panels or photochromic sensors. This paper focuses on the photochromic properties of nanoWO3, with tunable composition (with tunable oxygen sub-stoichiometry). Three reference samples with yellow, blue and black colors were prepared from polyol synthesis followed by post annealing under air, none post-annealing treatment, or a post-annealing under argon atmosphere. These three samples differ in terms of crystallographic structure (cubic system versus monoclinic system), oxygen vacancy concentration, electronic band diagram with occurrence of free or trapped electrons and their photochromic behavior. Constituting one main finding, it is shown that the photochromic behavior is highly dependent on the compound’s composition/color. Rapid and important change of coloration under UV (ultraviolet) irradiation was evidenced especially on the blue compound, i.e., the photochromic coloring efficiency of this compound in terms of contrast between bleached and colored phase, as the kinetic aspect is high. The photochromism is reversible in a few hours. This hence opens a new window for the use of tungsten oxide as smart photochromic compounds.


RSC Advances ◽  
2014 ◽  
Vol 4 (29) ◽  
pp. 14872-14878 ◽  
Author(s):  
Huan Pang ◽  
Changyun Chen

A facile method is developed to synthesize cerium oxides with plate and brick morphologies by the thermal decomposition of nanostructured oxalate precursors.


2009 ◽  
Vol 79-82 ◽  
pp. 747-750 ◽  
Author(s):  
Dong Qing Liu ◽  
Wen Wei Zheng ◽  
Hai Feng Cheng ◽  
Hai Tao Liu

Thermochromic vanadium dioxide (VO2) exhibits a semi-conducting to metallic phase transition at about 68°C, involving strong variations in electrical and optical properties. A simple method was proposed to prepare VO2 thin films from easily gained V2O5 thin films. The detailed thermodynamic calculation was done and the results show that V2O5 will decompose to VO2 when the post annealing temperature reaches 550°C at the atmospheric pressure of less than 0.06Pa. The initial V2O5 films were prepared by sol-gel method on fused-quartz substrates. Different post annealing conditions were studied. The derived VO2 thin film samples were characterized using X-ray diffraction and X-ray photoelectron spectroscopy. The electrical resistance and infrared emissivity of VO2 thin films under different temperatures were measured. The results show that the VO2 thin film derived from the V2O5 thin film annealed at 550°C for 10 hours is pure dioxide of vanadium without other valences. It was observed that the resistance of VO2 thin film with thickness about 600nm can change by 4 orders of magnitude and the 7.5-14μm emissivity can change by 0.6 during the phase transition.


2018 ◽  
Vol 913 ◽  
pp. 831-837
Author(s):  
Ju Gang Ma ◽  
Jun Mei Wang ◽  
Shuai Li ◽  
Yu Jun Song

The ternary FePtSn alloy nanoparticles (NPs) were synthesized via a simple programmed microfluidic process, showing a great electrochemical performance in methanol oxidation reaction (MOR). The synthesis process exhibited convenient and spatial-temporal kinetics control of the NPs formation for a narrow size distribution, ultra-small (~2nm) and good dispersion features. The morphology, crystal structure and composition of FePtSn NPs were characterized by transmission electron microscopy (TEM), energy-dispersive X-ray spectroscopy (EDS), powder X-ray diffraction (XRD). FePtSn/C nanocatalyst ink could be further prepared by mixing the as-synthesized or annealed FePtSn NPs with carbon black powder and nafion. Their electrocatalytic performances were tested by the electrochemical work station. By contrast, the annealing treatment made more active sites exposed and facilitated the catalytic performance of FePtSn/C NPs. The electrochemical active surface areas (ECSAs, 42.8m2/g), catalytic activity (If: 588.1 mA/mg-Pt) and electrochemical durability of FePtSn/C nanocatalysts after annealing were greatly improved, comparing with as-synthesized samples and commercial Pt/C nanocatalysts for MOR. In addition, the onset potential of annealed FePtSn/C nanocatalysts was improved, much better than the commercial Pt/C nanocatalysts.


Sign in / Sign up

Export Citation Format

Share Document