scholarly journals A comparative energy and exergy optimization of a supercritical-CO2 Brayton cycle and Organic Rankine Cycle combined system using swarm intelligence algorithms

Heliyon ◽  
2020 ◽  
Vol 6 (6) ◽  
pp. e04136 ◽  
Author(s):  
Guillermo Valencia Ochoa ◽  
Jorge Duarte Forero ◽  
Jhan Piero Rojas
Keyword(s):  
Swarm Intelligence ◽  
Supercritical Co2 ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Brayton Cycle ◽  
Combined System ◽  
Energy And Exergy

Thermoeconomic Analysis of a Combined Natural Gas Cogeneration System With a Supercritical CO2 Brayton Cycle and an Organic Rankine Cycle

2020 ◽  
Vol 142 (10) ◽  
Author(s):  
Zhen Pan ◽  
Mingyue Yan ◽  
Liyan Shang ◽  
Ping Li ◽  
Li Zhang ◽  
...  
Keyword(s):  
Supercritical Co2 ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Inlet Temperature ◽  
Total System ◽  
Brayton Cycle ◽  
Exhaust Gas ◽  
Total Cost ◽  
Cogeneration System ◽  
Isentropic Efficiency

Abstract This paper proposes a new type of Gas Turbine Cycle-supercritical CO2 Brayton/organic Rankine cycle (GT-SCO2/ORC) cogeneration system, in which the exhaust gas from gas-fired plants generates electricity through GT and then the remaining heat is absorbed by the supercritical CO2 (SCO2) Brayton cycle and ORC. CO2 contained in the exhaust gas is absorbed by monoethanolamine (MEA) and liquefied via liquified natural gas (LNG). Introducing thermodynamic efficiencies, thermoeconomic analysis to evaluate the system performance and total system cost is used as the evaluation parameter. The results show that the energy efficiency and exergy efficiency of the system are 56.47% and 45.46%, respectively, and the total cost of the product is 2798.38 $/h. Moreover, with the increase in air compressor (AC) or gas turbine isentropic efficiency, GT inlet temperature, and air preheater (AP) outlet temperature, the thermodynamic efficiencies have upward trends, which proves these four parameters optimize the thermodynamic performance. The total system cost can reach a minimum value with the increase in AC pressure ratio, GT isentropic efficiency, and AC isentropic efficiency, indicating that these three parameters can optimize the economic performance of the cycle. The hot water income increases significantly with the increase in the GT inlet temperature, but it is not cost-effective in terms of the total cost.

A Supercritical CO2 Brayton Cycle Micro Turbine for Waste Heat Conversion: Optimization Layout in Cogenerative Applications

2021 ◽  
Author(s):  
Fabrizio Reale ◽  
Raniero Sannino ◽  
Raffaele Tuccillo
Keyword(s):  
Gas Turbines ◽  
Supercritical Co2 ◽  
Waste Heat ◽  
Mechanical Energy ◽  
Organic Rankine Cycle ◽  
Rankine Cycle ◽  
Combined Cycle ◽  
Thermal Source ◽  
Brayton Cycle ◽  
Micro Turbine

Abstract Waste heat recovery (WHR) can represent a good solution to increase overall performance of energy systems, even more in case of small systems. The exhaust gas at the outlet of micro gas turbines (MGTs) has still a large amount of thermal energy that can be converted into mechanical energy, because of its satisfactory temperature levels, even though the typical MGT layouts perform a recuperated cycle. In recent studies, supercritical CO2 Brayton Cycle (sCO2 GT) turbines were studied as WHR systems whose thermal source was the exhausts from gas turbines. In particular, subject of this study is the 100 kW MGT Turbec T100. In this paper, the authors analyze innovative layouts, with comparison in terms of performance variations and cogenerative indices. The study was carried out through the adoption of a commercial software, Thermoflex, for the thermodynamic analysis of the layouts. The MGT model was validated in previous papers while the characteristic parameters of the bottoming sCO2 GT were taken from the literature. The combined cycle layouts include simple and recompression sCO2 bottoming cycles and different fuel energy sources like conventional natural gas and syngases derived by biomasses gasification. A further option of bottoming cycle was also considered, namely an organic Rankine cycle (ORC) system for the final conversion of waste heat from sCO2 cycle into additional mechanical energy. Finally, the proposed plants have been compared, and the improvement in terms of flexibility and operating range have been highlighted.

Numerical Study of a Micro Gas Turbine Integrated With a Supercritical CO2 Brayton Cycle Turbine

2018 ◽  
Author(s):  
Fabrizio Reale ◽  
Vincenzo Iannotta ◽  
Raffaele Tuccillo
Keyword(s):  
Gas Turbines ◽  
Waste Heat ◽  
Numerical Study ◽  
Organic Rankine Cycle ◽  
Energy Systems ◽  
Rankine Cycle ◽  
Energy System ◽  
Small Scale ◽  
Brayton Cycle ◽  
Integrated Energy System

The primary need of reducing pollutant and greenhouse gas emissions has led to new energy scenarios. The interest of research community is mainly focused on the development of energy systems based on renewable resources and energy storage systems and smart energy grids. In the latter case small scale energy systems can become of interest as nodes of distributed energy systems. In this context micro gas turbines (MGT) can play a key role thanks to their flexibility and a strategy to increase their overall efficiency is to integrate gas turbines with a bottoming cycle. In this paper the authors analyze the possibility to integrate a MGT with a super critical CO2 Brayton cycle turbine (sCO2 GT) as a bottoming cycle (BC). A 0D thermodynamic analysis is used to highlight opportunities and critical aspects also by a comparison with another integrated energy system in which the waste heat recovery (WHR) is obtained by the adoption of an organic Rankine cycle (ORC). While ORC is widely used in case of middle and low temperature of the heat source, s-CO2 BC is a new method in this field of application. One of the aim of the analysis is to verify if this choice can be comparable with ORC for this operative range, with a medium-low value of exhaust gases and very small power values. The studied MGT is a Turbec T100P.

Sign in / Sign up

Export Citation Format

Share Document