Glue wood veneer to wood-fiber–high-density-polyethylene composite

2019 ◽  
Vol 95 ◽  
pp. 102444
Author(s):  
Yanan Sun ◽  
Limin Guo ◽  
Yinan Liu ◽  
Weihong Wang ◽  
Yongming Song
2012 ◽  
Vol 182-183 ◽  
pp. 274-277
Author(s):  
Fang Huang

Wood flour is inexpensive, and can be used as a reinforcing agent to improve the mechanical properties of high density polyethylene, reduce cost. Wood fiber as a renewable natural material, biodegradation, therefore, high filling wood powder high density polyethylene composite material with certain environmental compatibility, at the same time, high density polyethylene can be a source of waste recycling materials, therefore plastic-wood composite material is a kind of can reduce the "white pollution" environmental material. [1-5]


2013 ◽  
Vol 32 (21) ◽  
pp. 1646-1655 ◽  
Author(s):  
Talel Ben Mbarek ◽  
Laurent Robert ◽  
Habib Sammouda ◽  
Bertrand Charrier ◽  
Jean-José Orteu ◽  
...  

2020 ◽  
Vol 8 (8) ◽  
pp. 879-890
Author(s):  
Jialin Lv ◽  
Rao Fu ◽  
Yinan Liu ◽  
Xuelian Zhou ◽  
Weihong Wang ◽  
...  

2012 ◽  
Vol 33 (7) ◽  
pp. 1071-1076 ◽  
Author(s):  
I. Tavman ◽  
I. Krupa ◽  
M. Omastova ◽  
M. Sarikanat ◽  
I. Novak ◽  
...  

2012 ◽  
Vol 622-623 ◽  
pp. 860-863
Author(s):  
S. Hamidizadeh ◽  
A. Ataie ◽  
Amin Nozari

Barium hexaferrite/high density polyethylene composite was prepared from synthesized barium hexaferrite as matrix with 0, 10, 20, 30, 40 wt.% of high density polyethylene via a high energy planetary ball milling for 10 h. The milling products were isostatically pressed and finally sintered at 1250 °C for 1 h. Effect of HDPE content on morphology of the products were investigated using scanning electron microscope (SEM). Vibrating samplemagnetometer (VSM) analysis of single phase BaFe12O19 indicates saturation magnetization and coercivity of 52 emu/g and 4300 Oe, respectively. Visually, as the weight percent of the HDPE increases, more porous structure was observed. Moreover, the density of the sintered sampleslinearly decreased from 4.16 to 1.41 g/cm3 by increasing the amount of HDPE from 0 to 40 wt.%.


2016 ◽  
Vol 39 (4) ◽  
pp. 1192-1199 ◽  
Author(s):  
Wenlong Liu ◽  
Dongxia Wang ◽  
Yin Zhang ◽  
Ting Bai ◽  
Jing Li

Sign in / Sign up

Export Citation Format

Share Document