Potential sites for geological storage of CO2 require detailed assessment of storage capacity, containment potential and migration pathways. A possible candidate is the Flag Sandstone of the Barrow Sub-basin, northwest Australia, sealed by the Muderong Shale. The Flag Sandstone consists of a series of stacked, amalgamated, basin floor fan lobes with good lateral interconnectivity. The main reservoir sandstones have high reservoir quality with an average porosity of 21% and an average permeability of about 1,250 mD. The Muderong Shale has excellent seal capacity, with the potential to withhold an average CO2 column height of 750 m. Other containment issues were addressed by in situ stress and fault stability analysis. An average orientation of 095°N for the maximum horizontal stress was estimated. The stress regime is strike-slip at the likely injection depth (below 1,800 m). Most of the major faults in the study area have east-northeast to northeast trends and failure plots indicate that some of these faults may be reactivated if CO2 injection pressures are not monitored closely. Where average fault dips are known, maximum sustainable formation pressures were estimated to be less than 27 MPa at 2 km depth. Hydrodynamic modelling indicated that the pre-production regional formation water flow direction was from the sub-basin margins towards the centre, with an exit point to the southwest. However, this flow direction and rate have been altered by a hydraulic low in the eastern part of the sub-basin due to hydrocarbon production. The integrated site analysis indicates a potential CO2 storage capacity in the order of thousands of Mtonnes. Such capacity for geological storage could provide a technical solution for reducing greenhouse gas emissions.
Application of a dual tubing CO2 injection-water production horizontal well pattern for improving the CO2 storage capacity and reducing the CAPEX: A case study in Pohang basin, Korea
