Modeling of condensation heat transfer of pure refrigerants in micro-fin tubes

2005 ◽  
Vol 48 (7) ◽  
pp. 1293-1302 ◽  
Author(s):  
Louay M. Chamra ◽  
Pedro J. Mago ◽  
Meng-Onn Tan ◽  
Chea-Chun Kung
Keyword(s):  
Heat Transfer ◽  
Condensation Heat Transfer ◽  
Fin Tubes

Condensation Pressure Drop and Heat Transfer in 5-mm-OD Micro-Fin Tubes

2012 ◽  
Author(s):  
Wei Li ◽  
Dan Huang ◽  
Zan Wu ◽  
Hong-Xia Li ◽  
Zhao-Yan Zhang ◽  
...  
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Pressure Drop ◽  
Transfer Coefficient ◽  
Heat Transfer Enhancement ◽  
Condensation Heat Transfer ◽  
Transfer Enhancement ◽  
Mass Fluxes ◽  
Fin Tubes ◽  
Condensation Heat Transfer Coefficient

An experimental investigation was performed for convective condensation of R410A inside four micro-fin tubes with the same outside diameter (OD) 5 mm and helix angle 18°. Data are for mass fluxes ranging from about 180 to 650 kg/m2s. The nominal saturation temperature is 320 K, with inlet and outlet qualities of 0.8 and 0.1, respectively. The results suggest that Tube 4 has the best thermal performance for its largest condensation heat transfer coefficient and relatively low pressure drop penalty. Condensation heat transfer coefficient decreases at first and then increases or flattens out gradually as G decreases. This complex mass-flux effect may be explained by the complex interactions between micro-fins and fluid. The heat transfer enhancement mechanism is mainly due to the surface area increase over the plain tube at large mass fluxes, while liquid drainage and interfacial turbulence play important roles in heat transfer enhancement at low mass fluxes. In addition, the experimental data was analyzed using seven existing pressure-drop and four heat-transfer models to verify their respective accuracies.

Experimental Study on Condensation of R134a inside Horizontal Inner-Micro-Fin Tubes

2011 ◽  
Vol 354-355 ◽  
pp. 753-758
Author(s):  
Qi Wei Chen ◽  
Xin Ping Ouyang
Keyword(s):  
Heat Transfer ◽  
Experimental Study ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Mass Velocity ◽  
Condensation Heat Transfer ◽  
Enhanced Tube ◽  
Glycol Solution ◽  
Fin Tubes ◽  
Condensation Heat Transfer Coefficient

An experimental study of condensation heat transfer of R134a on horizontal inner enhanced tubes was conducted. The tested tubes were inner-micro-fin tubes, named tube A and tube B, respectively. The tested pieces were double-pipe condensers. The glycol solution flowed in the space between outer surface of the enhanced tube and inner surface of outer tube. In the experiment, condensing temperature inside the enhanced tube was 51°C, and the flow velocity of glycol solution was 3.35m/s. The inlet temperature of glycol solution changed according to mass velocity of refrigerant, to maintain certain degree of undercooling of outlet refrigerant. The research showed that the condensation heat transfer coefficient of both tubes increased with the increasing mass velocity of refrigerant. when the mass velocity of refrigerant increased from 300kg/m2s to 700kg/m2s, the condensation heat transfer coefficient in tube A was 1.87% to 6.28% higher than that of tube B. However, the flow resistance of the refrigerant in tube B was 9.56% to 11.05% higher than in tube A. The structure of tube A was superior to that of tube B.

Effect of Fin Geometry on Condensation of R407C in a Staggered Bundle of Horizontal Finned Tubes

2003 ◽  
Vol 125 (4) ◽  
pp. 653-660 ◽  
Author(s):  
H. Honda ◽  
N. Takata ◽  
H. Takamatsu ◽  
J. S. Kim ◽  
K. Usami
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Vapor Phase ◽  
Mass Velocity ◽  
Three Dimensional ◽  
Condensation Heat Transfer ◽  
Finned Tubes ◽  
Fin Tubes ◽  
Condensation Heat Transfer Coefficient

Experimental results are presented that show the effect of fin geometry on condensation of downward flowing zeotropic refrigerant mixture R407C in a staggered bundle of horizontal finned tubes. Two types of conventional low-fin tubes and three types of three-dimensional-fin tubes were tested. The refrigerant mass velocity ranged from 4 to 23 kg/m2 s and the condensation temperature difference from 3 to 12 K. The measured condensation heat transfer coefficient was lower than the previous results for R134a, with the difference being more significant for smaller mass velocity. The effect of fin geometry on the condensation heat transfer coefficient was less significant for R407C than for R134a. The effect of condensate inundation was more significant for the three-dimensional-fin tubes than for the low-fin tubes. By using the dimensionless heat transfer correlation for the condensate film that was based on the experimental data for R134a, a superficial vapor-phase heat transfer coefficient was obtained for condensation of R407C. The vapor-phase heat transfer coefficient showed characteristics similar to the vapor-phase mass transfer coefficient that was obtained in the previous study for R123/R134a.

Condensation Heat Transfer of Soliman Flow Pattern in Mini-Channel

2006 ◽  
Author(s):  
Q. Chen ◽  
R. S. Amano
Keyword(s):  
Heat Transfer ◽  
Experimental Data ◽  
Flow Pattern ◽  
Flow Regime ◽  
Flow Region ◽  
Condensation Heat Transfer ◽  
Heat Transfer Correlation ◽  
Transfer Coefficients ◽  
Annular Regime ◽  
Fin Tubes

The condensation heat transfer for R134a in the two kinds of in-tube three-dimensional (3-D) micro-fin tubes with different geometries is experimentally investigated. Based on the flow pattern observations, the flow patterns in the Soliman flow regime map are divided into two-flow regimes; one with the vapor-shear-dominant annular regime and the other with the gravitational-force-dominant stratified-wavy regime. In the annular regime, the heat transfer coefficients of the two kinds of in-tube 3-D micro-fin tubes decreases as the vapor quality decreases. The regressed condensation heat transfer correlation from the experimental data of the annular flow region is obtained. The dispersibility of the experimental data is inside the limits of ±25%. In the stratified-wavy regime, the average heat transfer coefficient of the two kinds of in-tube 3-D micro fin tubes increases as the mass flux increases and the number of micro fins in the 3-D micro-fin tube is not the controlling factor for performance of a condensation heat transfer. The regressed condensation heat transfer correlation of the stratified-wavy flow regime is experimentally obtained. The dispersibility of the experimental data is inside the limits of ±22%. Combined with the criteria of flow pattern transitions, the correlations can be used for the design of a condenser with 3-D micro fin tubes.

Sign in / Sign up

Export Citation Format

Share Document