Utilization of natural sisal fibers to manufacture eco-friendly ultra-high performance concrete with low autogenous shrinkage

2021 ◽  
pp. 130105
Author(s):  
Guosheng Ren ◽  
Bin Yao ◽  
Miao Ren ◽  
Xiaojian Gao
Keyword(s):  
High Performance ◽  
High Performance Concrete ◽  
Autogenous Shrinkage ◽  
Ultra High Performance Concrete ◽  
Sisal Fibers

Evaluation of Setting Time in Ultra High Performance Concrete

2012 ◽  
Vol 525-526 ◽  
pp. 621-624
Author(s):  
Sung Wook Kim ◽  
Jung Jun Park ◽  
Doo Youl Yoo ◽  
Young Soo Yoon
Keyword(s):  
High Performance ◽  
High Performance Concrete ◽  
Setting Time ◽  
Autogenous Shrinkage ◽  
High Strength ◽  
Initial Crack ◽  
Test Method ◽  
Plastic State ◽  
Ultra High Performance Concrete ◽  
Confining Stress

Ultra high performance concrete (UHPC), characterized by a high strength and high ductility, is also subjected to large shrinkage due to its low water-to-binder ratio and its large content in high fineness materials. The large amount of autogenous shrinkage of UHPC can induce crack on structural member when it was restrained with reinforcement and form. However, shrinkage of UHPC in plastic state is not generating confining stress, which is the main cause of initial crack. Normally, the setting time in concrete is an index to distinguish shrinkage which occur confining stress or not. An estimation of setting time is conducted in compliance with ASTM C 403 till now however, that test standard reveals error of results due to discordance of test condition as following with concrete type. This study therefore evaluated setting time of UHPC through the modified test method which was proposed by KICT. Test results and analyses proved a discrepancy of setting time between ASTM and proposed method. The proposed method put faith in evaluation of setting time in accordance with UHPC.

Mechanical Properties and Durability of Ultra-High Performance Concrete Incorporating Coarse Aggregate

2014 ◽  
Vol 629-630 ◽  
pp. 96-103 ◽  
Author(s):  
Juan Yang ◽  
Gai Fei Peng ◽  
Yu Xin Gao ◽  
Hui Zhang
Keyword(s):  
Compressive Strength ◽  
High Performance ◽  
Coarse Aggregate ◽  
High Performance Concrete ◽  
Fresh Concrete ◽  
Raw Materials ◽  
Autogenous Shrinkage ◽  
Mineral Admixtures ◽  
Ultra High Performance Concrete ◽  
Spalling Failure

Ultra-high performance concrete (UHPC) incorporating coarse aggregate was prepared with common raw materials. Fresh concrete had excellent good workability with slump of 265 mm and slump spread of 673 mm. Compressive strength of UHPC at 56 d reached 150 MPa. However, UHPC exhibited high brittleness in terms of spalling failure which occurred during compression loading.The ratio of splitting tensile strength to compressive strength of about 1/18 and the ratio of flexural strength to compressive strength of about 1/14 at 56 d were also associated with the brittleness of UHPC in this research. Mineral admixtures and fluidity of fresh concrete influenced compressive strength of UHPC significantly. Moreover, UHPC had excellent permeation-related durability but considerable shrinkage. Autogenous shrinkage of UHPC was less than half of free shrinkage, for which the reason is unknown and needs further research.

scholarly journals Mechanical Performance and Microstructure of Ultra-High-Performance Concrete Modified by Calcium Sulfoaluminate Cement

2021 ◽  
Vol 2021 ◽  
pp. 1-9
Author(s):  
Meimei Song ◽  
Chuanlin Wang ◽  
Ying Cui ◽  
Qiu Li ◽  
Zhiyang Gao
Keyword(s):  
Compressive Strength ◽  
High Performance ◽  
Mechanical Performance ◽  
High Performance Concrete ◽  
Autogenous Shrinkage ◽  
Ultra High Performance Concrete ◽  
Maximum Heat ◽  
Degree Of Hydration ◽  
Calcium Sulfoaluminate ◽  
Shrinkage Property

High autogenous shrinkage property is one of the disadvantages of ultra-high-performance concrete (UHPC), which may induce early age cracking and threaten the safety of concrete structure. In the present study, different dosages of calcium sulfoaluminate (CSA) cement were added in UHPC as an effective expansive binder. Hydration mechanism, autogenous shrinkage property, and compressive strength of UHPC were carried out to investigate the effect of CSA addition on the mechanical properties of UHPC. Scanning electron microscopy was also employed to characterize the intrinsic microstructural reasons relating to the changes in macroproperties. Based on the XRD diagram, increasing formation of ettringite and Ca(OH)2 can be found with increasing CSA content up to 15%. In the heat flow results of UHPC with 10% CSA addition, the maximum heat release increases to 2.6 mW/g, which is 8.3% higher than the reference UHPC, suggesting a higher degree of hydration with CSA addition. The results in autogenous shrinkage show that CSA expansion agent plays a significantly beneficial role in improving the autogenous shrinkage of UHPC. The corresponding autogenous shrinkage of UHPC is −59.66 μ ε , −131.11 μ ε , and −182.31 μ ε , respectively, at 7 d with 5%, 10%, and 15% addition, which is 108%, 117%, and 123% reduction compared to the reference specimen without CSA. In terms of compressive strength, UHPC with 5%, 10%, 15%, and 20% CSA addition has 10.5%, 17.4%, 30.2%, and 22.1% higher compressive strength than that for the reference UHPC at 28 d. Microstructural study shows that there is an extremely dense microstructure in both the bulk matrix and interfacial transition zone of UHPC with 10% CSA addition, which can be attributed to the higher autogenous shrinkage property and can therefore result in higher mechanical performance.

Experimental investigation on the autogenous shrinkage of steam cured ultra-high performance concrete

2018 ◽  
Vol 162 ◽  
pp. 512-522 ◽  
Author(s):  
Peiliang Shen ◽  
Linnu Lu ◽  
Yongjia He ◽  
Meijuan Rao ◽  
Zedong Fu ◽  
...  
Keyword(s):  
Experimental Investigation ◽  
High Performance ◽  
High Performance Concrete ◽  
Autogenous Shrinkage ◽  
Ultra High Performance Concrete

The Influence of Chemical Admixtures on the Autogenous Shrinkage Ultra-High Performance Concrete

2010 ◽  
Vol 452-453 ◽  
pp. 725-728 ◽  
Author(s):  
Jung Jun Park ◽  
Sung Wook Kim ◽  
Gum Sung Ryu ◽  
Kwang Myung Lee
Keyword(s):  
High Performance ◽  
High Performance Concrete ◽  
Autogenous Shrinkage ◽  
Pulse Velocity ◽  
Reducing Agent ◽  
Shrinkage Stress ◽  
Early Age ◽  
Ultra High Performance Concrete ◽  
Expansive Additive ◽  
Shrinkage Reducing Agent

Ultra-high performance concrete (UHPC) is a material developing remarkable performance with compressive strength of about 200 MPa and flexural strength of approximately 30 MPa on which research is actively conducted today. However, UHPC is also characterized by a mixing composed of a high specific quantity of binder that is a W/B ratio of about 0.2, which requires to examine the effects of the autogenous shrinkage. Accordingly, this study investigates the effects of the use of expansive additive and water reducing agent on the autogenous shrinkage of UHPC at early age. To that goal, autogenous shrinkage test and ultrasonic pulse velocity (UPV) monitoring are conducted for a mixing of UHPC using expansive additive and shrinkage reducing agent. The experimental results reveal that the autogenous shrinkage of UHPC reduces by 24% for a mix of UHPC adopting both 7.5% of expansive additive and 1% of shrinkage reducing agent compared to the mix without admixture. Furthermore, this mix is seen to compensate the autogenous shrinkage occurring at early age when UHPC develops its largest stiffness in view of the UPV evolution curve. At that time, the shrinkage stress seems to be extremely softened.

Sign in / Sign up

Export Citation Format

Share Document