Electroluminescence near interfaces between (Ca,Sr)TiO3:Pr phosphor and SnO2:Sb transparent conductor thin films prepared by sol–gel and spin-coating methods

2014 ◽  
Vol 149 ◽  
pp. 133-137 ◽  
Author(s):  
Tôru Kyômen ◽  
Minoru Hanaya ◽  
Hiroshi Takashima
2015 ◽  
Vol 643 ◽  
pp. 33-37 ◽  
Author(s):  
Tôru Kyômen ◽  
Sayaka Hasuko ◽  
Minoru Hanaya ◽  
Hiroshi Takashima

Oxide inorganic electroluminescent device in which thin films of Pr-doped NaNbO3 phosphor and Sb-doped SnO2 transparent conductor are alternately stacked was prepared by sol-gel and spin-coating methods. Red electroluminescence was observed due to f-f transitions of Pr3+ ions by applying 5-kHz ac voltages to the device. The luminance was 1.0 cd m−2 at 25 V ac and5.0 cd m−2 at 34 V ac.


2016 ◽  
Vol 698 ◽  
pp. 60-65 ◽  
Author(s):  
Tôru Kyômen ◽  
Miyu Seki ◽  
Minoru Hanaya ◽  
Hiroshi Takashima

Powder samples of (Ca,Sr)TiO3:Er were prepared by a solid-state reaction method. Photoluminescence due to f-f transitions of Er3+ was not induced by band-gap excitation of (Ca,Sr)TiO3 but by f-f transitions of Er3+. An electroluminescent device in which thin films of Ca0.6Sr0.4TiO3:Er and SnO2:Sb are stacked alternately was prepared by sol-gel and spin-coating methods. Very weak electroluminescence due to f-f transition of Er3+ was observed in the device.


2019 ◽  
Vol 7 (1) ◽  
pp. 28
Author(s):  
KOMARAIAH DURGAM ◽  
RADHA EPPA ◽  
REDDY M. V. RAMANA ◽  
KUMAR J. SIVA ◽  
R. SAYANNA ◽  
...  

Author(s):  
Atefeh Nazari Setayesh ◽  
Hassan Sedghi

Background: In this work, CdS thin films were synthesized by sol-gel method (spin coating technique) on glass substrates to investigate the optical behavior of the film. Methods: Different substrate spin coating speeds of 2400, 3000, 3600 rpm and different Ni dopant concentrations of 0 wt.%, 2.5 wt.%, 5 wt.%) were investigated. The optical properties of thin films such as refraction index, extinction coefficient, dielectric constant and optical band gap energy of the layers were discussed using spectroscopic ellipsometry method in the wavelength range of 300 to 900 nm. Results: It can be deduced that substrate rotation speed and dopant concentration has influenced the optical properties of thin films. By decreasing rotation speed of the substrate which results in films with more thicknesses, more optical interferences were appeared in the results. Conclusion: The samples doped with Ni comparing to pure ones have had more optical band gap energy.


Author(s):  
Ibrahim Mohd Yazid ◽  
Muhammad Hazim Raselan ◽  
Shafinaz Sobihana Shariffudin ◽  
Puteri Sarah Mohamad Saad ◽  
Sukreen Hana ◽  
...  

2020 ◽  
Author(s):  
A. Amali Roselin ◽  
N. Anandhan ◽  
I. Joseph Paneer Doss ◽  
G. Gopu ◽  
K. P. Ganesan ◽  
...  

2008 ◽  
Vol 2008 ◽  
pp. 1-5 ◽  
Author(s):  
Mohammad Hossein Habibi ◽  
Mohammad Khaledi Sardashti

Glass plate-supported nanostructure ZnO thin films were deposited by sol-gel spin coating. Films were preheated at275∘Cfor 10 minutes and annealed at 350, 450, and550∘Cfor 80 minutes. The ZnO thin films were transparent ca 80–90% in visible range and revealed that absorption edges at about 370 nm. Thec-axis orientation improves and the grain size increases which was indicated by an increase in intensity of the (002) peak at34.4∘in XRD corresponding to the hexagonal ZnO crystal. The photocatalytic degradation of X6G an anionic monoazo dye, in aqueous solutions, was investigated and the effects of some operational parameters such as the number of layer and reusability of ZnO nanostructure thin film were examined. The results showed that the five-layer coated glass surfaces have a very high photocatalytic performance.


Sign in / Sign up

Export Citation Format

Share Document