AbstractObjective:Regenerative bioprostheses are being investigated for replacement of dysfunctional myocardium worldwide. The aim of this study was to develop a degradable magnesium structure to mechanically support the delicate biological grafts during the early remodeling phase.Methods:Sheets of magnesium alloys (LA33, LA63 and AX30) were manufactured into scaffolds by abrasive water jet cutting. Thereafter, their surface properties, corrosion kinetics, and breakage behaviors were investigated.Results:The magnesium alloy LA63 sheets proved superior to the other alloys in terms of load cycles (lc) until break of the specimens (LA63: >10 Mio lc; AX30: 676,044±220,016 lc; LA33: 423,558±210,063 lc; p<0.01). Coating with MgF led to better protection than coating with MagPass. Less complex, yet sufficiently flexible scaffolds were less prone to early breakage. A slow traverse rate during water jet cutting resulted in the lowest burr, but in a widening of the kerf width from 615±11 μm at 500 mm/min to 708±33 μm at 10 mm/min (p<0.01).Conclusion:The findings on alloy composition, coating, structural geometry and manufacturing parameters constitute a basis for clinically applicable magnesium scaffolds. The use of stabilized, regenerative myocardium prostheses could save the patients from severe morbidity and eventually death.
Effect of process parameters on depth of penetration and topography of AZ91 magnesium alloy in abrasive water jet cutting
