Depositional processes and stratigraphic architecture within a coarse-grained rift-margin turbidite system: The Wollaston Forland Group, east Greenland

2016 ◽  
Vol 76 ◽  
pp. 187-209 ◽  
Author(s):  
Gijs A. Henstra ◽  
Sten-Andreas Grundvåg ◽  
Erik P. Johannessen ◽  
Thomas B. Kristensen ◽  
Ivar Midtkandal ◽  
...  
2021 ◽  
Author(s):  
Miquel Poyatos-Moré ◽  
Ernesto Schwarz ◽  
Salvador Boya ◽  
Luz Elena Gomis-Cartesio ◽  
Ivar Midtkandal

<p>Thick shallow-marine successions associated with long-term transgressions are less well known than their thin, well-sorted counterparts, widely studied due to their potential to form good reservoirs. In these successions, particularly in storm-dominated examples, bioturbation can obliterate primary sedimentary characteristics, making stacking patterns and sequences difficult to define, and challenging our understanding of the main controls in their resulting depositional architecture. This study presents an example from the Jurassic of the Neuquén Basin (Argentina), with the aim to: a) refine the depositional model of a thick, shallow-marine succession associated with a long-term, early post-rift transgression, b) constrain multi-scale controls on stratigraphic architecture and lateral facies variability, and c) discuss their preservation and response to post-depositional processes. To do this, a <300 m-thick succession has been studied along a >10 km continuous exposure, with mapping, sedimentary logging and correlation of stratigraphic units, integrated with subsurface, biostratigraphic and ichnological data. The succession shows an overall retrogradational-aggradational-retrogradational stacking pattern, with several higher frequency regressive units (parasequences and parasequence sets, PSS). The lower part (PSS I) comprises laterally-discontinuous (10's of m) mouth-bars and distributary channel fills, dominated by several m-thick coarsening- and fining-up sandstone packages and m-scale erosive conglomeratic lenses. Above these, the succession (PSS II-IV) is composed by laterally-continuous (>100's of m) storm-dominated lower-shoreface to upper-offshore deposits, dominated by <1m-thick fine-grained and highly bioturbated tabular muddy sandstones and sandy mudstones, with rarely-preserved HCS and bioclastic-rich limestones; their internal characteristics and bed boundaries are diffuse due to pervasive bioturbation, suggesting overall low sedimentation rates and recurrent periods of colonization. The coarse-grained nature and lithology of the mouth bars and channel fills in the lower succession (PSS I) are consistent with a proximal sediment source, associated with erosion of intra-basinal highs. Its variable thickness, lateral distribution and onlap against underlying syn-rift deposits demonstrates partial infill of localized higher-accommodation areas. The well-sorted and finer-grained nature of the shoreface-offshore strata the middle and upper succession (PSS II-IV) indicates a more mature, distal source, with sediment redistributed by longshore currents, and then intensely bioturbated. These deposits display well-defined parasequences internally composed of laterally-continuous bedsets (<5 m-thick). They extend along the entire study area, but show a significant vertical thickness variability. The integration of outcrop and subsurface data mapping (well and seismic) reveals this variability records the stratigraphic response of transgression over a complex, regional-scale ramp-step and underfilled rift topography, which controlled the location of main thickness and facies changes, and promoted areas of favored biogenic reworking. This study offers new insights in how to interpret thick transgressive successions based on primary depositional mechanisms and postdepositional processes, and provides useful tools to understand and predict the nature and potential preservation of these deposits in limited subsurface datasets.</p>


1991 ◽  
Vol 38 ◽  
pp. 145-151
Author(s):  
C. K. Brooks

Tue Kræmer Ø syenite, situated close to the Skaergaard intrusion, is typical of many oversturated syenites in the area. It consists of a maginal breccia with a sharp contact to the surrounding gneisses. This breccia, about 150 m wide is made up of basaltic clasts in a granitic matrix. It is associated with pegmatites, aplites and granophyres, all with a non-peralkaline characters. Tue main part of the syenite is a coarse-grained, massively jointed body with many large basic xenoliths and occasional modal layering. It is associated with peralkaline rhyolitic dikes and pegmatites. Anatexis of basement and crystal differentiation from a basaltic magma are thought to be unlikely processes to explain the origin of the syenites although the breccia matrix appears to be a simple partial melt of the gneisses. It is postulated thai such an anatectic melt, formed by heat transfer from basaltic magmas, becomes modified by diffusive interchange with the basaltic melt to generate the syenite in the way described for a nearby locality by Nielsen & Brooks (1988).


2018 ◽  
Vol 69 (1) ◽  
pp. 89-113 ◽  
Author(s):  
Slavomír Nehyba

AbstractTwo coarse-grained Gilbert-type deltas in the Lower Badenian deposits along the southern margin of the Western Carpathian Foredeep (peripheral foreland basin) were newly interpreted. Facies characterizing a range of depositional processes are assigned to four facies associations — topset, foreset, bottomset and offshore marine pelagic deposits. The evidence of Gilbert deltas within open marine deposits reflects the formation of a basin with relatively steep margins connected with a relative sea level fall, erosion and incision. Formation, progradation and aggradation of the thick coarse-grained Gilbert delta piles generally indicate a dramatic increase of sediment supply from the hinterland, followed by both relatively continuous sediment delivery and an increase in accommodation space. Deltaic deposition is terminated by relatively rapid and extended drowning and is explained as a transgressive event. The lower Gilbert delta was significantly larger, more areally extended and reveals a more complicated stratigraphic architecture than the upper one. Its basal surface represents a sequence boundary and occurs around the Karpatian/Badenian stratigraphic limit. Two coeval deltaic branches were recognized in the lower delta with partly different stratigraphic arrangements. This different stratigraphic architecture is mostly explained by variations in the sediment delivery and /or predisposed paleotopography and paleobathymetry of the basin floor. The upper delta was recognized only in a restricted area. Its basal surface represents a sequence boundary probably reflecting a higher order cycle of a relative sea level rise and fall within the Lower Badenian. Evidence of two laterally and stratigraphically separated coarse-grained Gilbert deltas indicates two regional/basin wide transgressive/regressive cycles, but not necessarily of the same order. Provenance analysis reveals similar sources of both deltas. Several partial source areas were identified (Mesozoic carbonates of the Northern Calcareous Alps and the Western Carpathians, crystalline rocks of the eastern margin of the Bohemian Massif, older sedimentary infill of the Carpathian Foredeep and/or the North Alpine Foreland Basin, sedimentary rocks of the Western Carpathian/Alpine Flysch Zone).


2016 ◽  
Vol 37 (4) ◽  
pp. 435-456 ◽  
Author(s):  
Katarzyna Skolasińska ◽  
Grzegorz Rachlewicz ◽  
Witold Szczuciński

AbstractTextural properties and microstructures are commonly used properties in the analysis of Pleistocene and older glacial deposits. However, contemporary glacial deposits are seldom studied, particularly in the context of post-depositional changes. This paper presents the results of a micromorphological study of recently deposited tills in the marginal zones of Hansbreen and Torellbreen, glaciers in southwestern Spitsbergen. The main objectives of this study were to compare modern tills deposited in subglacial and supraglacial conditions, as well as tills that were freshly released from ice with those laid down several decades ago. The investigated tills are primarily composed of large clasts of metamorphic rocks and represent coarse-grained, matrix-supported diamictons. The tills reveal several characteristic features for ductile (e.g.turbate structures) and brittle (e.g.lineations, microshears) deformations, which have been considered to be indicative of subglacial conditions. In supraglacial tills, the same structures are common as in the subglacial deposits, which points to the preservation of the primary features, though the sediment was transferred up to the glacier surface due to basal ice layer deformation and redeposited as slumps, or to formation of similar structures due to short-distance sediment re-deposition by mass flows. This study revealed that it might not be possible to distinguish subglacial and supraglacial tills on the basis of micromorphology if the latter are derived from a subglacial position. The only noted difference was the presence of iron oxide cementation zones and carbonate dissolution features in supraglacial tills. These features were found in tills that were deposited at least a few years ago and are interpreted to be induced by early post-depositional processes involving porewater/sediment interactions.


2020 ◽  
Vol 90 (12) ◽  
pp. 1678-1705
Author(s):  
Kévin Boulesteix ◽  
Miquel Poyatos-Moré ◽  
David M. Hodgson ◽  
Stephen S. Flint ◽  
Kevin G. Taylor

ABSTRACT Mud dominates volumetrically the fraction of sediment delivered and deposited in deep-water environments, and mudstone is a major component of basin-floor successions. However, studies of basin-floor deposits have mainly focused on their proximal sandstone-prone part. A consequent bias therefore remains in the understanding of depositional processes and stratigraphic architecture in mudstone-prone distal settings beyond the sandstone pinchouts of basin-floor fans. This study uses macroscopic and microscopic descriptions of over 500 m of continuous cores from research boreholes from the Permian Skoorsteenberg Formation of the Karoo Basin, South Africa, to document the sedimentology, stratigraphy, and ichnology of a distal mudstone-prone basin-floor succession. Very thin- to thin-bedded mudstones, deposited by low-density turbidity currents, stack to form bedsets bounded by thin packages (< 0.7 m thick) of background mudstones. Genetically related bedsets stack to form bedset packages, which are bounded by thicker (> 0.7 m thick) background mudstones. Stratigraphic correlation between cores suggests that bedsets represent the distal fringes of submarine fan lobe elements and/or lobes, and bedset packages represent the distal fringes of lobe complexes and/or lobe complex sets. The internal stacking pattern of bedsets and bedset packages is highly variable vertically and laterally, which records dominantly autogenic processes (e.g., compensational stacking, avulsion of feeder channels). The background mudstones are characterized by remnant tractional structures and outsize particles, and are interpreted as deposited from low-density turbidity currents and debris flows before intense biogenic reworking. These observations challenge the idea that mud accumulates only from hemipelagic suspension fallout in distal basin-floor environments. Thin background mudstones separating bedsets (< 0.7 m thick) are interpreted to mainly represent autogenically driven lobe abandonment due to up-dip channel avulsion. The thicker background mudstones separating bedset packages (> 0.7 m thick) are interpreted to dominantly mark allogenically driven regional decrease of sand supply to the basin floor. The recognition of sandstone-prone basin-floor fans passing into genetically linked distal fringe mudstones suggests that submarine lobes are at least ∼ 20 km longer than previously estimated. This study provides sedimentological, stratigraphic, and ichnological criteria to differentiate mudstones deposited in different sub-environments in distal deep-water basin-floor settings, with implications for the accurate characterization of basin-floor fan architecture, and their use as archives of paleoenvironmental change.


2018 ◽  
Vol 164 ◽  
pp. 52-64 ◽  
Author(s):  
Willem G.M. van der Bilt ◽  
Brice Rea ◽  
Matteo Spagnolo ◽  
Desiree L. Roerdink ◽  
Steffen L. Jørgensen ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document