Modal parameters estimation of an electrical submersible pump installed in a test well using numerical and experimental analysis

2019 ◽  
Vol 176 ◽  
pp. 1-7 ◽  
Author(s):  
M.A. Castillo ◽  
R.H.R. Gutiérrez ◽  
U.A. Monteiro ◽  
R.S. Minette ◽  
L.A. Vaz
2019 ◽  
Vol 10 ◽  
pp. 82-86
Author(s):  
A.N. Ivanov ◽  
◽  
V.A. Bondarenko ◽  
M.M. Veliev ◽  
E.V. Kudin ◽  
...  

2021 ◽  
Vol 229 ◽  
pp. 108975
Author(s):  
R.H.R. Gutiérrez ◽  
U.A. Monteiro ◽  
C.O. Mendonça

2014 ◽  
Vol 226 (6) ◽  
pp. 1673-1687 ◽  
Author(s):  
Mousa Rezaee ◽  
Gholamreza Fattahi Yam

2012 ◽  
Author(s):  
Hua Yang ◽  
Idaku Ishii ◽  
Takeshi Takaki

2021 ◽  
Author(s):  
Mohd Hafizi Ariffin ◽  
Muhammad Idraki M Khalil ◽  
Abdullah M Razali ◽  
M Iman Mostaffa

Abstract Most of the oil fields in Sarawak has already producing more than 30 years. When the fields are this old, the team is most certainly facing a lot of problems with aging equipment and facilities. Furthermore, the initial stage of platform installation was not designed to accommodate a large space for an artificial lift system. Most of these fields were designed with gas lift compressors, but because of the space limitation, the platforms can only accommodate a limited gas lift compressor capacity due to space constraints. Furthermore, in recent years, some of the fields just started with their secondary recovery i.e. water, gas injection where the fluid gradient became heavier due to GOR drop or water cut increases. With these limitations and issues, the team needs to be creative in order to prolong the fields’ life with various artificial lift. In order to push the limits, the team begins to improve gas lift distribution among gas lifted wells in the field. This is the cheapest option. Network model recommends the best distribution for each gas lifted wells. Gas lifted wells performance highly dependent on fluid weight, compressor pressure, and reservoir pressure. The change of these parameters will impact the production of these wells. Rigorous and prudent data acquisitions are important to predict performance. Some fields are equipped with pressure downhole gauges, wellhead pressure transmitters, and compressor pressure transmitters. The data collected is continuous and good enough to be used for analysis. Instead of depending on compressor capacity, a high-pressure gas well is a good option for gas lift supply. The issues are to find gas well with enough pressure and sustainability. Usually, this was done by sacrificing several barrels of oil to extract the gas. Electrical Submersible Pump (ESP) is a more expensive option compared to a gas lift method. The reason is most of these fields are not designed to accommodate ESP electricity and space requirements. Some equipment needs to be improved before ESP installation. Because of this, the team were considering new technology such as Thru Tubing Electrical Submersible Pump (TTESP) for a cheaper option. With the study and implementation as per above, the fields able to prolong its production until the end of Production Sharing Contract (PSC). This proactive approach has maintained the fields’ production with The paper seeks to present on the challenges, root cause analysis and the lessons learned from the subsequent improvement activities. The lessons learned will be applicable to oil fields with similar situations to further improve the fields’ production.


2008 ◽  
Vol 52 (01) ◽  
pp. 45-56
Author(s):  
Giuliano Coppotelli ◽  
Daniele Dessi ◽  
Riccardo Mariani ◽  
Marcello Rimondi

The study of the ship structural response assumes an increasing importance as soon as the structures, characterized by much more lightness, are designed and built for faster vessels. This requisite implies a greater flexibility of the structures themselves, the elastic response of which has to be evaluated with accuracy in order to predict the dynamic behavior. In the present paper, a methodology for the identification of the modal parameters from the measurement of only the responses of a vibrating structure has been developed and applied to an elastically scaled model. This output-only technique is successfully applied to the segmented model of a real ship towed in the INSEAN linear basin. The broadband random excitation, provided by the loads exerted by an irregular sea pattern, induces a stochastic response of the model, which is monitored with accelerometers. The obtained results not only outline the parametric dependence of the modal properties on the ship speed, but also suggest a possible practical application of this technique for on-board structural monitoring and fatigue-life prediction.


2021 ◽  
Author(s):  
Abdullatif Al-Majdli ◽  
Carlos Caicedo Martinez ◽  
Sarah Al-Dughaishem

Abstract Oil production in North Kuwait (NK) asset highly relies on artificial lift systems. The predominant method of artificial lift in NK is electrical submersible pump (ESP). Corrosion is one of the major issues for wells equipped with ESP in NK field. Over 20% of the all pulled ESPs in 2019 and 2020 in NK field were due to corrosion of the completion or the ESP string. With an increase in ESP population in NK, a proactive corrosion mitigation is essential to reduce the number of ESP wells requiring workover. Historic data of the pulled ESPs in NK revealed that most of the corrosion cases were found in the tubing as opposed to the ESP components. Although there are multiple factors that can cause corrosion in NK, the driving force was identified to be the presence of CO2 (sweet corrosion). Corrosion rates have been enhanced by other factors such as stray current and galvanic couples. In this paper, multiple methods have been suggested to minimize and prevent the corrosion issue such as selecting the optimal completion and ESP metallurgy (ex. corrosion resistant alloy), installing internally glass reinforced epoxy lined carbon steel tubing, and installing a sacrificial anode whenever applicable.


Sign in / Sign up

Export Citation Format

Share Document