scholarly journals Influence of scour protection layers on the lateral response of monopile in dense sand

2022 ◽  
Vol 244 ◽  
pp. 110377
Author(s):  
Amin Askarinejad ◽  
Huan Wang ◽  
Giorgos Chortis ◽  
Ken Gavin
2018 ◽  
Vol 4 (9) ◽  
pp. 1996 ◽  
Author(s):  
Muqdad Abdallah Kahribt ◽  
Jasim M. Abbas

According to practical situation, there have been limited investigations on the response of piles subjected to combined loadings especially when subjected to cyclic lateral loads. Those few studies led to contradictory results with regard to the effects of vertical loads on the lateral response of piles. Therefore, a series of experimental investigation into piles in dense sand subjected to combination of static vertical and cyclic lateral loading were conducted with instrumented model piles. The effect of the slenderness ratio (L/D) was also considered in this study (i.e. L/D= 25 and 40). In addition, a variety of two-way cyclic lateral loading conditions were applied to model piles using a mechanical loading system. One hundred cycles were used in each test to represent environmental loading such as offshore structures. It was found that under combined vertical and cyclic lateral loads the lateral displacement of piles decreased with an increase in vertical load whereas it causes large vertical displacements at all slenderness ratios. In addition, for all loading conditions the lateral, vertical (settlement and upward) displacements and bending moments increased as either the magnitude of cyclic load or the number of cycles increases. 


Géotechnique ◽  
2021 ◽  
pp. 1-34
Author(s):  
Zhong-Sen Li ◽  
Matthieu Blanc ◽  
Luc Thorel

Two model piles with outer diameter D = 50 mm are loaded laterally at 100×g in a large-beam geotechnical centrifuge. The normal strains on both the tensile and compressive sides are measured using fibre Bragg gratings. An incremental method is introduced to define the pivot point. The testing and analytical program enables the effect of the embedding depth and load eccentricity to be quantified. The key findings are as follows. 1) The piles generate asymmetric tensile and compressive strains during bending, and the tension-compression asymmetry becomes more pronounced at the pile toe and for shorter piles. 2) The piles transition from flexure to rotation as the embedding depth is decreased from 9D to 3D, where the uniqueness of the ground-level rotation and deflection (θg–yg) relationship disappears. 3) The reaction and deflection (P–y) relationship flattens with increasing embedding depth but seems independent of the load eccentricity.


2011 ◽  
Vol 1 (3) ◽  
pp. 13-17
Author(s):  
Jasim M Abbas
Keyword(s):  

2021 ◽  
Vol 239 ◽  
pp. 112278
Author(s):  
Jixing Cao ◽  
Haibei Xiong ◽  
S. Farid Ghahari ◽  
Ertugrul Taciroglu

Sign in / Sign up

Export Citation Format

Share Document