Frost fatigue and its spring recovery of xylem conduits in ring-porous, diffuse-porous, and coniferous species in situ

2020 ◽  
Vol 146 ◽  
pp. 177-186 ◽  
Author(s):  
Yongxin Dai ◽  
Lin Wang ◽  
Xianchong Wan
2004 ◽  
Vol 80 (5) ◽  
pp. 612-616 ◽  
Author(s):  
Jean-Martin Lussier ◽  
Roger Gagné ◽  
Gilles Bélanger

This paper presents a method for preparing wood sections and reading tree rings in diffuse-porous hardwoods that is more efficient than the standard sanding method. The planning of fresh samples and the use of an ultraviolet light source in conjunction with a fluorescent dye reduced the preparation time by 39%. No significant differences were found between the two methods for the time needed for ring count. The fluorescent method can be used for both wood sections and cores, and it can be applied to coniferous species. Key words: dendrochronology, tree ring analysis, diffuse-porous hardwoods, fluorescence, Acer, Betula


2015 ◽  
Author(s):  
Jane R Foster

Defoliation outbreaks are biological disturbances that alter tree growth and mortality in temperate forests. Trees respond to defoliation in many ways; some recover rapidly, while others decline gradually or die. These differences may arise from species functional traits that constrain growth such as xylem anatomy, growth phenology or non-structural carbohydrate (NSC) storage, but this has not been shown. Although many studies address these phenomena, varied and idiosyncratic measures limit our ability to generalize and predict defoliation responses across species. I synthesized and translated published growth and mortality data into consistent standardized variables suitable for numerical models. I analyzed data from 32 studies, including 16 tree species and 10 defoliator systems from North America and Eurasia, and quantitatively compared responses to defoliation among species and tree functional groups using linear mixed-effects models. Relative growth decreased linearly or curvilinearly as defoliation stress accumulated across species. Growth decreased by only 5-20% following 100% defoliation in ring-porousQuercus, whereas growth of diffuse-porous hardwoods and conifers declined by 50-100%. Mortality increased exponentially with defoliation, more rapidly forPinusand diffuse-porous species than forQuercusandAbies. Species-specific mixed models were best (R2c = 0.83-0.94), yet functional-group models lost little in terms of goodness-of-fit (R2c = 0.72-0.92), providing useful alternatives when species data is lacking. These responses are consistent with functional differences in wood growth phenology and NSC storage. Ring-porous spring xylem growth precedes budburst. Defoliators whose damage follows foliar development can only affect development of later wood. Growth of diffuse-porous and coniferous species responds more drastically, yet differences in NSC storage make them more vulnerable to mortality as stress accumulates. Ring-porous species resist defoliation-related changes in growth and mortality more than diffuse-porous and coniferous species. These findings apply in general to disturbances that cause spring defoliation and should be incorporated into forest vegetation models.


1986 ◽  
Vol 64 (11) ◽  
pp. 2524-2537 ◽  
Author(s):  
D. C. Hoppe ◽  
M. E. McCully ◽  
C. L. Wenzel

The framework of the root system of a mature, field-grown corn plant of variety Seneca Chief consists of about 70 axile roots. One of these is the primary root. The others develop on the stem, a single tier at each of the seven basal nodes. Just over half of these roots grow out at or above ground level from nodes 6 and 7 late in the development of the plant, with those of node 7 entering the soil just before flowering. The mean diameter of the root produced at successively higher nodes increases, as does also the mean number of large metaxylem elements seen in a cross section, so that about 75% of the large xylem conduits between the root system and the stem are in the roots of the two uppermost tiers. Nodal root primordia develop initially in situ from an extensive region of dedifferentiated stem cortex. A sleeve-like extension of the stem encloses the base of each root formed at aerial nodes. At each node the complexity of vascular interconnections results in all of the framework roots being indirectly linked to each other and to the vascular traces from all of the leaves.


1984 ◽  
Vol 75 ◽  
pp. 743-759 ◽  
Author(s):  
Kerry T. Nock

ABSTRACTA mission to rendezvous with the rings of Saturn is studied with regard to science rationale and instrumentation and engineering feasibility and design. Future detailedin situexploration of the rings of Saturn will require spacecraft systems with enormous propulsive capability. NASA is currently studying the critical technologies for just such a system, called Nuclear Electric Propulsion (NEP). Electric propulsion is the only technology which can effectively provide the required total impulse for this demanding mission. Furthermore, the power source must be nuclear because the solar energy reaching Saturn is only 1% of that at the Earth. An important aspect of this mission is the ability of the low thrust propulsion system to continuously boost the spacecraft above the ring plane as it spirals in toward Saturn, thus enabling scientific measurements of ring particles from only a few kilometers.


Author(s):  
R. E. Herfert

Studies of the nature of a surface, either metallic or nonmetallic, in the past, have been limited to the instrumentation available for these measurements. In the past, optical microscopy, replica transmission electron microscopy, electron or X-ray diffraction and optical or X-ray spectroscopy have provided the means of surface characterization. Actually, some of these techniques are not purely surface; the depth of penetration may be a few thousands of an inch. Within the last five years, instrumentation has been made available which now makes it practical for use to study the outer few 100A of layers and characterize it completely from a chemical, physical, and crystallographic standpoint. The scanning electron microscope (SEM) provides a means of viewing the surface of a material in situ to magnifications as high as 250,000X.


Sign in / Sign up

Export Citation Format

Share Document