New insights on speleoseismology: The geothermal gradient and heat flow values in caves for the study of active faults

2017 ◽  
Vol 451 ◽  
pp. 165-175 ◽  
Author(s):  
R. Pérez-López ◽  
S. Martín-Velázquez ◽  
S. Sánchez-Moral ◽  
M. Patyniak ◽  
J. López-Gutiérrez ◽  
...  
Keyword(s):  
Heat Flow ◽  
Active Faults ◽  
Geothermal Gradient

scholarly journals Evaluation of geothermal energy resources in parts of southeastern sedimentary basin, Nigeria

2021 ◽  
Vol 23 (1) ◽  
pp. 195-211
Author(s):  
I.M. Okiyi ◽  
S.I. Ibeneme ◽  
E.Y. Obiora ◽  
S.O. Onyekuru ◽  
A.I. Selemo ◽  
...  
Keyword(s):  
Spectral Analysis ◽  
Heat Flow ◽  
Curie Point ◽  
Geothermal Energy ◽  
Sedimentary Basin ◽  
Geothermal Gradient ◽  
Geothermal System ◽  
Magnetic Vector ◽  
Geothermal Gradients ◽  
Vector Inversion

Residual aeromagnetic data of parts of Southeastern Nigerian sedimentary basin were reduced to the equator and subjected to magnetic vector inversion and spectral analysis. Average depths of source ensembles from spectral analysis were used to compute depth to magnetic tops (Z), base of the magnetic layer (Curie Point t Depth (CPD)), and estimate geothermal gradient and heat flow required for the evaluation of the geothermal resources of the study area. Results from spectral analysis showed depths to the top of the magnetic source ranging between 0.45 km and 1.90 km; centroid depths of 4 km - 7.87 km and CPD of between 6.15 km and 14.19 km. The CPD were used to estimate geothermal gradients which ranged from 20.3°C/km to 50.0°C/km 2 2 and corresponding heat flow values of 34.9 mW/m to 105 mW/m , utilizing an average thermal conductivity -1 -1 of 2.15 Wm k . Ezzagu (Ogboji), Amanator-Isu, Azuinyaba, Nkalagu, Amagunze, Nta-Nselle, Nnam, Akorfornor environs are situated within regions of high geothermal gradients (>38°C/Km) with models delineated beneath these regions using 3D Magnetic Vector Inversion, having dominant NW-SE and NE-SW trends at shallow and greater depths of <1km to >7 km bsl. Based on VES and 2D imaging models the geothermal system in Alok can be classified as Hot Dry Rock (HDR) type, which may likely have emanated from fracture systems. There is prospect for the development of geothermal energy in the study area. Keywords: Airborne Magnetics, Magnetic Vector Inversion, Geothermal Gradient, Heat Flow, Curie Point Depth, Geothermal Energy.

Inversion of bottom‐hole temperature data: The Pineview field, Utah‐Wyoming thrust belt

Geophysics ◽  
1988 ◽  
Vol 53 (5) ◽  
pp. 707-720 ◽  
Author(s):  
Dave Deming ◽  
David S. Chapman
Keyword(s):  
Thermal Conductivity ◽  
Temperature Field ◽  
Heat Flow ◽  
Random Noise ◽  
Synthetic Data ◽  
Element Model ◽  
Geothermal Gradient ◽  
Oil Field ◽  
Conductive Heat ◽  
Bottom Hole

The present day temperature field in a sedimentary basin is a constraint on the maturation of hydro‐carbons; this temperature field may be estimated by inverting corrected bottom‐hole temperature (BHT) data. Thirty‐two BHTs from the Pineview oil field are corrected for drilling disturbances by a Horner plot and inverted for the geothermal gradient in nine formations. Both least‐squares [Formula: see text] norm and uniform [Formula: see text] norm inversions are used; the [Formula: see text] norm is found to be more robust for the Pineview data. The inversion removes random error from the corrected BHT data by partitioning scatter between noise associated with the BHT measurement and correction processes and local variations in the geothermal gradient. Three‐hundred thermal‐conductivity and density measurements on drill cuttings are used, together with formation density logs, to estimate the in situ thermal conductivity of six of the nine formations. The thermal‐conductivity estimates are used in a finite‐element model to evaluate 2-D conductive heat refraction and, for a series of inversions of synthetic data, to assess the influence of systematic and random noise on the inversion results. A temperature‐anomaly map illustrates that a temperature field calculated by a forward application of the inversion results has less error than any single corrected BHT. Mean background heat flow at Pineview is found to be [Formula: see text] (±13 percent), but is locally higher [Formula: see text] due to heat refraction. The BHT inversion (1) is limited by systematic noise or model error, (2) achieves excellent resolution of a temperature field although resolution of individual formation gradients may be poor, and (3) generally cannot detect lateral variations in heat flow unless thermal‐conductivity structure is constrained.

A heat flow profile across the Sverdrup Basin, Canadian Arctic Islands

Geophysics ◽  
1989 ◽  
Vol 54 (2) ◽  
pp. 171-180 ◽  
Author(s):  
F. W. Jones ◽  
J. A. Majorowicz ◽  
A. F. Embry
Keyword(s):  
Heat Flow ◽  
Canadian Arctic ◽  
Ground Surface ◽  
Geothermal Gradient ◽  
Flow Profile ◽  
Heat Flows ◽  
Boundary Temperature ◽  
Sverdrup Basin ◽  
Base Boundary ◽  
Rock Analysis

An average geothermal gradient of 25 ± 5 mK/m and an average heat flow of [Formula: see text] have been determined for 16 out of 20 analyzed wells along a profile across the Sverdrup Basin in the Canadian Arctic. These estimates, based on deep bottom‐hole temperature (BHT) data from exploration wells and the permafrost base boundary temperature, together with assumed heat conductivities from net rock analysis, are surprisingly low and disagree with previously published results based on shallow data. The differences may be due to the dramatic changes in boundary temperature conditions from moderate subsea conditions to ground‐surface low temperatures as a result of marine regression. Because of these effects, it appears that deep BHT temperature data are valuable in providing information about the deep heat flow. The heat flows thus determined indicate that the basin has approached thermal equilibrium.

Geothermal gradient and heat flow in the radicofani region (East of Monte Amiata, Italy)

Geothermics ◽  
1970 ◽  
Vol 2 ◽  
pp. 443-449 ◽  
Author(s):  
P.D. Burgassi ◽  
P. Ceron ◽  
G.C. Ferrara ◽  
G. Sestini ◽  
B. Toro
Keyword(s):  
Heat Flow ◽  
Geothermal Gradient

scholarly journals Estimation of Geothermal Gradient and Heat Flow for Determination of Geothermal Energy Sources in Monguno Area of Northeastern Nigeria

2019 ◽  
pp. 1-8
Author(s):  
B. C. Udochukwu ◽  
M. Akiishi ◽  
A. A. Tyovenda
Keyword(s):  
Heat Flow ◽  
Curie Point ◽  
Geothermal Energy ◽  
Geothermal Gradient ◽  
High Heat ◽  
Curie Point Depth ◽  
The South ◽  
Geothermal Resources ◽  
North East ◽  
Curie Depth

The aeromagnetic data of Monguno area northeastern Nigeria have been used to estimate Curie point depth, geothermal gradients and heat flow using spectral analysis. These geothermal parameters were subsequently employed to identify areas of geothermal resources. First order polynomial fitting was applied in Regional-residual separation. The Curie point depth obtained in this area ranges from 10.318 to 24.476 km with an average of 13.387 km, the geothermal gradient of the area varies from 23.697 to 56.212°C /km, with an average of 46.195°C /km, while the heat flow ranges from 59.242 to 136.176 mWm-2, with an average value of about 112.364 mWm-2. It was also observed that the deepest Curie depth in the area is identified in the south, while the shallow depth is located in the northeast and spread toward the southwest. On the other hand, the highest geothermal gradient in the area is identified in the northern part of Moguno, while in the south,                    the lowest, geothermal gradient is located. The highest heat flow in the area is seen in the south-west and north-east, while the lowest heat flow is observed in the south. The high heat flow and geothermal gradient in the area show that geothermal energy could be found in Monguno region of the northeastern Nigeria.

scholarly journals High Gas Hydrate and Free Gas Concentrations: An Explanation for Seeps Offshore South Mocha Island

Energies ◽  
2018 ◽  
Vol 11 (11) ◽  
pp. 3062 ◽  
Author(s):  
Iván Vargas-Cordero ◽  
Umberta Tinivella ◽  
Lucía Villar-Muñoz ◽  
Joaquim Bento
Keyword(s):  
Gas Hydrate ◽  
Active Faults ◽  
Geothermal Gradient ◽  
Slope Instability ◽  
Cold Seeps ◽  
Supply Source ◽  
Hydrate Dissociation ◽  
Free Gas ◽  
The Past ◽  
Seismic Sections

Recent studies have reported cold seeps offshore of Mocha Island. Gas hydrate occurrences along the Chilean margin could explain seeps presence. Gas-phase (gas hydrate and free gas) and geothermal gradients were estimated analysing two seismic sections. Close to Mocha Island (up to 20 km) were detected high (up to 1900 m/s) and low (1260 m/s) velocities associated with high gas hydrate (up to 20% of total volume) and free gas (up to 1.1% of total volume) concentrations, respectively. A variable and high geothermal gradient (65–110 °C/km) was obtained. These results are related to high supply of deep fluids canalised by faults and fractures. Faraway from Mocha Island (>60 km), free gas concentrations decrease to 0.3% of total volume and low geothermal gradient (from 35 to 60 °C/km) are associated with low fluids supply. Finally, we propose gas hydrate dissociation processes as the main supply source for seeps in the vicinity of Mocha Island. These processes can be caused by: (a) active faults and seismic activity; and (b) warm fluid expulsion from deeper zones altering hydrate stability conditions. In both cases, gas hydrate dissociation could generate slope instability and landslides, as occurred in the past in this region and reported in the literature.

Sign in / Sign up

Export Citation Format

Share Document