Chronic impact of tetracycline on nitrification kinetics and the activity of enriched nitrifying microbial culture

2015 ◽  
Vol 72 ◽  
pp. 227-238 ◽  
Author(s):  
Tugce Katipoglu-Yazan ◽  
Christophe Merlin ◽  
Marie-Noëlle Pons ◽  
Emine Ubay-Cokgor ◽  
Derin Orhon
1996 ◽  
Vol 34 (5-6) ◽  
pp. 163-171 ◽  
Author(s):  
Celal F. Gökçay ◽  
Ulku Yetis

Biomass yield of microorganisms is important in applied microbiology since it is the ultimate factor determining the amount of product produced regardless of whether product is growth-linked or not. In the case of environmental microbiology the opposite is true and minimizing the biomass produced, or the sludge in the relevant jargon, often is the prime goal. In this paper, a unique means of manipulating the microbial biomass yield of a heterogeneous culture to fulfil either of the two goals is presented. 5.0 mgl−1 Ni(II) in the feed composition to a completely mixed, once- through, activated sludge was found to induce the observed biomass yield of the microbial culture developed from sewage. As compared with the base-line study without Ni(II), where the reactor received synthetic wastewater only, true biomass yield was found to have increased along with the increased decay constant with the net effect of lowering observed biomass yield drastically at lower dilution rates and increasing it over that observed in the base-line study at higher dilution rates. At 10.0 mgl−1 influent Ni(II) concentration the culture conditions almost reverted back to the base- line study and at 25 mgl−1 Ni(II) concentration a truly steady-state condition could not be attained.


2000 ◽  
Vol 42 (12) ◽  
pp. 189-200 ◽  
Author(s):  
G.-H. Chen ◽  
H.-K. Mo ◽  
S. Saby ◽  
W.-k. Yip ◽  
Y. Liu

Minimization of excess sludge production in activated sludge processes has been pursued around the world in order to meet stringent environmental regulations on sludge treatment and disposal. To achieve this goal, physical, chemical, and biological approaches have been proposed. In this paper, a chemical compound, 3,3′,4′,5-tetrachlorosalicylanilide (TCS) was tested for enhancing microbial energy spilling of the sludgeso as to minimize its growth. In order to examine this, an exploratory study was conducted using both batch and continuous activated sludge cultures. Batch experiments with these two cultures were carried out at different initial concentrations of TCS. It has been confirmed that an addition of TCS is effective in reducing the production of both the sludge cultures, particularly the continuous culture where the observed growth yield was reduced by around 70%, when the initial TCS concentration was 0.8 ppm. Meanwhile, the substrate removal activity of this culture was found not to be affected at this TCS concentration. To further evaluate the TCS effect, a pure microbial culture of E. coli was employed. Batch experiment results with this culture implied that TCS might be able to reduce the cell density of E. coli drastically when an initial TCS concentration was greater than 0.12 ppm. It was also found that TCS was not toxic to this type of bacteria. Microscopic examinations with a 4′, 6-diamidino-2-phenylindole (DAPI) staining technique revealed that TCS neither affected the cell division nor altered the cell size of E. coli. However, both the cell ATP content and the cell dry weight were reduced significantly with the addition of TCS.


2020 ◽  
Vol 10 (3) ◽  
pp. 200-207
Author(s):  
Sabbir Ansari ◽  
Tasneem Fatma

Background: Poly-3-hydroxybutyrate (PHB) has attracted much consideration as biodegradable biocompatible polymer. This thermoplastic polymer has comparable material properties to polypropylene. Materials with more valuable properties may result from blending, a common practice in polymer science. Objective: In this paper, blends of PHB (extracted from cyanobacterium Nostoc muscorum NCCU- 442 with polyethylene glycol (PEG) were investigated for their thermal, tensile, hydrophilic and biodegradation properties. Methods: Blends were prepared in different proportions of PHB/PEG viz. 100/0, 98/2, 95/5, 90/10, 80/20, and 70/30 (wt %) using solvent casting technique. Morphological properties were investigated by using Scanning Electron Microscopy (SEM). Differential scanning calorimetry and thermogravimetric analysis were done for thermal properties determination whereas the mechanical and hydrophilic properties of the blends were studied by means of an automated material testing system and contact angle analyser respectively. Biodegradability potential of the blended films was tested as percent weight loss by mixed microbial culture within 60 days. Results: The blends showed good misciblity between PEG and PHB, however increasing concentrations of plasticizer caused morphological alteration as evidenced by SEM micrographs. PEG addition (10 % and above) showed significant alternations in the thermal properties of the blends. Increase in the PEG content increased the elongation at break ratio i.e enhanced the required plasticity of PHB. Rate of microbial facilitated degradation of the blends was greater with increasing PEG concentrations. Conclusion: Blending with PEG increased the crucial polymeric properties of cyanobacterial PHB.


2021 ◽  
Vol 15 (1) ◽  
Author(s):  
Charity Wiafe Akenten ◽  
Kennedy Gyau Boahen ◽  
Kwadwo Sarfo Marfo ◽  
Nimako Sarpong ◽  
Denise Dekker ◽  
...  

Abstract Background The increasing incidence of multi-antibiotic-resistant bacterial infections, coupled with the risk of co-infections in malaria-endemic regions, complicates accurate diagnosis and prolongs hospitalization, thereby increasing the total cost of illness. Further, there are challenges in making the correct choice of antibiotic treatment and duration, precipitated by a lack of access to microbial culture facilities in many hospitals in Ghana. The aim of this case report is to highlight the need for blood cultures or alternative rapid tests to be performed routinely in malaria patients, to diagnose co-infections with bacteria, especially when symptoms persist after antimalarial treatment. Case presentation A 6-month old black female child presented to the Agogo Presbyterian Hospital with fever, diarrhea, and a 3-day history of cough. A rapid diagnostic test for malaria and Malaria microscopy was positive for P. falciparum with a parasitemia of 224 parasites/μl. The patient was treated with Intravenous Artesunate, parental antibiotics (cefuroxime and gentamicin) and oral dispersible zinc tablets in addition to intravenous fluids. Blood culture yielded Acinetobacter baumanii, which was resistant to all of the third-generation antibiotics included in the susceptibility test conducted, but sensitive to ciprofloxacin and gentamicin. After augmenting treatment with intravenous ciprofloxacin, all symptoms resolved. Conclusion Even though this study cannot confirm whether the bacterial infection was nosocomial or otherwise, the case highlights the necessity to test malaria patients for possible co-infections, especially when fever persists after parasites have been cleared from the bloodstream. Bacterial blood cultures and antimicrobial susceptibility testing should be routinely performed to guide treatment options for febril illnesses in Ghana in order to reduce inappropriate use of broad-spectrum antibiotics and limit the development of antimicrobial resistance.


1969 ◽  
Vol 58 (3) ◽  
pp. 423-425 ◽  
Author(s):  
A. R. GRIVELL ◽  
J. F. JACKSON
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document