Prediction of plastic deformation of fiber-reinforced copper matrix composites

2002 ◽  
Vol 307-311 ◽  
pp. 74-78 ◽  
Author(s):  
J.H. You ◽  
H. Bolt
2011 ◽  
Vol 474-476 ◽  
pp. 1605-1610 ◽  
Author(s):  
Lian Wei Yang ◽  
Yun Dong ◽  
Rui Jie Wang

The mechanical properties and wear behavior of short carbon fiber reinforced copper matrix composites was studied. In order to avoid any interfacial pronlems in the carbon fibre reinforced composites, the carbon fibers were coated with copper. The fibers were coated by electroless coating method and then characterized. Composites containing different amounts of carbon fibers were prepared by hot pressing technique. The results show that Carbon fiber/Cu–Ni–Fe composites showed higher hardness, higher wear resistance and bending strength than the common copper alloy when carbon fibers content is less than 15 vol.%. The predominant wear mechanisms were identified as adhesive wear in the alloy and adhesive wear accompanied with oxidative wear in the 12 vol.% carbon fiber/Cu–Ni–Fe composites.


2007 ◽  
Vol 459 (1-2) ◽  
pp. 244-250 ◽  
Author(s):  
X. Luo ◽  
Y.Q. Yang ◽  
Y.C. Liu ◽  
Z.J. Ma ◽  
M.N. Yuan ◽  
...  

2019 ◽  
Vol 2019 ◽  
pp. 1-8
Author(s):  
Chong Su ◽  
Chao Wang ◽  
Xiaoshuai Sun ◽  
Xinghua Sang

The processing mechanism of copper matrix composites is very complex, for the particle phase and lubricating phase are randomly distributed in the copper matrix phase, and the characteristics of the three phases are completely different. Aiming at understanding the chip formation and the influence of each phase of the material on the workpiece surface morphology, a single abrasive grain cutting experiment is carried out. Experiment results show that the cutting force increases with the increase in the cutting depth, but the increase amplitude is smaller. Extrusion of the abrasive particles causes plastic deformation of the copper matrix phase and brittle fracture of the particle phase and graphite phase. It results in the defects on the groove surface, such as pits, collapses and cracks, and holes. The brittle fracture of the graphite phase and the breaking and falling off of the particle phase block the plastic deformation of the copper alloy, which makes the copper alloy not forming ductile chips. The chip is mainly powdery. It shows that the brittle fracture is the main removal form of the brake pad material. The copper matrix phase on the surface of the groove produces obvious plastic deformation. The plastic deformation at the bottom is larger and has a certain degree of fibrosis appearing.


2000 ◽  
Vol 39 (Part 2, No. 2A) ◽  
pp. L119-L121 ◽  
Author(s):  
Koichi Miyake ◽  
Noriko Hanzawa ◽  
Ryuji Ninomiya ◽  
Hidefusa Takahara ◽  
Sigeru Kobayashi ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document